PubMed HealthSearch

PubMed · 2607961

Localized volume selection technique using an additional radial gradient coil.

Abstract

A volume selection technique for the localized NMR imaging using an additional radial gradient is proposed. This volume selection gradient is the fourth gradient in addition to the usual 3-dimensional imaging gradients, i.e., x-, y-, and z-directional gradients, and is of the radial form. The principle of the proposed method is the use of the radial gradient in conjunction with the selective RF pulse thereby selecting a small cylindrical volume which can be used for the 3-dimensional volume imaging with fewer encoding steps than those of the conventional full 3-dimensional volume imaging. The present technique combined with the fast steady state free precession gradient echo imaging sequence allows us to reduce the total scan time to several minutes for the 3-dimensional volume imaging with the spatial resolution of 1 x 1 x 1 mm or to spend the same scan time for the 3-dimensional imaging with improved spatial resolution. The basic principle of the radial gradient coil consisting of a main circular loop coil and an offset compensating Helmholtz coil is discussed and the construction details are presented. Some experimental results of the proposed volume selection imaging technique as well as computer simulation results are also given.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

S Y Lee, Z H Cho. 1989. Localized volume selection technique using an additional radial gradient coil.. https://doi.org/10.1002/mrm.1910120107

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Needlestick injury.

Explore the source record for details and available documents.

Equipment Design

A new oral surgery teaching model.

An anatomical model for teaching the practical aspects of routine oral surgery in a clinical or laboratory environment, is described. Replaceable sections allow the model to be rapidly re-used so that successive students may practise procedures such as incisions, flap reflection, bone removal, tooth removal, apicectomy and suturing. Keeping the cost per procedure to a minimum was considered to be of fundamental importance and this has been achieved through the use of 'factory produced' replacement parts.

Equipment Design