Electromechanical changes during electrically induced and maximal voluntary contractions: surface and intramuscular EMG responses during sustained maximal voluntary contraction.

T Moritani; M Muro; A Kijima; F A Gaffney; D Parsons

doi:10.1016/0014-4886(85)90065-2

Home/Archive/PubMed

PubMed · 2987016

Electromechanical changes during electrically induced and maximal voluntary contractions: surface and intramuscular EMG responses during sustained maximal voluntary contraction.

T Moritani·M Muro·A Kijima·F A Gaffney·D Parsons

View original source ↗Export metadata ↓

Abstract

Changes in the electrical activity of the human gastrocnemius and soleus muscles during fatiguing maximal plantar flexions were studied with computer-aided EMG frequency power spectral analysis and intramuscular spike amplitude-frequency histogram analysis. In some experiments, brief supramaximal nerve stimulations of 80 Hz were given at 15-s intervals during sustained maximal voluntary contractions (MVCs). Multiple muscle biopsy samples were also obtained from the gastrocnemius muscle for fiber type determination. The surface EMG frequency spectral analysis showed a highly significant reduction in mean power frequency and root mean square EMG amplitude during sustained MVCs. The intramuscular spike amplitude-frequency histograms showed that the gastrocnemius muscle had a progressive reduction in the motor unit discharge frequency, particularly those with a relatively high amplitude, whereas the soleus muscle hardly showed a reduction in motor unit activity. Reduction in motor unit activity was also found to be more pronounced in gastrocnemius muscles with higher proportions of type II fibers. Brief maximal tetanic stimulations initially matching the MVC failed to increase the contraction force. Similarly, the evoked compound mass action potentials showed little change in the amplitude in subjects with different muscle fiber compositions. Results of this study suggest that during sustained MVCs, force fatigue could not be attributed to a failure of muscle membrane electrical propagation; a progressive reduction in motor unit activation does not result in a functional disadvantage, but may optimize excitation-contraction coupling by avoiding a muscle electrical conduction failure; and the extent of the reduction in motor unit activation seems to be muscle-fiber-type-dependent which may account for the reduction in amplitude and frequency of the surface EMG.

Explore related subjects

Biomechanical Phenomena Electric Stimulation Electromyography Electrophysiology Humans Male Motor Neurons Muscle Contraction Muscles Neuromuscular Junction Synaptic Transmission Time Factors Journal Article Research Support, Non-U.S. Gov't

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

T Moritani, M Muro, A Kijima, F A Gaffney, D Parsons. 1985. Electromechanical changes during electrically induced and maximal voluntary contractions: surface and intramuscular EMG responses during sustained maximal voluntary contraction.. https://doi.org/10.1016/0014-4886(85)90065-2

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

The effect of excessive tibial torsion on the capacity of muscles to extend the hip and knee during single-limb stance.

Excessive tibial torsion, a rotational deformity about the long axis of the tibia, is common in patients with cerebral palsy who walk with a crouch gait. Previous research suggests that this deformity may contribute to crouch gait by reducing the capacity of soleus to extend the knee; however, the effects of excess external torsion on the capacity of other muscles to extend the stance limb during walking are unknown. A computer model of the musculoskeletal system was developed to simulate a range of tibial torsion deformities. A dynamic analysis was then performed to determine the effect of these deformities on the capacity of lower limb muscles to extend the hip and knee at body positions corresponding to the single-limb stance phase of a normal gait cycle. Analysis of the model confirmed that excessive external torsion reduces the extension capacity of soleus. In addition, our analysis revealed that several important muscles crossing the hip and knee are also adversely affected by excessive tibial torsion. With a tibial torsion deformity of 30 degrees , the capacities of soleus, posterior gluteus medius, and gluteus maximus to extend both the hip and knee were all reduced by over 10%. Since a tibial torsion deformity reduces the capacity of muscles to extend the hip and knee, it may be a significant contributor to crouch gait, especially when greater than 30 degrees from normal, and thus should be considered by clinicians when making treatment decisions.

Biomechanical Phenomena↗

PubMed2007

Predicting the subject-specific primary stability of cementless implants during pre-operative planning: preliminary validation of subject-specific finite-element models.

Pre-operative planning help the surgeon in taking the proper clinical decision. The ultimate goal of this work is to develop numerical models that allow the surgeon to estimate the primary stability during the pre-operative planning session. The present study was aimed to validate finite-element (FE) models accounting for patient and prosthetic size and position as planned by the surgeon. For this purpose, the FE model of a cadaveric femur was generated starting from the CT scan and the anatomical position of a cementless stem derived by a skilled surgeon using a pre-operative CT-based planning simulation software. In-vitro experimental measurements were used as benchmark problem to validate the bone-implant relative micromotions predicted by the patient-specific FE model. A maximum torque in internal rotation of 11.4 Nm was applied to the proximal part of the hip stem. The error on the maximum predicted micromotion was 12% of the peak micromotion measured experimentally. The average error over the entire range of applied torques was only 7% of peak measurement. Hence, the present study confirms that it is possible to accurately predict the level of primary stability achieved for cementless stems using numerical models that account for patient specificity and surgical variability.

Biomechanical Phenomena↗

PubMed2007

Experimental validation of intact and implanted distal femur finite element models.

Four finite element (FE) models of intact and distal femur of knee replacements were validated relative to measured bone strains. FE models of linear tetrahedrons were used. Femoral replacements with cemented stemless, cemented and noncemented femoral stems of the PFC Sigma Modular Knee System were analyzed. Bone strains were recorded at ten locations on the cortex. The magnitude of the FE bone strains corresponded to the mean measured strains, with an overall agreement of 10%. Linear regression between the FE and mean experimental strains produced slopes between 0.94 and 1.06 and R(2) values between 0.92 and 0.99. RSME values were less than 12%. The FE models were able to adequately replicate the mechanical behavior of distal femur reconstructions.

Biomechanical Phenomena↗