PubMed · 13981192
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
N P THOMPSON, J A PATTERSON. Solid salt bridge contact electrodes.. https://pubmed.ncbi.nlm.nih.gov/13981192/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Numerous bacterial genera are known to respire anaerobically using macroscopic electrodes as electron acceptors. Typically, inexpensive graphite electrodes, which are readily colonized, are used to monitor electrogenic bacterial metabolism for microbial fuel cell and bioelectronics studies. We compare current production by electrogenic bacteria on gold electrodes coated with various alkanethiol self-assembled monolayers to current production on glassy carbon electrodes. Current production is correlated to chain length and headgroup of the monolayer molecules as expected. Relative to graphite, the coated gold electrodes achieve more reproducible experimental conditions and certain headgroups enhance electronic coupling to the bacteria.
A novel sample injection method for chip CE was presented. This injection method uses hydrostatic pressure, generated by emptying the sample waste reservoir, for sample loading and electrokinetic force for dispensing. The injection was performed on a double-cross microchip. One cross, created by the sample and separation channels, is used for formation of a sample plug. Another cross, formed by the sample and controlling channels, is used for plug control. By varying the electric field in the controlling channel, the sample plug volume can be linearly adjusted. Hydrostatic pressure takes advantage of its ease of generation on a microfluidic chip, without any electrode or external pressure pump, thus allowing a sample injection with a minimum number of electrodes. The potential of this injection method was demonstrated by a four-separation-channel chip CE system. In this system, parallel sample separation can be achieved with only two electrodes, which is otherwise impossible with conventional injection methods. Hydrostatic pressure maintains the sample composition during the sample loading, allowing the injection to be free of injection bias.
Described is the fabrication of self-aligned highly ordered TiO(2) nanotube arrays by potentiostatic anodization of Ti foil having lengths up to 134 mum, representing well over an order of magnitude increase in length thus far reported. We have achieved the very long nanotube arrays in fluoride ion containing baths in combination with a variety of nonaqueous organic polar electrolytes including dimethyl sulfoxide, formamide, ethylene glycol, and N-methylformamide. Depending on the anodization voltage, pore diameters of the resulting nanotube arrays range from 20 to 150 nm. Our longest nanotube arrays yield a roughness factor of 4750 and length-to-width (outer diameter) aspect ratio of approximately 835. The as-prepared nanotubes are amorphous but crystallize with annealing at elevated temperatures. In initial measurements, 45 mum long nanotube-array samples, 550 degrees C annealed, under UV illumination show a remarkable water photoelectrolysis photoconversion efficiency of 16.25%.