Fire fighter helmet ventilation analysis.

U Reischl

doi:10.1080/15298668691390205

Home/Archive/PubMed

PubMed · 3766398

Fire fighter helmet ventilation analysis.

U Reischl

View original source ↗Export metadata ↓

Abstract

A series of wind tunnel tests was conducted on selected fire fighter helmets to identify design factors which affect helmet ventilation at various air velocities and head orientation angles. Biomedical heat flux transducers were mounted on the surface of an electrically heated mannequin head to monitor convective heat loss. Under the experimental conditions, specific helmet design features were identified which can contribute to improved helmet ventilation and thus improve body metabolic heat loss. Attention to helmet design and helmet suspension systems is recommended to reduce fire fighter heat stress.

Explore related subjects

Fires Head Protective Devices Humans Models, Anatomic Protective Devices Ventilation Journal Article Research Support, Non-U.S. Gov't

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

U Reischl. 1986. Fire fighter helmet ventilation analysis.. https://doi.org/10.1080/15298668691390205

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

Fire effects on stable isotopes in a Sierran forested watershed.

This study tested the hypothesis that stable C and N isotope values in surface soil and litter would be increased by fire due to volatilization of lighter isotopes. The hypothesis was tested by: (1) performing experimental laboratory burns of organic and mineral soil materials from a watershed at combinations of temperature ranging 100 to 600 degrees C and duration ranging from 1 to 60 min; (2) testing field samples of upland soils before, shortly after, and 1 yr following a wildfire in the same watershed; and (3) testing field soil samples from a down-gradient ash/sediment depositional area in a riparian zone following a runoff event after the wildfire. Muffle furnace results indicated the most effective temperature range for using stable isotopes for tracing fire impacts is 200 to 400 degrees C because lower burn temperatures may not produce strong isotopic shifts, and at temperatures>or=600 degrees C, N and C content of residual material is too low. Analyses of field soil samples were inconclusive: there was a slightly significant effect of the wildfire on delta15N values in upland watershed analyses 1 yr postburn, while riparian zone analyses results indicated that delta13C values significantly decreased approximately 0.71 per thousand over a 9 mo post-fire period (p=0.015), and ash/sediment layer delta13C values were approximately 0.65 per thousand higher than those in the A horizon. The lack of field confirmation may have been due to overall wildfire burn temperatures being <200 degrees C and/or microbial recovery and vegetative growth in the field. Thus, the muffle furnace experiment supported the hypothesis, but it is as yet unconfirmed by actual wildfire field data.

Fires↗

PubMed2006

Thin-layer boilover in diesel-oil fires: Determining the increase of thermal hazards and safety distances.

A study of the effects of thin-layer boilover on large hydrocarbon fires was carried out. In the experiments, diesel-oil was burned in pools with diameters ranging from 1.5 to 6m. Previous models used to predict emissive power during the stationary state were analysed and successively modified in order to accurately predict thermal hazard during the water ebullition phase. It was discovered that the increase in emissive power during thin-layer boilover is greater when the pool diameter is smaller. Furthermore, the required increases in safety distances in the case of accidents involving this dangerous phenomenon are provided.

Fires↗

PubMed2006

Large hydrocarbon fuel pool fires: physical characteristics and thermal emission variations with height.

In a recent paper [P.K. Raj, Large LNG fire thermal radiation-modeling issues and hazard criteria revisited, Process Safety Progr., 24 (3) (2005)] it was shown that large, turbulent fires on hydrocarbon liquid pools display several characteristics including, pulsating burning, production of smoke, and reduced thermal radiation, with increasing size. In this paper, a semi-empirical mathematical model is proposed which considers several of these important fire characteristics. Also included in this paper are the experimental results for the variation of the fire radiance from bottom to top of the fire (and their statistical distribution) from the largest land spill LNG pool fire test conducted to date. The purpose of the model described in this paper is to predict the variation of thermal radiation output along the fire plume and to estimate the overall thermal emission from the fire as a function its size taking into consideration the smoke effects. The model utilizes experimentally measured data for different parameters and uses correlations developed from laboratory and field tests with different fuels. The fire dynamics and combustion of the fuel are modeled using known entrainment and combustion efficiency parameter values. The mean emissive power data from field tests are compared with model predictions. Model results for the average emissive powers of large, hypothetical LNG fires are indicated.

Fires↗