PubMed · 14818986
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
R ENGELBERG, M McNALLY. 1951. A simple inexpensive staining device.. https://doi.org/10.1093/ajcp%2F21.3_ts.296
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This study is focused on the optimisation of the electrochemical decolourisation of textile effluents containing reactive dyes with the aim of making feasible-technically and economically-this method at industrial scale. Coloured waters were treated in continuous at low current density, to reduce the electrical consumption. Ti/PtO(x) electrodes were used to oxidize simulated dyebaths prepared with an azo/dichlorotriazine reactive dye (C.I. Reactive Orange 4). The decolourisation yield was dependent on the dyeing electrolyte (NaCl or Na(2)SO(4)). Dyeing effluents which contained from 0.5 to 20 gl(-1) of NaCl reached a high decolourisation yield, depending on the current density, immediately after the electrochemical process. These results were improved when the effluents were stored for several hours under solar light. After the electrochemical treatment the effluents were stored in a tank and exposed under different lighting conditions: UV light, solar light and darkness. The evolution of the decolourisation versus the time of storage was reported and kinetic constants were calculated. The time of storage was significantly reduced by the application of UV light. A dye mineralization study was also carried out on a concentrated dyebath. A TOC removal of 81% was obtained when high current density was applied for a prolonged treatment with recirculation. This treatment required a high electrical consumption.
A first attempt to measure the molecular compositions of pigments in paintings using static SIMS was made. An investigation of pellets of pure pigments such as auripigment and verdigris allowed the detection of numerous high m/z ions useful for molecular identification. Analysis of pigments in embedded paint fragments, on the other hand, only yielded elemental information because of charge build-up and contamination problems. Optimization of the form in which the sample is presented to the analysis method is obviously the price to pay for the ultimate sensitivity and information depth of S-SIMS.
To measure electron diffusion coefficients (D) and electron lifetimes (tau) of dye-sensitized solar cells (DSC), we introduced stepped light-induced transient measurements of photocurrent and voltage (SLIM-PCV), which can simplify the optical setup and reduce measurement time in comparison to conventional time-of-flight and frequency-modulated measurements. The method was applied to investigate the influence of the viscosity of a thermally stable high-boiling-point solvent on the energy conversion efficiency of DSCs. By systematic study of the influence of the viscosity, the species of cations as the counter charge of I(-)/I(3)(-), and the concentrations of electrolytes, we concluded that a lower dye cation reduction rate due to slower iodine diffusion is a limiting factor for a highly viscous electrolyte system. On the other hand, comparable values of D and increased values of tau were observed in a highly viscous electrolyte. By employing 0.5 M TBAI and 0.05 M I(2) in propylene carbonate, the efficiency of the DSC became comparable to that of a DSC using conventional electrolytes consisting of LiI, imidazolium iodide, and 4-tert-butylpyridine in methoxyacetonitrile. The simultaneous evaluation of D and tau through the appropriately simple measurement realizes fast optimization of the efficient and reliable DSC composed of thermally stable but often viscous electrolytes.