PubMed · 331203
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
Z Vannicelli, E Galizioli. 1977. [A method of rapid decalcification].. https://pubmed.ncbi.nlm.nih.gov/331203/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Aims of this work were to examine lateral canals in extracted teeth, to propose a new technique to produce artificial lateral canals, and to compare two obturation techniques. Cleared roots were examined to record measure and shape of lateral canals. Artificial lateral canals were prepared on human demineralized teeth before final clearing. Specimens were divided in two groups: canals of group 1 were filled with Schilder's technique, canals of group 2 were filled with vertical compaction with apical backfilling. Stereomicroscopic analysis of lateral canal filling revealed lower filling rates in apical canals compared to coronal ones and higher filling rates with "vertical compaction with apical backfilling" compared to Schilder's group. The tested procedure appears to be a reliable technique to obtain standardized lateral canals and to compare filling procedures.
The purpose of this study was to compare the effects of concentration and pH variations of EDTA on dentin demineralization. Twenty extracted, human permanent teeth with single canals were used in this study. Demineralizing effects of EDTA solutions at 10% and 17% concentrations at pH 7.5 and 9.0 were determined by measuring the amount of liberated phosphorus 1, 3, 5,10, and 15 min after exposure. The results showed that the amount of phosphorus liberated from dentin was greater with increased EDTA concentration and increased time of exposure, and it was more effective at neutral pH than pH 9.0. The pH of the EDTA solutions did not display any significant alterations during the demineralization process.
The aim of the present study was to evaluate the influence of spreader shape on the quality of obturation. Forty-five single canal teeth with varying degrees of apical curvature were used throughout. The canals were prepared using the step-back technique and obturated with lateral condensation. The teeth were classified into three groups (A, B, and C) and treated as follows. Group A was treated with markedly conical, flat-ended spreaders (A to D; Dentsply-Maillefer, Ballaigues, Switzerland). Group B was treated with slightly conical (15 to 40) sharp-pointed CC-cord spreaders. Group C was treated with CC-cord, slightly conical but flat-ended spreaders. The obturated teeth were decalcified in 7.5% nitric acid to obtain four cross-sections: the first at 2 mm from the apex and then the following three sections at 1-mm intervals. Section thickness was approximately 1 mm. Each section was photographed under a stereoscopic microscope. The following areas were measured on each of the microphotographs using a planimeter: (a) gutta-percha mass, (b) mass of sealer, (c) foreign bodies, and (d) empty spaces. These four areas were added to determine total cross-sectional canal area and then the percent of that area attributable to a and to b + c + d was calculated. The statistical analysis of the data (parametric Student's t test for independent groups) revealed that only in group B was the area occupied by a, the gutta-percha mass, significantly greater at all levels than the area occupied by b + c + d. Next in obturation effectiveness was group C, followed by group A.