PubMed · 14391899
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
H FOREMAN. 1955. Chelating agents.. https://pubmed.ncbi.nlm.nih.gov/14391899/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The effects of hydraulic retention time (HRT) and sulfide toxicity on ethanol and acetate utilization were studied in a sulfate-reducing fluidized-bed reactor (FBR) treating acidic metal-containing wastewater. The effects of HRT were determined with continuous flow FBR experiments. The percentage of ethanol oxidation was 99.9% even at a HRT of 6.5 h (loading of 2.6 g ethanol L(-1) d(-1)), while acetate accumulated in the FBR with HRTs below 12 h (loading of 1.4 g ethanol L(-1) d(-1)). Partial acetate utilization was accompanied by decreased concentrations of dissolved sulfide (DS) and alkalinity in the effluent, and eventually resulted in process failure when HRT was decreased to 6.1 h (loading of 2.7 g ethanol L(-1) d(-1)). Zinc and iron precipitation rates increased to over 600 mg L(-1) d(-1) and 300 mg L(-1) d(-1), respectively, with decreasing HRT. At HRT of 6.5 h, percent metal precipitation was over 99.9%, and effluent metal concentrations remained below 0.08 mg L(-1). Under these conditions, the alkalinity produced by substrate utilization increased the wastewater pH from 3 to 7.9-8.0. The percentage of electron flow from ethanol to sulfate reduction averaged 76 +/- 10% and was not affected by the HRT. The lowest HRT did not result in significant biomass washout from the FBR. The effect of sulfide toxicity on the sulfate-reducing culture was studied with batch kinetic experiments in the FBR. Noncompetitive inhibition model described well the sulfide inhibition of the sulfate-reducing culture. (DS) inhibition constants (K(i)) for ethanol and acetate oxidation were 248 mg S L(-1) and 356 mg S L(-1), respectively, and the corresponding K(i) values for H(2)S were 84 mg S L(-1) and 124 mg S L(-1). In conclusion, ethanol oxidation was more inhibited by sulfide toxicity than the acetate oxidation.
Trichloroacetate (TCA) and dichloroacetate (DCA) are hepatocarcinogenic metabolites of the environmental pollutant trichloroethylene (TCE) and are common water contaminants. Induction of peroxisome proliferation via activation of the peroxisome proliferator-activated receptor alpha (PPARalpha) has been proposed as a mechanism for their hepatocarcinogenic action. However, it is unclear whether these compounds are direct ligands of PPARalpha or whether activation occurs by a ligand-independent process. The present studies were undertaken to determine whether a primary rat hepatocyte model system could be used to examine structure-activity relationships of haloacetates for the induction of peroxisomal palmitoyl-CoA oxidation. The haloacetates tested differed in both type (iodo, bromo, chloro and fluoro) and extent (mono, di and tri) substitution. Significant differences were observed in both potency and efficacy. Potency varied over about two orders of magnitude, in the order of mono > di = tri. Within the monohalo-substituted series, the order of potency was iodo > bromo > chloro, with the fluoro analog being essentially inactive. The monoiodo- and monobromo-derivatives showed significant induction at 50 and 100 microM, respectively, but cytotoxicity precluded obtaining full concentration-response curves. The dihalo- and trihalo-acetates had generally similar potency, and, with the exception of the diflouro- and dibromoacetates, showed a maximal induction of two- to three-fold. Difluoroacetate and dibromoacetate induced palmitoyl-CoA oxidation by nine- and six-fold, respectively, approaching the effectiveness of Wy-14,643 (50 microM) in this system. Of interest, the slopes of the concentration-dependence lines of the difluoro- and dibromo-acetates were markedly dissimilar from the other di- and tri-haloacetates, suggesting either a marked difference in the way they activate the PPARalpha receptor or a substantial difference in the way they are metabolized or transported by the hepatocytes.
The feasibility of biodegradability improvement induced from the structural conversion of refractory pollutants by hydrothermal reaction was investigated. Monochloroacetic acid (MCAA) was selected as a preliminary material represented for linear hydrocarbon structured refractory pollutants. Under the tested conditions, MCAA was partially destructed and then converted to biodegradable reaction products by hydrolysis, dehydration and thermal decomposition. The identified products were glycolic acid, citric acid and formic acid. Total organic carbon (TOC) reduction during the structural conversion did not exceed 24%, except the results at the reaction conditions of 350 degrees C and 17 MPa. However, Produced biodegradable organic acids were reduced by thermal decomposition with increasing reaction temperature and time. At the reaction temperature of 250 and 300 degrees C, biodegradability (BOD/COD(Cr)) was reached at 0.51 in 6.9 min and 0.52 in 7.4 min despite the presence of dissociated chlorine ions. The detachment of recalcitrant chlorine ion from MCAA and the production of biodegradable organic acids by hydrothermal reaction were directly related to the biodegradability improvement of reaction products.