PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 1398825

Prosthesis fabrication using electrical discharge machining.

N B Van Roekel
View original source ↗Export metadata ↓

Abstract

Fixed-removable implant prostheses provide solutions for some of the problems associated with implant dentistry, especially in the maxilla. The technique for using electrical discharge machining to create a precise passive fit between the substructure bar and the removable suprastructure is presented. The advantages, disadvantages, and complications associated with this type of prosthesis are discussed.

Explore related subjects

Dental Casting TechniqueDental ImplantsDental PolishingDenture DesignDenture RetentionDenture, OverlayDenture, Partial, FixedDenture, Partial, RemovableElectrolysisHumansJournal Article

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

N B Van Roekel. 1992. Prosthesis fabrication using electrical discharge machining.. https://pubmed.ncbi.nlm.nih.gov/1398825/

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2006

Fabrication of custom clips for bar-and-clip attachments for implant-supported overdentures.

Bar-and-clip attachments for dental implants are a common and versatile device for improving the retention and stability of a removable prosthesis. Manufactured clips may be unsubstantial and may not always fit or provide the desired amount of retention for the bar. The purpose of this article is to describe a technique for custom fabrication of clip attachments. The wax pattern of the clips is fabricated and then cast in dental gold alloy. The gold clips are then cut to an appropriate size that will allow for a variety of clinical applications.

Dental Casting Technique↗
PubMed2006

[Effects of laser welding on bond of porcelain fused cast pure titanium].

OBJECTIVE: To investigate the influence of the laser welding on bond of porcelain fused to cast pure titanium. METHODS: Twenty cast titanium plates were divided into two groups: laser welded group and control group. The low-fusing porcelain was fused to the laser welded cast pure titanium plates at fusion zone. The bond strength of the porcelain to laser welded cast pure titanium was measured by the three-point bending test. The interface of titanium and porcelain was investigated by scanning electron microscopy (SEM) and energy depressive X-ray detector (EDX). The non-welded titanium plates were used as comparison. RESULTS: No significant difference of the bond strength was found between laser-welded samples [(46.85 +/- 0.76) MPa] and the controls [(41.71 +/- 0.55) MPa] (P > 0.05). The SEM displayed the interface presented similar irregularities with a predominance. The titanium diffused to low-fusing porcelain, while silicon and aluminum diffused to titanium basement. CONCLUSIONS: Laser welding does not affect low-fusing porcelain fused to pure titanium.

Dental Casting Technique↗