PubMed HealthSearch

PubMed · 3333137

Monopolar surfaces.

Abstract

Following the development of a methodology for determining the apolar components as well as the electron donor and the electron acceptor parameters of the surface tension of polar surfaces, surfaces of a number of quite common materials were found to manifest virtually only electron donor properties and no, or hardly, any electron acceptor properties. Such materials may be called monopolar; they can strongly interact with bipolar materials (e.g., with polar liquids such as water); but one single polar parameter of a monopolar material cannot contribute to its energy of cohesion. Monopolar materials manifesting only electron acceptor properties also may exist, but they do not appear to occur in as great an abundance. Among the electron donor monopolar materials are: polymethylmethacrylate, polyvinylalcohol, polyethyleneglycol, proteins, many polysaccharides, phospholipids, nonionic surfactants, cellulose esters, etc. Strongly monopolar materials of the same sign repel each other when immersed or dissolved in water or other polar liquids. The interfacial tension between strongly monopolar surfaces and water has a negative value. This leads to a tendency for water to penetrate between facing surfaces of a monopolar substance and hence, to repulsion between the molecules or particles of such a monopolar material, when immersed in water, and thus to pronounced solubility or dispersibility. Monopolar repulsion energies can far outweigh Lifshitz-van der Waals attractions as well as electrostatic and "steric" repulsions. In aqueous systems the commonly observed stabilization effects, which usually are ascribed to "steric" stabilization, may in many instances be attributed to monopolar repulsion between nonionic stabilizing molecules. The repulsion between monopolar molecules of the same sign can also lead to phase separation in aqueous solutions (or suspensions), where not only two, but multiple phases are possible. Negative interfacial tensions between monopolar surfactants and the brine phase can be the driving force for the formation of microemulsions; such negative interfacial tensions ultimately decay and stabilize at a value very close to zero. Strongly monopolar macromolecules or particles surrounded by oriented water molecules of hydration can still repel each other, albeit to an attenuated degree. This repulsion was earlier perceived as caused by "hydration pressure". A few of the relevant colloid and surface phenomena are reviewed and re-examined in the light of the influence of surface monopolarity on these phenomena.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

C J van Oss, M K Chaudhury, R J Good. 1987. Monopolar surfaces.. https://doi.org/10.1016/0001-8686(87)80008-8

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Scintigraphic quantitation of gastrointestinal motor activity and transport: oesophagus and stomach.

For the recognition and characterisation of oesophageal motor disorders, manometry represents the most reliable tool but yields no information on bolus transport. The transport can be quantitated by radionuclide techniques. The patient is positioned supine beneath a gamma-camera and instructed to swallow a radiolabelled bolus in a single gulp. Using a marker over the cricoid and the activity in the stomach as landmarks, regions of interest are drawn representing the upper, middle and lower third of the oesophagus and the gastric fundus. Activity-time curves enable one to recognise the clearance patterns in these regions. In combination, manometric and radionuclide transit studies recognise a higher number of motor disorders than either procedure alone. Radionuclide methods also are the most reliable and sensitive to quantitate gastric emptying. Procedure, meal size and composition as well as patient position must be standardised and correction techniques applied. The emptying of solid and liquid meal constituents can be evaluated concomitantly. Solids start to empty only after a lag phase of varying extent. With semi-solid meals, which are emptied at the same rate as solid meals of identical composition in the postlag phase, the recording time can be considerably shorter. Besides gastric emptying, the amplitude, frequency and propagation velocity of antral contractions can be recorded using serial images of short frame time and specially devised analytic techniques.

Colloids

Determination of the arterial flow fraction in normal and diseased livers using constrained deconvolution.

There is some evidence that the ratio of the blood flow to the liver through the hepatic artery to the total flow to the liver through the hepatic artery and portal vein (the hepatic arterial flow fraction, AFF) is altered in the presence of cirrhosis. Several methods have been published that seek to provide an index of this ratio. These indices are dependent on factors other than the AFF and cannot provide a true measure of it. The impulse retention function of the liver has two components and these may be derived using a model-driven deconvolution of the arterial tracer concentration curve and the curve of tracer concentration in the liver. The AFF may then be obtained from the relative heights of these two components. Simulation studies show that the AFF calculated using this method is reasonably accurate and a small clinical series shows that it is capable of appropriate clinical classification of patients into cirrhotic and non-cirrhotic groups.

Colloids