PubMed · 14777733
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
H J ORAMS. 1950. Pulp capping.. https://pubmed.ncbi.nlm.nih.gov/14777733/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The purpose of this study was to measure intrapulpal temperature rise induced by two kinds of bleaching gels when the tooth was exposed to a variety of light-curing units and a diode laser in vitro. The root portions of 80 extracted intact human maxillary central incisors were sectioned with a carborundum disk approximately 2 mm below the cementoenamel junction perpendicular to the long axis of the teeth. Two bleaching agents containing heat-enhancing colorant was applied to the labial surface. Light-curing units used were a conventional halogen (40 s), a high-intensity halogen (30 s), a light-emitting diode unit (40 s), and a diode laser (15 s). The temperature rise was measured in the pulpal chamber with a J-type thermocouple wire that was connected to a data logger. Ten specimens were used for each system and bleaching-agent combination. Differences between the starting temperature and highest temperature reading were taken and the calculated temperature changes were averaged to determine the mean value in temperature rise. Temperature rise values were compared using two-way analysis of variance (ANOVA) at a preset alpha of 0.05. Temperature rise varied significantly depending on curing unit and diode laser used. The diode laser induced significantly higher temperature increases than any other curing unit (11.7 degrees C). The light-emitting diode unit produced the lowest temperature changes (6.0 degrees C); however, there were no statistically significant differences among the curing units and there were no statistically significant differences between bleaching agents. Light activation of bleaching materials with diode laser caused higher temperature changes as compared to other curing units and the temperature rise detected was viewed as critical for pulpal health.
Six iatrogenic dental borings were identified in four individuals of a Native American skeletal collection from an 18th and early 19th century Middle Columbia River burial site. The borings, all in maxillary first molars with severe dental attrition and secondary dentin, demonstrate striated walls and associated periapical alveolar lesions. An ethnographic review of the subsistence pattern during the burial period indicates a diet that is consistent in dental attrition with other riverine fisher-hunter-gathers. Histological changes of dental pulp tissue during the process of attrition may result in dental necrosis. Access into the pulp chamber is a technique used to drain necrotic fluid. A common Euro-American therapeutic dental practice of the 18th and 19th centuries for diseases of the pulp was dental extraction. Multiple dental borings indicate that the practice of molar drilling into the pulp chamber was an effective and independent technique used by the Wishram and Wasco people.
Root canal morphology is a critically important part of conventional and surgical endodontics (root canal therapy). Many in vitro studies have recorded the scales and average sizes of root canals, but there have been few clinical attempts to determine the working width. In the absence of a study that defines what the original width and optimally prepared horizontal dimensions of canals are, clinicians are making treatment decision without any support of scientific evidence. This article provides definitions and perspectives on the current concepts and techniques to handle working width-the horizontal dimension of the root canal system-and its clinical implications.