PubMed · 3906095
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
J R Ivanhoe. 1985. Alternative cingulum rest seat.. https://doi.org/10.1016/0022-3913(85)90559-1
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
In this study, the cutting ability of a newly developed dental laser was compared with a dental high-speed handpiece and rotary bur for removal of enamel. Measurements of the volume of tissue removed, energy emitted, and time of exposure were used to quantify the ablation rate (rate of tissue removal) for each test group and compared. Cutting efficiency (mm3/s) of the laser was calculated based on the mean volume of tissue removed per pulse (mm3/pulse) and unit energy expended (mm3/J) over the range of applied powers (2, 4, 6, and 8 W). The specimens were then examined by light microscopy and scanning electron micrographs for qualitative analysis of the amount of remaining debris and the presence of the smear layer on the prepared enamel surface. Calculations of the cutting efficiency of the laser over the range of powers tested revealed a linear relationship with the level of applied power. The maximum average rate of tissue removal by the laser was 0.256 mm3/s at 8 W, compared with 0.945 mm3/s by the dental handpiece. Light microscopy and scanning electron micrograph examinations revealed a reduction in the amount of remaining debris and smear layer in the laser-prepared enamel surfaces, compared with the conventional method. Based on the results of this study, the cutting efficiency of the high-speed handpiece and dental bur was 3.7 times greater than the laser over the range of powers tested, but the laser appeared to create a cleaner enamel surface with minimal thermal damage. Further modifications of the laser system are suggested for improvement of laser cutting efficiency.
Effective ablation of dental hard tissues by means of the erbium-doped:yttrium-aluminum garnet (Er:YAG) laser has been reported recently, and its application to caries removal and cavity preparation has been expected. However, few studies have investigated the capability of the Er:YAG laser to treat caries. In the present study, the effectiveness of caries removal by using an Er:YAG laser in vitro was compared with that of conventional mechanical treatment. Thirty-one extracted human teeth with root caries were used. Half of the caries in each tooth was treated with the Er:YAG laser, and the other was removed with a conventional bur or was left untreated as a control. Laser treatment was performed by means of a combination of contact and non-contact irradiation modes with cooling water spray, with a new fiber delivery and contact probe system. Conventional bur treatment was conducted by means of a low-speed micromotor. Measurements of the time required for caries removal, histopathological observations of decalcified serial sections, scanning electron microscope (SEM) observations, and hardness measurements of the treated cavity-floor dentin were performed for each treatment. Due to the careful irradiation technique, a longer treatment time was required for the complete removal of carious dentin by the Er:YAG laser. However, the Er:YAG laser ablated carious dentin effectively with minimal thermal damage to the surrounding intact dentin, and removed infected and softened carious dentin to the same degree as the bur treatment. In addition, a lower degree of vibration was noted with the Er:YAG laser treatment. The SEM examination revealed characteristic micro-irregularities of the lased dentin surface. Our results show that the Er:YAG laser system is promising as a new technical modality for caries treatment.
Explore the source record for details and available documents.