PubMed Health⌕ Search

PubMed · 3077237

Structure and function of bacteriorhodopsin.

Abstract

Bacteriorhodopsin (bR) is a powerful light-driven proton pump. We have developed a procedure to prepare bR-containing membrane vesicles in which a pH gradient as large as 4 pH units can be generated and maintained in the light. Using such a system, we have demonstrated that bR exhibits a high proton pump activity in a wide pH region; it works well at least between pH 4 and 9.5. For the large light-induced pH change in the external medium, the presence of a high concentration (approximately 0.1 M) of magnesium or transition metal ion is required. It is suggested that the influx of magnesium ion, electrically coupled with the proton release, takes place in the light. The three-dimensional structure of bR was studied by fluorescence energy transfer techniques. It was shown that the retinal chromophore is located 10 A below a surface of purple membrane. The in-plane location and orientation of retinal was also determined; it exists in a pocket surrounded by the helices 3, 4, 5, and 6. The position of a fluorescent probe labeled to Lys 41 was determined to be near the helix 7. Based on the results obtained, we propose a model of the bR structure. The dynamic structure of bR was investigated by fluorescence depolarization techniques. It was shown that the retinal chromophore is tightly buried in a pocket within the protein. In the presence of detergents like octylglucoside, its tertiary structure can be stable near the electric isosbestic point. The rate of dissociation/association process of bR molecules is sensitive to the pH of the medium. Dimeric and/or trimeric bR can exist stably if the concentration of detergent and other solvent conditions are adequately controlled. The photoreaction of bR in purple membrane, including the dark/light adaptation, the trans photocycle and the primary photoreaction, was reported. With respect to the trans photocycle, we found that, at alkaline pH, an M-like photoproduct (NM) is generated by excitation of a long-lived photoproduct N560 which has a major absorption maximum near 560 nm. We suggest that, at alkaline pH, the overall photoreaction of bR under steady illumination is approximated by the two-photon cycle: bR570 approximately greater than M412----N560 approximately greater than NM----bR570. With respect to the primary photoreaction, we found that the fluorescence quantum yield of the near-infrared emission of bR was greatly enhanced at acidic pH (approximately pH 2).(ABSTRACT TRUNCATED AT 400 WORDS)

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

T Kouyama, K Kinosita, A Ikegami. 1988. Structure and function of bacteriorhodopsin.. https://doi.org/10.1016/0065-227x(88)90006-8

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Compositional heterogeneity reflects partial dehydration in three-dimensional crystals of bacteriorhodopsin.

Absorption, fluorescence and excitation spectra of three-dimensional bacteriorhodopsin crystals harvested from a lipidic cubic phase are presented. The combination of the spectroscopic experiments performed at room temperature, controlled pH and full external hydration reveals the presence of three distinct protein species. Besides the well-known form observed in purple membrane, we find two other species with a relative contribution of up to 30%. As the spectra are similar to those of dehydrated or deionized membranes containing bacteriorhodopsin, we suggest that amino acid residues, located in the vicinity of the retinal chromophore, have changed their protonation state. We propose partial dehydration during crystallization and/or room temperature conditions as the main source of this heterogeneity. This assignment is supported by an experiment showing interconversion of the species upon intentional dehydration and by crystallographic data, which have indicated an in-plane unit cell in 3D crystals comparable to that of dehydrated bacteriorhodopsin membranes. Full hydration of the proteins after the water-withdrawing crystallization process is hampered. We suggest that this hindered water diffusion originates mainly from a closure of hydrophobic crystal surfaces by lipid bilayers. The present spectroscopic work complements the crystallographic data, due to its ability to determine quantitatively compositional heterogeneity resulting from proteins in different protonation states.

Bacteriorhodopsins↗

Structural insights into the mechanism of proton pumping by bacteriorhodopsin.

For over three decades, bacteriorhodopsin has served as a paradigm for the study of the mechanisms underlying ion pumping across biological membranes. It is perhaps among the simplest known ion pumps, which functions by converting light energy into an electrochemical gradient by pumping protons out of the cytoplasm. The combination of spectroscopic, biochemical and crystallographic studies on bacteriorhodopsin provides a unique opportunity to dissect the principal elements underlying the mechanism of transmembrane proton transport. Here, we provide a brief review of recent developments related to the determination of the structural changes during proton transport using crystallographic approaches. Taken together with previous spectroscopic and biochemical investigations, these studies allow the description of a detailed molecular mechanism of the main steps in vectorial proton transport by bacteriorhodopsin.

Bacteriorhodopsins↗

Fabrication and photoelectric response of poly(allylamine hydrochloride)/PM thin films by layer-by-layer deposition technique.

Thin films of poly(allylamine hydrochloride) (PAH) and bacteriorhodopsin (bR) embedded in purple membrane (PM) have been prepared by layer-by-layer (LBL) self-assembly technique. The results obtained by UV-Vis spectroscopy and atomic force microscopy (AFM) analysis showed that the biological activity of bR was preserved and PM fragments could be well oriented onto the ITO substrate. A photo-electrochemical cell with the structure of ITO/(PAH/PM)(n)/electrolyte (0.5M KCl)/Pt was fabricated and studied. The photocurrent peaks of (PAH/PM)(6) corresponding to light-on and light-off were about 200 and 100 nA/cm(2), respectively, with the former enhanced 30% higher than that of the reference films made of (PDAC/PM)(6).

Bacteriorhodopsins↗