PubMed · 4557758
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
M R Dyer. 1972. The 'Every' type acrylic partial denture.. https://pubmed.ncbi.nlm.nih.gov/4557758/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Raman spectroscopy has been used to investigate the structure of gel-surfactant complexes. Cross-linked sodium poly(acrylate) and sodium poly(styrene sulfonate) were immersed in solutions of the cationic surfactant dodecyl trimethylammonium bromide. During the deswelling process, two distinct regions could be observed for both types of gels. Looking at the Raman spectra, however, for the poly(styrene sulfonate), the surfactant could be found throughout the gel particle, whereas for poly(acrylate), essentially all the surfactant was bound in a surface layer.
A novel approach for the surface modification of poly(acrylonitrile-co-2-hydroxyethyl methacrylate) (PANCHEMA) membranes by introducing phospholipid moieties is presented, which involved the reaction of the hydroxyl groups on the membrane surface with 2-chloro-2-oxo-1,3,2-dioxaphospholane (COP) followed by the ring-opening reaction of COP with trimethylamine. The chemical changes of phospholipid-modified acrylonitrile-based copolymers (PMANCP) membranes were characterized by Fourier transfer infrared spectroscopy and X-ray photoelectron spectroscopy. The surface properties of PMANCP membranes were evaluated by pure water contact angle, protein adsorption, and platelet adhesion measurements. Pure water contact angles measured by the sessile drop method on PMANCP membranes were obviously lower than those measured on the PANCHEMA membranes and decreased with the increase of the content of phospholipid moieties on the membrane surface. It was found that the bovine serum albumin adsorption and platelet adhesion were suppressed significantly with the introduction of phospholipid moieties on the membranes surface. These results demonstrated that the described process was an efficient way to improve the surface biocompatibility for the acrylonitrile-based copolymer membrane.
Glucose oxidase (GOD) and catalase (CAT) were covalently immobilized onto three types of polyacrylonitrile (PAN 1, PAN 2, and PAN 3) ultrafiltration (UF) membranes with different pore sizes and one type of polyamide (PA) microfiltration (MF) membrane by the bifunctional reagent, glutaraldehyde. The initial membranes were pre-modified to generate active amide groups in the PAN membranes and active amino groups in the PA membranes. The PAN 3 membrane contained the highest amount of active groups, and the membrane PA the lowest. The modified membranes were enzyme-loaded by diffusion and convection (UF). The effect of membrane pore size and immobilization methods on enzymatic activity and bound protein were studied. The most effective immobilized system was prepared by diffusion using a PAN 3 membrane as a carrier (bound protein: 0.055 mg/cm(2), relative activity: 87.6%). This membrane had the highest pore size of all the PAN membranes. Despite the highest pore size of PA membrane, the enzyme PA membranes prepared by diffusion showed the lowest amount of bound protein (0.03 mg/cm(2)) and the lowest relative activity (35.38%). This correlates with the lowest amount of active groups found in these membranes. The relative activity was higher for all the enzyme systems loaded by diffusion. The systems prepared by convection of the enzyme solution contained higher amounts of enzymes (0.035-0.13 mg/cm(2) protein), which led to internal substrate diffusion resistance and a decrease in the GOD relative activity (21.55-68.5%) in these systems. The kinetic parameters (V(max) and K(m)) and the glucose conversion of the immobilized systems prepared by diffusion were also studied. [diagram in text].