PubMed Health⌕ Search

PubMed · 15963369

Acid neutralization within limestone sand reactors receiving coal mine drainage.

Abstract

Pulsed bed treatment of acid mine drainage (AMD) uses CO2 to accelerate limestone dissolution and intermittent fluidization to abrade and carry away metal hydrolysis products. Tests conducted with a prototype of 60 L/min capacity showed effective removal of H+ acidity over the range 196-584 mg/L (CaCO3) while concurrently generating surplus acid neutralization capacity. Effluent alkalinity (mg/L CaCO3) rose with increases in CO2 (DC, mg/L) according to the model Alkalinity=31.22+2.97(DC)0.5, where DC was varied from 11-726 mg/L. Altering fluidization and contraction periods from 30s/30s to 10s/50s did not influence alkalinity but did increase energy dissipation and bed expansion ratios. Field trials with three AMD sources demonstrated the process is capable of raising AMD pH above that required for hydrolysis and precipitation of Fe3+ and Al3+ but not Fe2+ and Mn2+. Numerical modeling showed CO2 requirements are reduced as AMD acidity increases and when DC is recycled from system effluent.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Barnaby J Watten, Philip L Sibrell, Michael F Schwartz. 2005. Acid neutralization within limestone sand reactors receiving coal mine drainage.. https://doi.org/10.1016/j.envpol.2005.01.026

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Comparison of the solution behaviour of a pyrite-calcite mixture in batch and unsaturated sand column.

A successful application of reaction transport algorithms to calculate the chemical evolution of natural systems requires accurate methods to compute the rates of mineral/fluid surface reactions. Regarding the transport of radio-nuclides in mining dumps the dissolution of minerals is of special importance. Using a kinetic rate law of the mineral dissolution verified for unsaturated conditions will allow a realistic modelling of the mineral weathering in the environment. Dissolution rates of minerals in an aqueous solution are determined by several characteristics. These are surface reaction rates, morphology of the mineral's surface and, in case it is the unsaturated zone, the degree of the water saturation. For this process, the quantity of the particle surfaces which are in contact with percolating water is most decisive. In order to study the differences of mineral dissolution under saturated and unsaturated conditions batch and column experiments were carried out with a pyrite-calcite mixture. The experimental results were verified by calculations. Comparing the dissolution in batch with those in the column experiment, which was performed with a water flow velocity of 0.64 cm/day and was analyzed in the region of a water saturation of 0.11, one can conclude that only a small portion of about 5% of the grain surface is chemically reactive in this unsaturated flow.

Calcium Carbonate↗

Oriented aggregation and novel phase transformation of vaterite controlled by the synergistic effect of calcium dodecyl sulfate and n-pentanol.

Calcium dodecyl sulfate (CDS) was used for the first time both as an anionic surfactant and as the source of mineral ions in the precipitation process of calcium carbonate (CaCO3). The simple reaction of the enriched Ca2+ ions at the so-called organic-inorganic interfaces with the slowly bubbled CO2 gas resulted in the metastable vaterite polymorph with various structures. The single-crystalline vaterite of the hexagonal platelets, the lens-shaped structures with hexagonal symmetry, the olive-shaped superstructures and these with a concave at each top of olives, and another metastable polymorph of aragonite were obtained, respectively, depending upon the concentration ratio between CDS and n-pentanol. The synergistic effect of CDS and n-pentanol is believed to play a crucial role in driving the oriented aggregation of metastable nanoparticles. Simultaneously, the novel phase transformation of vaterite to aragonite was observed, implying the possible formation mechanism of aragonite at room temperature and in the absence of magnesium ions.

Calcium Carbonate↗

Direction specific interactions of 1,4-dicarboxylic acid with calcite surfaces.

Interactions of succinic acid (SUC) with the {104} cleavage faces of calcite show a strong preference in crystallographic directions. In situ atomic force microscopy revealed that the morphology of etch pits on the crystal surfaces experienced a transition from the common rhombus to a hexagon upon the introduction of SUC. The pit shape further evolved from 6-sided to 7-sided and eventually to 5-sided with increasing concentrations of SUC. Analysis indicates that the morphology changes may result from SUC preferentially binding to the [42] and [010] edges of the (104) plane to selectively slow down their step speed.

Calcium Carbonate↗