PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 3784599

An improved microelectrode resistance meter.

R S Stephenson·G W Overbeck
View original source ↗Export metadata ↓

Abstract

A device is described for measuring the resistance of micropipette electrodes. The useful range of electrode resistances that it can measure is 100 k omega to 1 G omega. It is more convenient to use than previously described or commercially available meters, especially for very high-resistance electrodes. Resistance of even the finest microelectrodes can be measured accurately while their tips are inserted by hand into a test solution. This eliminates the need for special holders, speeding and simplifying the screening of large numbers of electrodes. Test solutions are stored in interchangeable reservoirs, making it easy to characterize the resistance of an electrode in solutions of different resistivity. Test solutions can also be capped and removed when not in use to prevent evaporation. To protect very high-resistance electrodes from damage during measurement, the measuring current is low (only 300 pA on the highest resistance range) and the test voltage across the electrode is limited to +/- 1 V.

Explore related subjects

Electric ConductivityElectric WiringEquipment and SuppliesMicroelectrodesJournal ArticleResearch Support, U.S. Gov't, P.H.S.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R S Stephenson, G W Overbeck. 1986. An improved microelectrode resistance meter.. https://doi.org/10.1016/0165-0270(86)90135-4

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed1998

Coupling of proton source and sink via H+-migration along the membrane surface as revealed by double patch-clamp experiments.

Long-range proton transfer along the surface of black lipid bilayers was observed between two integral membrane channels (gramicidins), one operating as a proton source, the other as a sink, by patch-clamp technique. In contrast, potassium ions were shown to equilibrate with the aqueous bulk phase before being consumed. Both channels opened and closed simultaneously only if the charge between them was carried by protons. In this case an anomalous high conductance between two patched membrane fragments was measured, each of them containing one single gramicidin channel. The coupled state disappeared when the distance between these two channels was increased above the critical value. The latter was shown to increase with the channel lifetime. Our results support the idea of the 'localized' proton coupling, in which protons that have been pumped across membranes migrate along the membrane surface to reach another membrane protein that utilizes the established pH gradient.

Electric Conductivity↗
PubMed1998

Electrorotation of isolated generative and vegetative cells, and of intact pollen grains of Lilium longiflorum.

The dielectric structure of mature pollen of the angiosperm Lilium longiflorum was studied by means of single-cell electrorotation. The use of a microstructured four-electrode chamber allowed the measurements to be performed over a wide range of medium conductivity from 3 to 500 mS m-1. The rotation spectra of hydrated pollen grains exhibited at least three well-resolved peaks in the kHz-MHz frequency range, which obviously arise due to the multilayered structure of pollen grains. The three-shell model can explain the complex rotational behavior of pollen grains in terms of conductivities, permittivities and thicknesses of the following compartments: the exine and intine of the pollen grain wall as well as the membrane and cytoplasm of the vegetative cell. However, the number of unknown parameters (more than 8) was too large to allow unambiguous values to be assigned to any of them. Therefore, to facilitate the evaluation of the pollen grain parameters, additional rotational measurements were made on isolated vegetative and generative cells. The rotation spectra of these cells could be fitted very accurately on the basis of the single-shell model by assuming a dispersion of the cytoplasm. The data on the membrane and cytoplasmic properties of isolated vegetative cells were then used for modeling the rotation spectra of pollen grains. This greatly facilitated the fitting of the theoretical model to the experimental data and allowed the dielectric properties of the major structural units to be determined. The dielectric characterization of pollen is of enormous interest for plant biotechnology, where pollen and isolated germ cells are successfully used for production of transgenic crop and drug plants of economic importance by means of electromanipulation techniques.

Electric Conductivity↗