PubMed · 15951660
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Steven N Goodman. 2005. The methodologic ozone effect.. https://doi.org/10.1097/01.ede.0000165813.07327.35
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Chloroform (CHCl3) is a short-lived ozone-depleting substance not currently regulated under the Montreal Protocol. Due to the unique meteorological conditions in East Asia, CHCl3 emitted in this region has a greater potential to reach the stratosphere and contribute to ozone depletion. As an essential component of national CHCl3 emissions, southeastern China has attracted increasing attention. However, long-term observational data in this region remain relatively scarce, with no updates since 2020. In this study, we continuously measured atmospheric CHCl3 concentrations at a remote monitoring station in southeastern China from 1 June 2023 to 31 May 2025. Frequent concentration enhancements were observed during the monitoring period, with mixing ratios ranging from 9.3 to 134.1 ppt and an average value of 36.8 ± 19.7 ppt. Back-trajectory analysis indicated that air masses associated with elevated CHCl3 levels primarily originated from coastal industrial provinces in eastern China. Using the Potential Source Contribution Function and Concentration Weighted Trajectory methods, we identified the Yangtze River Delta (Jiangsu, Anhui, and Zhejiang Provinces) and Jiangxi Province as dominant source regions. Emissions of CHCl3 in southeastern China were estimated using the Tracer Ratio Method to be approximately 30.1 ± 5.3 Gg/yr from 2023-06-01 to 2025-05-31, indicating overall stability relative to earlier estimates and no apparent upward trend. These findings provide updated insights into the current status of CHCl3 emissions in southeastern China and highlight the need for continued monitoring and emission assessment of CHCl3 in East Asia, given its unregulated status and implications for ozone layer recovery.
The performance and microbial communities of three differently inoculated biotrickling filters removing dimethyl sulfide (DMS) were compared. The biotrickling filters were inoculated with Thiobacillus thioparus TK-m (THIO), sludge (HANDS) and sludge + T. thioparus TK-m + Hyphomicrobium VS (HANDS++), respectively. The criteria investigated were length of the start-up period, the maximum elimination capacity, and the effects of intermittent loading rates, low pH, peak loading and very low loading rate on the DMS removal efficiency. The HANDS++ reactor exhibited the best performance considering all treatments. HANDS performed almost equally well as HANDS++, except during the determination of the EC(max), while THIO was generally the least efficient. During stable DMS loading at concentrations of 20 ppmv or lower, all reactors exhibited similar and high removal efficiencies (>99%). Denaturing gradient gel electrophoresis (DGGE) analysis showed the establishment of T. thioparus in the biofilm of all reactors, but not of Hyphomicrobium VS. Quantitative monitoring of the introduced bacterial strains was performed with a newly developed real-time PCR protocol. Initially, the inoculated strains were exclusively found in the reactors in which they were added. Afterwards, however, both strains developed in the biofilm of all three reactors, although T. thioparus attained higher cell densities than Hyphomicrobium. The presence of T. thioparus in THIO was related with the DMS loading rates that were applied, in the sense that intermittent DMS loading and very low DMS loading rates (0.5 ppmv) induced a decrease in gene copy numbers. Real-time PCR and DGGE both gave consistent results regarding the presence of Hyphomicrobium VS and Thiobacillus thioparus TK-m in the reactors. Only real-time PCR could be used to detect bacteria comprising of less than 1.4% of the total bacterial community ( approximately 10(5) copies ring(-1)).
Over the past decade much effort has been made to develop new carrier materials, more performant biocatalysts, and new types of bioreactors for waste gas treatment. In biofilters fungal biocatalysts are more resistant to acid and dry conditions and take up hydrophobic compounds from the gas phase more easily than wet bacterial biofilms. In the present study, a biofilter packed with a mixture of perlite and Pall rings and fed alpha-pinene-polluted air was inoculated with a new fungal isolate identified as Ophiostoma species. alpha-Pinene is a volatile pollutant typically found in waste gases from wood-related industries. The temperature of waste gas streams from pulp and paper industries containing alpha-pinene is usually higher than ambient temperature. Studies were undertaken here on the effect on performance of temperature changes in the range of 15-40 degrees C. The effect of temperature on biodegradation kinetics in continuous reactors was elucidated through equations derived from the Arrhenius formula. Moreover, the effects of the relative humidity (RH) of the inlet gas phase, transient loads (shock or starvation), and the nature of the nitrogen source on alpha-pinene removal were also studied in this research. The results suggest that the fungal biofilter appears to be an effective treatment process for the removal of alpha-pinene. The optimal conditions are: temperature around 30 degrees C, RH of the inlet waste gas stream around 85%, and nitrate as nitrogen source. The fungal biofilter also showed a good potential to withstand shock loads and recovered rapidly its full performance after a 3-7 days starvation period.