A prediction method for radon in groundwater using GIS and multivariate statistics.

Kirlna Skeppström; Bo Olofsson

doi:10.1016/j.scitotenv.2006.02.044

Home/Archive/PubMed

PubMed · 16580708

A prediction method for radon in groundwater using GIS and multivariate statistics.

Kirlna Skeppström·Bo Olofsson

View original source ↗Export metadata ↓

Abstract

Radon (222Rn) in groundwater constitutes a source of natural radioactivity to indoor air. It is difficult to make predictions of radon levels in groundwater due to the heterogeneous distribution of uranium and radium, flow patterns and varying geochemical conditions. High radon concentrations in groundwater are not always associated with high uranium content in the bedrock, since groundwater with a high radon content has been found in regions with low to moderate uranium concentrations in the bedrock. This paper describes a methodology for predicting areas with high concentrations of 222Rn in groundwater on a general scale, within an area of approximately 185x145km2. The methodology is based on multivariate statistical analyses, including principal component analysis and regression analysis, and investigates the factors of geology, land use, topography and uranium (U) content in the bedrock. A statistical variable based method (the RV method) was used to estimate risk values related to different radon concentrations. The method was calibrated and tested on more than 4400 drilled wells in Stockholm County. The results showed that radon concentration was clearly correlated to bedrock type, well altitude and distance from fracture zones. The weighted index (risk value) estimated by the RV method provided a fair prediction of radon potential in groundwater on a general scale. Risk values obtained using the RV method were compared to radon measurements in 12 test areas (on a local scale, each of area 25x25km2) in Stockholm County and a high correlation (r=-0.87) was observed. The study showed that the occurrence and spread of radon in groundwater are guided by multiple factors, which can be used in a radon prediction method on a general scale. However, it does not provide any direct information on the geochemical and flow processes involved.

Explore related subjects

Environmental Monitoring Forecasting Fresh Water Geographic Information Systems Geological Phenomena Geology Multivariate Analysis Radon Risk Assessment Sweden Water Pollutants, Chemical Journal Article Research Support, Non-U.S. Gov't

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Kirlna Skeppström, Bo Olofsson. 2006-03-31. A prediction method for radon in groundwater using GIS and multivariate statistics.. https://doi.org/10.1016/j.scitotenv.2006.02.044

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2026

Comprehensive source-risk assessment of organophosphate esters in surface water of the Dianchi Lake Basin, Yunnan, China.

Organophosphate esters (OPEs), widely used as flame retardants and plasticizers, have been increasingly detected in aquatic environments. However, investigations of their distribution in high-altitude plateau lakes remain scarce. Identifying and quantifying the sources and associated risks of OPEs are crucial for subsequent water environment management. In this study, an integrated source-risk analysis approach was employed by combining the Positive Matrix Factorization (PMF) model, the Geodetector (GD) model, and risk quotient (RQ). Analysis of 14 OPEs in surface waters of the Dianchi Lake Basin (DLB) revealed 12 detectable compounds, with total OPEs concentrations (ΣOPEs) ranging from not detected (ND)-64.6 ng/L during the wet season and ND-35.8 ng/L during the dry season. Elevated ΣOPEs were primarily observed at inflow sites in the northern part of the lake and in urban rivers. Source apportionment indicated four major contributing sources: agricultural films containing flame-retardant and plasticizer additives, traffic-related particulate emissions, releases from household and personal care products, and industrial production and applications of flame retardants in plastics, electronics, and related products (the predominant source). The ecological impact caused by OPEs ranges from no risk to low risk, with tris(2-chloroethyl) phosphate emitted from industrial source being the primary driver of potential environmental risk. These findings highlight the necessity of prioritizing industrial sources in future management strategies. Overall, this study provides a methodological framework for source apportionment and risk assessment of OPEs and offers scientific evidence to support environmental management of OPEs in the DLB.

Environmental Monitoring↗

PubMed2007

SENEQUE: a multi-scaling GIS interface to the Riverstrahler model of the biogeochemical functioning of river systems.

The Riverstrahler model describes the biogeochemical functioning of an entire river system, from 100 to 100,000 km(2) or more, taking into account the constraints set by the morphology of the drainage network, the meteorological/hydrological conditions, and the inputs of material from point and non-point sources in the watershed. This tool has been applied for research purpose to several river systems differing in terms of hydrological regime and anthropogenic influences. In order to improve its capabilities and its generic dimension, as well as to develop a user-friendly interface allowing its transfer to non-specialist users including managers, the model has been coupled to a GIS interface. This gives the user the possibility to visualize the available geospatial database, to select the best geographical representation of the drainage network, to automatically prepare the corresponding input files required for the model, to pilot the model calculation and to visualize the results. The coupling with a GIS interface has considerably improved the capabilities of the Riverstrahler model. The code of the model is now entirely generic and can be run on any river system for which a suitable database is available. Its spatial resolution can be adapted to the requirement of the relevant problem, from the highest level, where each elementary watershed is individualized, to the lower level, where the whole basin is idealized as one basin with tributaries of each order having the same characteristics. As an illustration of the new potentialities offered by the coupling of Riverstrahler with a GIS through the SENEQUE interface, the results of a same modeling scenario are compared at different spatial resolutions. For the first time, with on-line coupling to a geodatabase, the effect of increasing the spatial resolution of the drainage network representation on the performance of the Riverstrahler model has been examined. At the outlet of the basin, the water quality results were found invariant to a large degree, whatever the details of its representation in the calculations. This result justifies the use of a low resolution representation of the upstream watershed when results are required only at the outlet of the basin.

Environmental Monitoring↗

PubMed2007

High temporal resolution in situ measurement of the effective particle size characteristics of fluvial suspended sediment.

This paper reports the use of a LISST-100 device to monitor the effective particle size characteristics of suspended sediment in situ, and at a quasi-continuous temporal resolution. The study site was located on the River Exe at Thorverton, Devon, UK. This device has not previously been utilized in studies of fluvial suspended sediment at the storm event scale, and existing studies of suspended sediment dynamics have not involved such a high temporal resolution for extended periods. An evaluation of the field performance of the instrument is presented, with respect to innovative data collection and analysis techniques. It was found that trends in the effective particle size distribution (EPSD) and degree of flocculation of suspended sediment at the study site were highly complex, and showed significant short-term variability that has not previously been documented in the fluvial environment. The collection of detailed records of EPSD facilitated interpretation of the dynamic evolution of the size characteristics of suspended sediment, in relation to its likely source and delivery and flocculation mechanisms. The influence of measurement frequency is considered in terms of its implications for future studies of the particle size of fluvial suspended sediment employing in situ data acquisition.

Environmental Monitoring↗