PubMed · 13539552
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
J K McDONALD, W E BARRON. 1958. Bromide intoxication.. https://pubmed.ncbi.nlm.nih.gov/13539552/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The most common method of sample preparation for Fourier transform infrared spectroscopic analysis of proteins in the solid state is compression after mixing with potassium bromide (KBr). Recently, questions have arisen as to whether proteins are conformationally altered by this process. In this study, the amide I Fourier transform infrared spectra of two model proteins, lysozyme and alpha-chymotrypsinogen, were measured before and after compression in KBr, and the effects of moisture exposure and the ratio of KBr to protein were examined. Contrary to earlier reports, compaction of the KBr/protein mixtures did not foster aggregation, and only minor apparent structural alterations were observed.
Triclosan (TCS) is an anti-microbial agent used in down-the-drain consumer products. Following sewage treatment some of the triclosan will enter receiving waters. This study was designed to determine the die-away rate of triclosan released into a river as part of the sewage treatment plant effluent matrix. The study was conducted in Cibolo Creek, a moderate sized stream (discharge approximately 0.1 m(3)s(-1)) located in South Central Texas. Triclosan was analyzed from samples collected upstream of the sewage treatment plant, the sewage treatment plant effluent, and the river downstream from the effluent discharge. The first-order loss rate of parent triclosan from the water column was calculated from measured data (0.06 h(-1)) and this rate corresponded to a 76% reduction in triclosan over an 8 km river reach below the discharge. Mathematical modeling indicated that sorption and settling accounted for approximately 19% of total triclosan loss over 8 km. When removing sorption and settling, the remaining amount of triclosan had an estimated first-order loss rate of 0.25 h(-1). This loss rate was presumably due to other processes such as biodegradation and photolysis. These data show that loss of parent triclosan from the water column is rapid. Additional data are needed to fully document loss mechanisms.
In this study, the photoelectrocatalytic behavior of bromide and generation of bromine using TiO2 was investigated in the separate anode and cathode reaction chambers. Our results show that the generation of bromine begins around a flatband potential of -0.34 V vs. standard calomel electrode (SCE) at pH 3.0 under UV illumination and increases with an increase in positive potential, finally reaching a steady-state concentration at 1.0 V vs. SCE. Maximum bromine formation occurs over the range of pH 4-6, decreasing sharply at conditions where the pH>7.