PubMed · 14891136
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
S KARLSTROM. [The pontostructor; method for constructing fixed bridges].. https://pubmed.ncbi.nlm.nih.gov/14891136/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This paper reports a case of tooth surface loss as a result of the eating disorder pica. Background to the condition is discussed and the clinical findings and treatment of the patient outlined. The case illustrates a rare cause of wear which should be considered when patients present with an unusual pattern of tooth surface loss.
OBJECTIVES: The purpose of this study was to formulate explicitly the equation to relate the biaxial strength of multilayered dental ceramics to the fracture load for multilayered discs subjected to biaxial flexure tests. METHODS: Analytical modeling showed that the solutions for multilayered discs subjected to biaxial flexure tests could be obtained from the existing solutions for monolayered systems by replacing the neutral surface position and the flexural rigidity of monolayers with those of multilayers. Finite element analyses were performed on porcelain/zirconia bilayered discs subjected to piston-on-ring and ring-on-ring tests to verify the analytical results. RESULTS: Good agreement was obtained between (i) present analytical results and Roark's formulas for stresses at the top and the bottom surfaces of bimetallic discs subjected to bending, and (ii) present analytical and finite element results for porcelain/zirconia bilayered discs subjected to piston-on-ring and ring-on-ring tests. SIGNIFICANCE: The present closed-form solutions provide a basis for evaluating the biaxial strength of multilayered dental ceramics. Depending upon the strength of the individual layers and the stress distribution through the thickness of the multilayer during tests, cracking can initiate from any layer under tension.
OBJECTIVES: The purpose of this study was to evaluate the fit of metal ceramic crowns cast in Au-1.6 wt% Ti alloy and investigate the effect of abutment finish line curvature on the fit of crowns. METHODS: Three types of finish line curvature abutments were prepared (1, 3 and 5mm-curvature). For each type of abutment, five metal ceramic crowns of the facial veneered type were fabricated, which were cast in Au-1.6 wt% Ti alloy. Used as controls, another fifteen specimens were made from a commercially available gold alloy. The fit was measured in the as-cast and after porcelain application. RESULTS: In the as-cast specimens, the greater the finish line curvature was, the larger the gaps exhibited at the mesial and distal margins of copings, compared with labial and lingual margins. The distal margin of copings for 5mm-curvature abutments showed the largest gap (35 (7) microm). After porcelain application, the greater was the finish line curvature, the larger the labial marginal gap became (mean 44, 34, 25 microm, respectively, for 5, 3, 1mm-curvature). However, there was no significant difference on marginal gaps between specimens of Au-1.6 wt% Ti alloy and control gold alloy. SIGNIFICANCE: This study indicated that the metal ceramic crowns cast in Au-1.6 wt% Ti alloy had equivalent accuracy to those that cast in control gold alloy, and the abutment finish line curvature had a significant effect on the marginal fit of metal ceramic crowns.