PubMed · 6378681
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
T McHale. 1984. The Aquaforma process.. https://pubmed.ncbi.nlm.nih.gov/6378681/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
The fit of a fixed partial denture (FPD) is fundamental for the clinical success of a restoration. When a postsoldering procedure is needed, a high-precision laboratory technique is necessary to not affect the fit of the FPD. This article evaluates whether a standardized postsoldering technique affected the marginal fit of a 3-unit high palladium alloy FPD. One hundred and eight measurements were made of 3-unit FPDs, fabricated in a high palladium alloy (2% Au-79% Pd-10% Cu-8% Ga) and constructed on 9 tin dies in vitro. After the castings were fabricated, specimens were measured at 3 specific points per abutment (distal, labial, lingual) before and after soldering. Differences were found in the marginal opening of both copings, before soldering (49.9 microm) and after soldering (48. 3 microm). There was no significant difference in the adaptation of the copings after the soldering procedure (P<.05).
STATEMENT OF PROBLEM: Accelerated bench-set and burnout schedules are used with little knowledge of the effect acceleration has on clinical factors determining casting success. PURPOSE: This pilot study investigated the effect of 2 rapid mold preparation schedules on full crown castings by comparing size, margin sharpness, and surface roughness. MATERIAL AND METHODS: Three groups of 10 crowns were cast with a type III gold alloy. All crowns were nominally identical, only their mold preparation schedules differed. Two groups used accelerated schedules; the third group was cast using a conventional schedule. Group comparisons were based on direct microscopic measurements of crown diameters (x50 magnification), and surface roughness was measured. Margin sharpness was judged by amount of marginal length lost in the axial direction as a result of the casting process. RESULTS: Measured crown diameters, indexing size for the 3 groups, were not significantly different. Crowns made with the conventional schedule had greater surface roughness, and better margin sharpness or length. CONCLUSION: Crowns were successfully cast using accelerated mold preparation techniques and considerable time was saved, but a small loss of margin length or fineness was observed.
All-ceramic restorations may have limitations when used in combinations with other treatment modalities. Removable partial denture (RPD) abutment crowns are typically shaped to provide guide planes, rest seats, and retentive areas. Porcelain-to-metal crowns are routinely fabricated with retentive contours in the veneering porcelain, but until recently, the contours of the other portions of the restoration were developed in metal. This article describes the fabrication of all-ceramic crowns for RPDs with rest seats and guide planes in densely sintered aluminum oxide and retentive areas in veneering porcelain. Within the limitations outlined, this procedure allows the practitioner to use all-ceramic crowns in situations previously reserved for metal or metal-ceramic restorations.