PubMed HealthSearch

PubMed · 7948623

Modeling and optimising lactose fermentation using a fluorosensor.

Abstract

Lactose has been fermented in a Tokyo Rikakikai Fermentor using two percent seeding at various temperatures. The progress of the reaction was followed by measuring the fluorescent signal due to NADH with a Dr. Ingold (Switzerland) fluorosensor which has an excitation wave length of 360 nm and measurement wavelength of 450 nm. The optimum temperature for this fermentation reaction is 34 degree celsius. At this temperature while biomass growth rate and final biomass concentration are a maximum the time taken to reach the final biomass concentration and lag time are a minimum. The fluorescent voltage vs time data fitted a first order plus dead time model with an error of less than one percent. The present work is in good agreement with earlier work on glucose and lactose fermentation with one percent seeding. The increase in seeding from one to two percent has improved the optimum parameters studied. Further work on higher seeding concentration and higher order models is in progress.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

S Sundaram, D Chopra, S Krithiga, V Damodaran. 1994. Modeling and optimising lactose fermentation using a fluorosensor.. https://pubmed.ncbi.nlm.nih.gov/7948623/

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Integrated electronic nose, GC-MS, and metagenomic analyses reveal volatile flavor and microbial community differences in heap-fermented grains of Jiangxiangxing Baijiu across different fermentation degrees.

The fermentation degree of heap-fermented grains in Jiangxiangxing Baijiu production is a critical factor influencing base Baijiu quality. However, conventional assessment methods largely rely on empirical experience and therefore suffer from limited objectivity and accuracy. In this study, integrated volatile profiling and metagenomic approaches were employed to investigate volatile characteristics and microbial functional potential differentiation in fermented grains with different fermentation degrees (under-fermented, normally fermented, and over-fermented). Significant differences in physicochemical properties were observed among fermentation degrees, particularly in acidity and reducing sugar content. Electronic nose analysis revealed distinct sensor response patterns among different fermentation degrees, indicating differences in overall volatile odor fingerprint patterns. A total of 81 volatile compounds were identified by HS-SPME-GC-MS, with aldehydes, ketones, and pyrazines showing pronounced variations among fermentation degrees, and acetaldehyde exhibiting strong discriminatory potential. LEfSe analysis identified 18 microbial taxa as potential biomarkers associated with different fermentation degrees, including Pichia kudriavzevii, Lentibacillus daiqui, and Acetobacter pasteurianus. Correlation analysis revealed significant positive associations between acetaldehyde levels and Acetobacter abundance. Furthermore, KEGG, CAZy, and eggNOG analyses revealed differentiated functional potentials among fermentation degrees, providing insights into the potential metabolic basis associated with flavor differentiation. Overall, these findings highlight that fermentation degree differentiation is closely associated with coordinated changes in physicochemical conditions, microbial communities, and functional potentials, providing ecological insights into flavor differentiation and theoretical support for objective fermentation degree evaluation and quality control of Jiangxiangxing Baijiu production.

Fermentation

Multi-omics insights into aroma formation in congou black tea during fermentation.

This study used multi-omics technologies to analyze aroma formation during Congou black tea fermentation. Volatile compounds were analyzed by headspace solid phase microextraction coupled with gas chromatography mass spectrometry using two columns of different polarity. Fermentation increased total volatile normalized peak area fivefold, with alcohols, aldehydes, and acids increasing over sevenfold. 29 differential metabolites were screened, including amino acid derived phenylacetaldehyde, phenylethanol, and 2-methylbutanal; fatty acid derived (E,E)-2,4-heptadienal, hexanal, and 1-hexanol; and isoprenoid derived linalool, geraniol, and beta ionone. Transcriptomic, proteomic, and enzyme analyses revealed that biosynthesis contributed to early accumulation of amino acid and isoprenoid derived aromas, whereas ortho quinone mediated Strecker degradation and free radical induced fatty acid auto oxidation dominated generation of amino and fatty acid derived aromas during middle and late fermentation. In conclusion, aroma formation during fermentation results from biosynthesis and non-enzymatic oxidation, with the latter possibly dominating amino and fatty acid derived aromas.

Fermentation

Exploring the mechanism of aroma production in fermented cherry juice by L. brevis LD1.0600 using flavomics and whole genome analysis.

This study focused on L.brevis LD1.0600 with excellent fermentation traits: it analyzed genome-wide key regulatory genes for micro-metabolites, combined with fermented cherry juice flavor metabolomics data, and used machine learning to explore correlations between gene regulation, metabolite production, and flavor formation. The SVM model screened and verified fermented cherry juice VOCs; through OAV and flavor wheel analysis, LD1.0600 emerged as the top-performing strain, with a sweet, fruity dominant aroma. Key aroma-active components (OAV > 100) included 2-methoxy-4-vinylphenol, benzaldehyde, 2-methyl-butanoic acid and hexanoic acid, and 2-methoxy-4-vinylphenol and hexanoic acid elevated by LD1.0600-regulated genes (Chrom1-001884, Chrom1-000925, fabF and Chrom1-000199). At the same time, through research, a "strain screening-SVM screening of DVCs-OAV screening of key aroma components-whole genome sequencing of flavor regulatory genes" system was established. This system can not only be applied to the screen fermentation strains, but also can be extended to the application of other fermentation products.

Fermentation