PubMed · 298733
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
N Davis. 1979. Take it off.. https://pubmed.ncbi.nlm.nih.gov/298733/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Human enamel surface was irradiated with ArF excimer laser and examined under light microscopy and scanning electron microscopy (SEM). Enamel surface was irradiated at three different areas with different energy fluences. It is demonstrated that the ArF excimer laser causes ablation of the calcified hard enamel tissue. Ablation curves were measured. There was no significant difference found in the etch depth between the three different areas of enamel surface. The morphology of the irradiated areas seen under the SEM was found to be dependent on energy fluence. It changed with increase in energy fluence from being etched to forming a smooth, fused, glaze-like surface and then at very high energy fluences producing a rough surface. The influence of the laser irradiation was confined to the irradiated area only, with no visible heat damage to the surroundings. These results suggest that excimer laser could be applied in a controlled and defined manner for tooth enamel treatments in dentistry.
A pulsed Er:YAG laser (2.94 microns) was used to determine ablation depths per pulse of laser energy at 2 Hz and 5 Hz in human teeth cross sections of enamel and dentin. Ablation depths per pulse at 2 Hz in enamel of intact human teeth were measured and compared to ablation depths per pulse determined in enamel cross sections at 2 Hz. Close correlation was observed for ablation depths per pulse of laser energy between teeth cross sections and intact teeth for enamel. Photographs of lased holes at 2 Hz and 5 Hz indicated minimal thermal effects in enamel at fluences below 80 J/cm2. Minimal thermal effects in dentin were noted below 74 J/cm2. Scanning Electron Microscopy (SEM) pictures of lased dentin showed an irregular serrated surface. Results of this study suggest that the Er:YAG laser can effectively ablate enamel and dentin with minimal thermal effects at 2 Hz and 5 Hz.
Explore the source record for details and available documents.