PubMed · 7800590
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
A S Greenwald. 1994. Current concepts in joint replacement.. https://doi.org/10.3928/0147-7447-19940901-03
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
From 1930 to 1994, 54 patients with primary malignant tumors of the sternum were seen. Fifty patients were first seen with a mass, and one half of them also had pain in the sternal region. Two patients had no symptoms at presentation. Among 39 solid tumors were 26 chondrosarcomas, 10 osteosarcomas, 1 fibrosarcoma, 1 angiosarcoma, and 1 malignant fibrous histiocytoma. Of these, 25 were low-grade and 14 were high-grade tumors. Among 15 small cell tumors were 8 plasmacytomas, 6 malignant lymphomas, and 1 Ewing's sarcoma. Partial or subtotal sternectomy was done in 37 patients and total sternectomy in 3. Of the remaining 14 patients, 3 had local excision; 10 had external radiation or chemotherapy without operation, or both; and 1 had no treatment. All but one patient treated by wide resection (N = 40) had some form of skeletal reconstruction of the chest wall defect. Thirty-one (78%) underwent repair with Marlex mesh, and in 25 this was combined with methyl methacrylate. The skin edges were closed per primum in 32 patients; 8 required muscle, omentum, or skin flaps. Resection in chondrosarcomas yielded a 5-year survival (Kaplan-Meier) of 80% (median follow-up, 17 years). The 5-year survival in osteosarcomas was 14%. Resection was curative in 64% of low-grade sarcomas but in only 7% of high-grade sarcomas. In small cell tumors, resection and radiation were helpful for local control; all failures were a result of distant metastases. We conclude that primary sarcomas of the sternum though uncommon are potentially curable by wide surgical excision. With rigid prostheses to repair the skeletal defects, the surgical complication rates are low. Overall survival after complete surgical resection is related to tumor histologic type and grade.
Explore the source record for details and available documents.
We evaluated 2 techniques of cement augmentation to enhance fixation of intertrochanteric hip fractures. 4 fixation groups with 6 cadaver femurs in each group were compared: stainless steel lag screw and side plate with and without cement augmentation and a titanium alloy expandable dome plunger and side plate with and without cement augmentation. Gauges were used to establish the mechanical behavior of intact and then fractured femurs to simple uniaxial loads. Subsequent loading to failure allowed determination of maximum fixation strengths and modes of failure. Cement augmentation of each device increased its load to failure. There was no significant difference between the cemented lag screw and the uncemented dome plunger groups with average loads to failure of 4.0 x 10(3) N. The greatest average load to failure was in the cemented dome plunger group (5.6 x 10(3) N) with the lowest in the uncemented sliding hip screw group (3.6 x 10(3) N). Device cut-out as a cause of failure occurred mostly in the uncemented lag screw group. Sliding was enhanced by those methods that increased the fixation surface area within the femoral head, unless cement encroached in the region of the barrel-screw junction. Strain analysis showed that the dome plunger unloaded the bone at the calcar, regardless of cement augmentation, while the sliding hip screw allowed for compressive stresses in this area. Proper cement augmentation increases load to failure and minimizes nail cut-out for both devices studied. However, the dome plunger, a device with a large fixation area in the femoral head, was equally effective and eliminated potential cement encroachment. Failure of intertrochanteric fracture fixation in osteoporotic bone may be minimized by an appropriate choice of device or cement augmentation.