PubMed Health⌕ Search

PubMed · 1704721

Major and trace elements in spruce needles by NAA.

Abstract

Concentrations of 23 elements in needles of Norway spruce (P. abies) have been determined at 47 sites. It is shown that a thorough removal of the aerosols sitting on the needles surface is necessary in order to get the inherent needle concentrations. Neutron activation was used to determine concentrations from 10(-9) to 10(-2) g/g. Irradiation and counting conditions are given. The essential elements, Ca, Cl, Cu, Fe, K, Mg, Mn, P, Zn, and the nonessential elements, Al, As, Ba, Br, Co, Cs, Hg, La, Na, Rb, Sb, Sc, Sr, and V, could be determined. The concentrations of most elements are about a factor of 6 smaller than the mean concentrations in land plants. Analytical reproducibility was much better than the variation among individual trees, and the variation within sites is smaller than among sites. In general, essential elements have smaller variations than nonessential elements. For some elements, variations between sites are owing to differences in the soil pH or the emission situation.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

A Wyttenbach, S Bajo, L Tobler. Major and trace elements in spruce needles by NAA.. https://doi.org/10.1007/bf02992674

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Instrumental neutron activation analysis of rib bone samples and of bone reference materials.

The instrumental neutron activation analysis method was used for the determination of trace elements in rib bone samples taken from autopsies of accident victims. The elements Br, Ca, Cl, Cr, Fe, Mg, Mn, Na, P, Sr, Rb, and Zn were determined in cortical tissues by using short and long irradiations with thermal neutron flux of the IEA-R1m nuclear reactor. The reference materials NIST SRM 1400 Bone Ash and NIST SRM 1486 Bone Meal were also analyzed in order to evaluate the precision and the accuracy of the results. It was verified that lyophilization is the most convenient process for drying bone samples because it does not cause any element losses. Comparisons were made between the results obtained for rib samples and the literature values as well as between the results obtained for different ribs from a single individual and for bones from different individuals.

Neutron Activation Analysis↗

Elemental analysis of herbal preparations for traditional medicines by neutron activation analysis with the k0 standardization method.

Medicinal herb preparations prescribed for specific treatment purposes were purchased from markets and were analyzed by instrumental neutron activation analysis with k0 standardization. Then, 500-700 mg of each sample was pelletized under a pressure of six tones and irradiated together with monitors for alpha and neutron flux ratio determinations for about 6 h in a thermal flux of 2.29 x 10(12) n/cm2/s. The accuracy of the method was established by analyzing standard reference materials. Twenty-nine elements, Ag, As, Au, Ba, Br, Ca, Ce, Co, Cr, Cs, Eu, Fe, Hf, K, La, Mn, Mo, Na, Rb, Sb, Sc, Se, Sm, Sr, Th, U, Yb, and Zn, were measured in all the samples, and Hg was detected in some samples, with good accuracy and reproducibility. The concentration of elements determined was found to vary depending on the composition of the herbs used. Although the trend linking the element of the medicinal plants to its curative abilities could not be clearly determined, this study showed that the toxic elements found in the samples were below the levels prescribed by health regulations. Nevertheless, such data are important to understand the pharmacological action and the exact mechanisms of action and formation of active constituents for each medicinal plant and to decide the dosage of the herbs used in the final formulation.

Neutron Activation Analysis↗

Some improvements in the quality of NAA procedures and the reliability of the results.

After considering the need for quality control in NAA, the concept of quality in NAA procedures themselves is discussed, and some important factors identified. Two approaches to improve quality are then described in more detail. The first concerns the unique ability of NAA using different isotopic reactions and different modes (INAA/RNAA) to provide independent data sets in the same laboratory, thus allowing internal validation or crosschecking. The second discusses the need for chemical yield measurements in RNAA and the advantages of the radioisotopic tracer technique. Some recent advances and further possibilities for this use of tracers are listed.

Neutron Activation Analysis↗