PubMed · 14281754
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
L ELLENBOGEN, D R HIGHLEY. 1963. INTRINSIC FACTOR.. https://doi.org/10.1016/s0083-6729(08)60237-x
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Considering the importance of developing selective COX-2 inhibitors, the present paper explores selectivity requirements for COX-2 versus COX-1 binding of 3,4-diaryloxazolones using electrotopological state (E-state) index. The study also shows the utility of E-state index in developing statistically acceptable model having direct physicochemical significance: electron density distribution of different atoms of the oxazolone ring and attached two phenyl rings are important for the selective binding with COX-2 over COX-1. Moreover, the use of indicator variable shows that presence of ortho R(1) substituent (except fluoro) on the N(3)-phenyl ring decreases COX-2 selectivity. Further, an amino substituent at R(2) position (i.e., sulfonamide compound) is favorable for increasing COX-2 selectivity when the R(3) position is unsubstituted.
The hexane-extracted oil content of Moringa oleifera seeds ranged from 38.00 to 42.00%. Protein, fiber, and ash contents were found to be 26.50-32.00, 5.80-9.29, and, 5.60-7.50%, respectively. Results of physical and chemical parameters of the extracted oil were as follows: iodine value, 68.00-71.80; refractive index (40 degrees C), 1.4590-1.4625; density (24 degrees C), 0.9036-0.9080 mg/mL; saponification value, 180.60-190.50; unsaponifiable matter, 0.70-1.10%; and color (1 in. cell), 0.95-1.10 R + 20.00-35.30 Y. Tocopherols (alpha, gamma, and delta) in the oil were up to 123.50-161.30, 84.07-104.00, and 41.00-56.00 mg/kg, respectively. The oil was found to contain high levels of oleic acid (up to 78.59%) followed by palmitic, stearic, behenic, and arachidic acid up to levels of 7.00, 7.50, 5.99, and 4.21%, respectively. The induction period (Rancimat, 20 L/h, 120 degrees C) of the crude oil was 9.99 h and reduced to 8.63 h after degumming. Specific extinctions at 232 and 270 nm were 1.70 and 0.31, respectively. Many parameters of M. oleifera oil indigenous to Pakistan were comparable to those of typical Moringa seed oils reported in the literature. The results of the present analytical study were also compared with those of different vegetable oils.
Oil-in-water emulsions containing droplets stabilized by beta-lactoglobulin (beta-Lg)-pectin membranes were produced using a two-stage process. A primary emulsion containing small droplets (d(32) approximately 0.3 microm) was prepared by homogenizing 10 wt % corn oil with 90 wt % aqueous solution (1 wt % beta-Lg, 5 mM imidazole/acetate buffer, pH 3.0) using a high-pressure valve homogenizer. The primary emulsion was then diluted with pectin solutions to produce secondary emulsions with a range of pectin concentrations (5 wt % corn oil, 0.45 wt % beta-Lg, 5 mM imidazole/acetate buffer, 0-0.22 wt % pectin, pH 3.0). The electrical charge on the droplets in the secondary emulsions decreased from +33 +/- 3 to -19 +/- 1 mV as the pectin concentration was increased from 0 to 0.22 wt %, which indicated that pectin adsorbed to the droplet surfaces. The mean particle diameter of the secondary emulsions was small (d(32) < 1 microm) at relatively low pectin concentrations (<0.04 wt %), but increased dramatically at higher pectin concentrations (e.g., d(32) approximately 13 microm at 0.1 wt % pectin), which was attributed to charge neutralization and bridging flocculation effects. Emulsions with relatively small mean particle diameters (d(32) approximately 1.2 microm at 0.1 wt % pectin) could be produced by disrupting flocs formed in secondary emulsions containing highly negatively charged droplets, for example, by sonication, blending, or homogenization. The particles in these emulsions probably consisted of small flocs containing a number of protein-coated droplets bound together by pectin molecules. These emulsions had good stability to further particle aggregation up to relatively high ionic strengths (< or =500 mM NaCl) and low pH (pH 3). The interfacial engineering technology used in this study could lead to the creation of food emulsions with improved physicochemical properties or stability.