PubMed · 14808695
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
E PERSICO, C GEOFFRION. 1950. Beta-ray spectroscopes.. https://doi.org/10.1063/1.1745497
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Alkali halides crystals have been the subject of intense research for an understanding of their radiation-induced defects and luminescence properties. They exhibit noteworthy thermoluminescence (TL) properties when exposed to ionising radiation. Currently, these materials are grown employing expensive and rather complicated techniques. In this work, the results on the TL properties of new alkali halides phosphors fabricated by a simple and inexpensive procedure are presented. The samples were made by mixing KCl, KBr and EuCl3 salts, and compressing them at a pressure of 3.2 x 10(7) Pa during 3 min, followed by sintering at 700 degrees C during 24 h under air atmosphere. The dosimetric response of the samples showed an increase with radiation dose in the 1.5-20.0 Gy dose range for beta and gamma radiation. The TL glow curves in sintered samples presented significant differences in their peak structures compared with monocrystalline samples, indicating that the nature of the trapping states and the recombination mechanisms may be different.
Two types of thin LiF:Mg,Cu,P detectors, GR-200F and MCP-Ns, have been characterised for use in the design of an extremity dosemeter for mixed beta-photon radiation fields. Both detectors consist of an extremely thin layer of sensitive material with effective thicknesses of 5 and 8 mg cm(-2), respectively, held in a 5 mg cm(-2) PVC ring holder. Dosimetric performance was analysed according to the ISO 12794 standard and compared with 240 mg cm(-2) TLD-100 measurements. In particular, the energy response was obtained for ISO narrow X-ray spectra, (137)Cs, (60)Co, (204)Tl and (90)Sr/(90)Y. From these measurements a mean calibration factor was calculated to estimate H(p)(0.07). Subsequently, the performance of the dosemeters was checked for a set of 10 different mixed photon and beta-photon fields. The study shows that the proposed dosemeters can estimate H(p)(0.07) in a wide range of mixed beta-photon fields with a maximum deviation from the given dose of 30% and an overall uncertainty of the order of 25% (k = 1). However, the results also highlight a large variability among the different thin detectors and, thus, the standard TLD-100 material is recommended whenever the workplace does not include low-energy beta radiation.
Three different methods for characterising the dose deposition profile of a (90)Sr/(90)Y radioactive source are described: GAFChromic film dosimetry, Thermoluminescence (TL) and Optically Stimulated Luminescence (OSL). For the film measurements, GAFChromic film samples were stacked at different depths between polyethylene terephthalate (PET) foils. For TL, the thickness of a TLD-500 dosemeter was gradually reduced by polishing and the TL from chips of different thickness was used in conjunction with a mathematical model based on the exponential attenuation of dose inside the crystal to determine the decay constant for the dose-depth profile. Finally, an OSL reader with confocal stimulation / detection capabilities was used to map the two-dimensional dose distribution in TLD-500 dosemeters as a function of depth. The shapes of the dose deposition profiles obtained from all the investigated methods are in good agreement.