PubMed · 14785903
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
K KLEES, L KLEES. 1950. [Vasodentin].. https://pubmed.ncbi.nlm.nih.gov/14785903/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Dentine is a porous hydrated composite structure that forms the major bulk of the human tooth. The aim of this study was to investigate the role of free water on the in-plane, mechanical strain response in dentine structure. A digital moire interferometry was used for this purpose. It was observed from this experiment that structural dentine demonstrated distinct strain gradients in the axial (perpendicular to the dentinal tubules) and lateral (parallel to the dentinal tubules) directions. The hydrated dentine displayed significant increase in strain with stress in the direction perpendicular to the dentinal tubules, and this response was characteristic of a tough material. On the contrary, the dehydrated dentine, which was dehydrated at 24 degrees C, 55% relative humidity for 72 h showed a strain response characteristic of a brittle material. The strains formed in the direction parallel to the dentinal tubules for hydrated dentine were consistent and did not vary much with increase in applied loads. Upon dehydration, the outer dentine experienced higher strains, and the difference between the outer and inner dentine became more conspicuous with increase in loads. This experiment highlights hydration-induced, distinct in-plane strain gradients in the directions perpendicular and parallel to the dentinal tubules in the dentine structure.
The finite element method (FEM) is applied for studying the hardness (H) and yield strength (Y) of dentin subjected to a nano-indentation process. The nano-indentation experiments were simulated with the ABAQUS finite element software package. This test, performed with a spherical indenter, was simulated by axisymmetric finite element analysis. The load versus displacement was calculated during loading-unloading sequence for different elastic modulus (E) and yield strength. Hardness and maximum principal compressive and tensile stresses were plotted for different elastic modulus depending on yield strength. The dentin was assumed to be isotropic, homogenous and elasto-plastic. The theoretical results outlined in this study were compared with the experimental works reported in the literature and then hardness and yield strength of dentin was estimated.
A novel oligomer was synthesized in different molecular masses and used as a primer in dentin bonding. The hypothesis was that an intermediate molecular mass would optimize the conflicting needs for diffusion into etched dentin (low M(w)) and high mechanical properties (high M(w)). The initial oligomer synthesized was tert butylmethacrylate-co-maleic anhydride, which was further reacted to add hyrdoxyethyl methacrylate (HEMA) across the anhydride. The oligomer was synthesized in a series of molecular masses from approximately 800-6000 amu. The oligomer with an average M(w) of approximately 1000 amu provided the highest bond strength (16 MPa), with both lower and higher molar mass oligomers producing lower bond strengths. A polynomial model was fitted to the data with an R(2) = 0.606, while a linear model only had an R(2) = 0.534. This implies that the graph of molar mass to bond strength has a maximum in the range of molar masses examined, and that an optimum molar mass can be found between 800 and 6000 amu.