PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 15787367

Linker-based bio-compatible microemulsions.

Edgar J Acosta·Thu Nguyen·Anuradee Witthayapanyanon·Jeffrey H Harwell·David A Sabatini
View original source ↗Export metadata ↓

Abstract

In this work we have studied the formulation of biocompatible microemulsions using lecithin as the main surfactant and bio-compatible linker molecules (hexyl polyglucoside asthe hydrophilic linker and sorbitan monoleate as the lipophilic linker). These bio-compatible systems are discussed as potential substitutes for chlorinated solvents in dry-cleaning applications and as solvent delivery systems for pharmaceutical applications. Formulation parameters and conditions were evaluated using isopropyl myristate (IPM) as the model oil. It was found that the proposed linker-based formulations were able to form alcohol-free microemulsions while achieving higher solubilization capacity than similar systems reported in the literature. In addition, these lecithin/linker formulations were able to form microemulsions with a wide range of oils, from polar chlorinated hydrocarbons to hydrophobic oils such as squalene. These microemulsions were achieved under isotonic conditions (0.9% NaCl) by only varying the relative proportions of the linkers. The "solvency" power of these bio-compatible formulations was tested for the removal of hexadecane (used as model oil) from cotton fabrics and compared to the solvency power of a typical dry cleaning solvent tetrachloroethylene (PCE). While PCE and the linker-based lecithin formulation removed the same amount of hexadecane at low loading ratios (less than 1% oil volume fraction), at higher loading ratios the linker-based lecithin formulation retained its oil removal capacity while the efficiency of the PCE system declined rapidly. These initial results thus demonstrate the remarkable oil solubilization capacity of these bio-compatible linker-based lecithin formulations and illustrate their potential as environmentally friendly replacements for organic solvents.

Explore related subjects

Biocompatible MaterialsEmulsionsEnvironmental PollutionNanostructuresPharmaceutical PreparationsPhosphatidylcholinesSolventsSurface-Active AgentsJournal ArticleResearch Support, Non-U.S. Gov'tResearch Support, U.S. Gov't, Non-P.H.S.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Edgar J Acosta, Thu Nguyen, Anuradee Witthayapanyanon, Jeffrey H Harwell, David A Sabatini. 2005-03-01. Linker-based bio-compatible microemulsions.. https://doi.org/10.1021/es049010g

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2006

Micellization of casein-graft-dextran copolymer prepared through Maillard reaction.

Casein is almost insoluble at around pH 4.6, which is its isoelectric point (pI). Grafting copolymer, casein-g-dextran, was prepared through the Amadori rearrangement of the Maillard reaction. The copolymer has a reversible pH sensitive property: micellization at the pI of casein forming a casein core and dextran shell structure and dissociation when pH differs from the pI. The micelles produced at pH 4.6 have a spherical shape and their size is dependent on the Maillard reaction: reaction time, molar ratio of casein to dextran, and molecular weight of dextran used. Typically, the hydrodynamic diameter of the micelles is about 100 nm and the critical micelle concentration is about 10 mg/L. The micelles are very stable in aqueous solution and can be stored as lyophiled powder. The micelles are able to encapsulate hydrophobic compounds such as pyrene.

Biocompatible Materials↗
PubMed2006

Surface-attached PEO in the form of activated Pluronic with immobilized factor H reduces both coagulation and complement activation in a whole-blood model.

In the present work we have bound Pluronic, a class of triblock copolymers consisting of a block of polypropylene oxide (PPO) surrounded on each side by polyethylene oxide (PEO) blocks, to polystyrene surfaces and investigated the thrombogenicity and complement activation of this construct upon exposure to whole blood. The surface was highly inert towards coagulation, unfortunately at the expense of increased complement activation. We, therefore, as an alternative approach, used End-Group Activated Pluronic to conjugate factor H, a regulator of complement activation (RCA), to the surface. The bound factor H did not detach from the surface upon incubation with human serum. Furthermore, factor H bound in a physiological conformation could to a significant degree attenuate complement activation at the Pluronic surface. Thus, we have created a hybrid surface in which the coagulation-inert properties of the original Pluronic are supplemented with a specific complement-inhibitory effect. Medical device technology includes numerous potential applications for crosslinkers that are capable of specifically binding biomolecules to surfaces with retained activity. These applications include coupling of functional biomolecules to biomedical devices such as stents and grafts. The biomolecule may be an RCA, antibody, or other beneficial ligand.

Biocompatible Materials↗
PubMed2006

Synthesis and characterization of novel polyanhydrides with tailored erosion mechanisms.

We have designed a new synthesis route to create polyanhydrides based on monomers that contain hydrophilic entities within highly hydrophobic backbones. The method results in polyanhydrides that can be easily processed into drug-containing tablets. The synthesis, characterization, and erosion studies of polyanhydride copolymers based on 1,6-bis(p-carboxyphenoxy)hexane (CPH), which is highly hydrophobic, and 1,8-bis(p-carboxyphenoxy)-3,6-dioxaoctane (CPTEG), which has hydrophilic oligomeric ethylene glycol segments in the monomer unit, was performed using a combination of molecular spectroscopy, thermal analysis, gravimetry, and scanning electron microscopy. The studies demonstrate that by increasing the CPH content in the CPTEG:CPH copolymers, the erosion of the system can be tailored from bulk-eroding to surface-eroding mechanism. These systems have promise as protein carriers.

Biocompatible Materials↗