PubMed Health⌕ Search

PubMed · 16275050

Chitosan drug binding by ionic interaction.

Abstract

Three model drugs (insulin, diclofenac sodium, and salicylic acid) with different pI or pKa were used to prepare drug-chitosan micro/nanoparticles by ionic interaction. Physicochemical properties and entrapment efficiencies were determined. The amount of drug entrapped in the formulation influences zeta potential and surface charge of the micro/nanoparticles. A high entrapment efficiency of the micro/nanoparticles could be obtained by careful control of formulation pH. The maximum entrapment efficiency did not occur in the highest ionization range of the model drugs. The high burst release of drugs from chitosan micro/nanoparticles was observed regardless of the pH of dissolution media. It can be concluded that the ionic interaction between drug and chitosan is low and too weak to control the drug release.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Yaowalak Boonsongrit, Ampol Mitrevej, Bernd W Mueller. 2005-11-04. Chitosan drug binding by ionic interaction.. https://doi.org/10.1016/j.ejpb.2005.09.002

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Magnetic properties of ferromagnetic quasi-1D copper-peptide compounds: exchange interactions and very low temperature phase transitions.

The magnetic properties of the Cu(II)-peptide compounds (L-tyrosyl-L-leucinato)Cu(II) and (L-tryptophyl-glycinato)Cu(II), to be identified as Cu(II)Tyr-Leu and Cu(II)Trp-Gly, respectively, have been investigated by specific heat (0.08 < T < 28 K), dc magnetization (2 < T < 80 K, with B(0) = mu(o)H < or = 9 T), and ac magnetic susceptibility (with B(0) = 0 for 0.03 < T < 3 K and B(0) up to 9 T for 2 < T < 80 K) measurements. Above approximately 1 K, the specific heat and magnetization of both compounds display a ferromagnetic (FM) spin chain behavior sustained by syn-anti carboxylate bridges connecting equatorially Cu(II) ions at about 5 A. To model this behavior, we calculated the eigenvalues of Heisenberg chains with up to 20 spins 1/2 and used the method of Bonner and Fisher. A global fit of the model to the specific heat and magnetization data gives 2J(0)/k(B) = 3.60(5) K and 2.59(5) K for the intrachain exchange interactions in Cu(II)Tyr-Leu and Cu(II)Trp-Gly, respectively (H(ex)(i,j) = -2J(0) S(i).S(j)). These values of 2J(0) are discussed in terms of structural properties of the carboxylate bridges in the two compounds. Using the parameters obtained from the global fit, we calculated isothermal susceptibilities in agreement with the ac susceptibilities measured with small applied dc magnetic fields. However, the ac susceptibility measured with applied dc fields larger than 1 T lie between the values calculated for the isothermal and adiabatic susceptibilities. At 0.16 K for Cu(II)Tyr-Leu and 0.53 K for Cu(II)Trp-Gly, the observed specific heat and magnetic susceptibility display peaks associated to three-dimensional magnetic phase transitions. The interchain exchange couplings 2J(1) producing the 3D magnetic order are ferromagnetic and have magnitudes 2J(1)/k(B) approximately 0.015 and 0.073 K for Cu(II)Tyr-Leu and Cu(II)Trp-Gly, respectively.

Chemical Phenomena↗

Hydrogen bonding affects the [NiFe] active site of Desulfovibrio vulgaris Miyazaki F hydrogenase: a hyperfine sublevel correlation spectroscopy and density functional theory study.

Pulse electron paramagnetic resonance and hyperfine sublevel correlation spectroscopy have been used to investigate nitrogen coordination of the active site of [NiFe] hydrogenase of Desulfovibrio vulgaris Miyazaki F in its oxidized "ready" state. The obtained (14)N hyperfine (A = [+1.32, +1.32, +2.07] MHz) and nuclear quadrupole (e(2)qQ/h = -1.9 MHz, eta = 0.37) coupling constants were assigned to the N(epsilon) of a highly conserved histidine (His88) by studying a hydrogenase preparation in which the histidines were (15)N labeled. The histidine is hydrogen-bonded via its N(epsilon)-H to the nickel-coordinating sulfur of a cysteine (Cys549) that carries an appreciable amount of spin density. Through the hydrogen bond a small fraction of the spin density ( approximately 1%) is delocalized onto the histidine ring giving rise to an isotropic (14)N hyperfine coupling constant of about 1.6 MHz. These conclusions are supported by density functional calculations. The measured (14)N quadrupole coupling constants are related to the polarization of the N(epsilon)-H bond, and the respective hydrogen bond can be classified as being weak.

Chemical Phenomena↗

The influence of pressure on the lower critical solution temperature miscibility behavior of aqueous solutions of poly(vinyl methyl ether) and the relation to the compositional curvature of the volume of mixing.

In mixtures of PVME and water, the influence of pressure on the LCST miscibility gap is determined covering the whole composition range and pressures from atmospheric pressure up to 900 MPa. The cloud point curve at atmospheric pressure has the characteristic bimodal shape in agreement with literature data. Upon increasing pressure the cloud point curve at the low concentration side decreases with pressure, whereas at the high concentrations the cloud point curve increases with pressure. The overall influence of pressure results in a less pronounced bimodality and ultimately the bimodal shape disappears. In addition to the pressure dependence of the miscibility behavior, the density of mixtures of water and PVME are determined at atmospheric pressure. The experimental excess specific volumes are negative for all measured compositions, but the compositional curvature varies with composition. The curvature of the excess specific volume is positive for the higher concentrations but it is negative in the lower composition range. The density measurements are linked to the pressure dependence of the LCST miscibility behavior using exact thermodynamic relationships. The excess specific volume and miscibility results are shown to be in good agreement. Moreover, it is shown that the Clapeyron equation, which is exact for pure components and also frequently assumed to apply to mixtures, is not valid in the system PVME/water. The system PVME/water is an example where the usual approximation of one-to-one correspondence between curvature and excess volume does not apply. Finally, the molecular origins for the observed excess volume and miscibility behavior are briefly discussed from theoretical and molecular simulation points of view.

Chemical Phenomena↗