PubMed Health⌕ Search

PubMed · 1617140

Phospholipid interactions in model membrane systems. I. Experiments on monolayers.

Abstract

We study the lateral headgroup interactions among phosphatidylcholine (PC) molecules and among phosphatidylethanolamine (PE) molecules in monolayers and extend our previous models. In this paper, we present an extensive set of pressure-area isotherms and surface potential experiments on monolayers of phospholipids ranging from 14 to 22 carbons in length at the n-heptane/water interface, over a wide range of temperature, salt concentration, and pH on the acid side. The pressure data presented here are a considerable extension of previous data (1) to higher surface densities, comprehensively checked for monolayer loss, and include new data on PE molecules. We explore surface densities ranging from extremely low to intermediate, near to the main phase transition, in which range the surface pressures and potentials are found to be independent of the chain length. Thus, these data bear directly on the headgroup interactions. These interactions are observed to be independent of ionic strength. PC and PE molecules differ strongly in two respects: (a) the lateral repulsion among PC molecules is much stronger than for PE, and (b) the lateral repulsion among PC molecules increases strongly with temperature whereas PE interactions are almost independent of temperature. Similarly, the surface potential for PC is found to increase with temperature whereas for PE it does not. In this and the following paper we show that these data from dilute to semidilute monolayers are consistent with a theoretical model that predicts that, independent of coverage, for PC the P-N+ dipole is oriented slightly into the oil phase because of the hydrophobicity of the methyl groups, increasingly so with temperature, whereas for PE the P-N+ dipole is directed into the water phase.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J Mingins, D Stigter, K A Dill. 1992. Phospholipid interactions in model membrane systems. I. Experiments on monolayers.. https://doi.org/10.1016/s0006-3495(92)81964-1

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Advanced oxidation processes for the treatment of olive-oil mills wastewater.

In this work, the treatment of an actual industrial waste with three advanced oxidation processes (AOP) has been studied: conductive-diamond electrooxidation (CDEO), ozonation and Fenton oxidation. The wastewater comes from olive-oil mills (OMW) and contains a COD of nearly 3000 mg dm(-3). CDEO allowed achieving the complete mineralization of the waste with high current efficiencies. Likewise, both ozonation and Fenton oxidation were able to treat the wastes, but they obtained very different results in terms of efficiency and mineralization. The accumulation of oxidation-refractory compounds as final products excludes the use of ozonation and Fenton oxidation as a sole treatment technology. This confirms that besides the hydroxyl-radical mediated oxidation, CDEO combines other important oxidation processes such as the direct electro-oxidation on the diamond surface and the oxidation mediated by other electrochemically formed compounds generated on this electrode.

Electrochemistry↗

Electrosynthesis of hydrogen peroxide via the reduction of oxygen assisted by power ultrasound.

The electrosynthesis of hydrogen peroxide using the oxygen reduction reaction has been studied in the absence and presence of power ultrasound in a non-optimized sono-electrochemical flow reactor (20 cm cathodic compartment length with 6.5 cm inner diameter) with reticulated vitreous glassy carbon electrode (30 x 40 x 10 mm, 10 ppi, 7 cm(2)cm(-3)) as the cathode. The effect of several electrochemical operational variables (pH, volumetric flow, potential) and of the sono-electrochemical parameters (ultrasound amplitude and horn-to-electrode distance) on the cumulative concentration of hydrogen peroxide and current efficiency of the electrosynthesis process have been explored. The application of power ultrasound was found to increase both the cumulative concentration of hydrogen peroxide and the current efficiency. The application of ultrasound is therefore a promising approach to the increased efficiency of production of hydrogen peroxide by electrosynthesis, even in the solutions of lower pH (<12). The results demonstrate the feasibility of at-site-of-use green synthesis of hydrogen peroxide.

Electrochemistry↗