PubMed HealthSearch

PubMed · 6200849

Apparent pacemaker failure due to reversion circuitry within the programming device.

Abstract

While being evaluated for a recurrent tachyarrhythmia, a patient with a permanent pacemaker underwent reprogramming of the unit from the DVI to the VVI mode for assessment of the underlying rhythm. Subsequent reprogramming of the pacemaker to the DVI or DDD mode was impossible despite multiple attempts and the use of multiple programmers. The problem was considered to be a malfunction of the pacemaker circuitry, and plans were made for the pacemaker to be explanted and a replacement unit implanted. Before the procedure, the pacemaker company was notified of the explantation. We subsequently learned that a special programming sequence had to be carried out because of reversion circuitry present in the pacemaker but not described in the available literature. This report emphasizes the need for familiarity with each of the individual pacemakers being implanted and the need for the manufacturer to be as specific as possible given the complexity of current units.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

D L Hayes, D R Holmes, J Merideth, M J Osborn, W T Bardsley. 1984. Apparent pacemaker failure due to reversion circuitry within the programming device.. https://doi.org/10.1111/j.1540-8159.1984.tb04891.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Needlestick injury.

Explore the source record for details and available documents.

Equipment Design

A new oral surgery teaching model.

An anatomical model for teaching the practical aspects of routine oral surgery in a clinical or laboratory environment, is described. Replaceable sections allow the model to be rapidly re-used so that successive students may practise procedures such as incisions, flap reflection, bone removal, tooth removal, apicectomy and suturing. Keeping the cost per procedure to a minimum was considered to be of fundamental importance and this has been achieved through the use of 'factory produced' replacement parts.

Equipment Design