PubMed · 3037048
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
1987. Bathtub refinishers' lung.. https://pubmed.ncbi.nlm.nih.gov/3037048/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Methyl isocyanate (MIC) in aqueous solution forms methylamine (MA) and N,N'-dimethylurea (DMU). MA in buffered system further converts into its salt form, methylamine hydrochloride (MAH). Therefore, MAH and DMU were evaluated for their mutagenic activity in the in vitro Ames Salmonella/microsome mutagenicity test. The liquid preincubation protocol was followed, using tester strains TA98, TA100 and TA104 of Salmonella typhimurium, in the presence of 0, 5, 15 and 30% Aroclor 1254-induced rat liver S9 mixture. DMU and MAH did not induce a mutagenic response in any of the tester strains, both in the presence and in the absence of S9 mixture. The results therefore confirm that MIC in its native form or as its unknown metabolites is responsible for the mutagenic activity reported earlier by us in the his tester strains TA100 and TA104 of Salmonella typhimurium (Mutation Res., 204 (1988) 123-129) and not due to its hydrolysis products, MA or DMU.
Monitoring of exposure to 1,6-hexamethylene (HDI) monomers and HDI polyisocyanates in Oregon was initiated in 1980 and covered primarily spray painting and related activities. A total of 562 air samples were collected from 60 workplaces during the years 1980-1990 and analyzed for HDI and HDI polyisocyanate content. Of the total, only a small fraction (6%) of the samples exceeded the state of Oregon permissible exposure limit (PEL) of 0.02 ppm for HDI monomer; however, a much higher number (42%) of the samples exceeded the Oregon PEL of 1 mg/m3 for HDI polyisocyanates. Spray finishing operations were divided into three categories: continuous industrial spraying, auto body repair shops, and intermittent spray operations of large objects. The highest exposures among all three categories for both HDI and HDI polyisocyanates were measured during spray finishing. The geometric mean for HDI in the industrial spray operations was 0.001 ppm and for HDI polyisocyanates was 3.78 mg/m3. Frequently, the peak exposures exceeded the Oregon PEL for polyisocyanates, reaching as high as 12.2 mg/m3. In auto body shops, the mean for HDI was 0.002 ppm and for HDI polyisocyanates was 1.60 mg/m3 with peak concentrations of 0.049 ppm for HDI and 18.4 mg/m3 for HDI polyisocyanates. In the third category of spray finishing of large objects, the geometric means for three subcategories ranged from 0.001 to 0.017 ppm for HDI with a peak concentration of 0.069 ppm. The geometric means for HDI polyisocyanates ranged from 2.09 to 15.9 mg/m3 with a peak of 29.5 mg/m3. In all the surveys, the ventilation facilities and personal protective equipment were evaluated.(ABSTRACT TRUNCATED AT 250 WORDS)
Explore the source record for details and available documents.