PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 9041063

Degradable bisphosphonate-alkaline phosphatase-complexed hydroxyapatite implants in vitro.

H Denissen·E van Beek·T van den Bos·J de Blieck·C Klein·A van den Hooff
View original source ↗Export metadata ↓

Abstract

Degradable hydroxyapatite (HA) implants complexed with the resorption inhibiting agent bisphosphonate (PCP) and the mineralizing agent alkaline phosphatase (ALP) can theoretically maintain alveolar bone mass directly after extraction of teeth. The present in vitro study investigated the surface properties of PCP-ALP-complexed HA implants in relation to the requirements of implant behavior and action. Adsorbed PCP (pH 3.49) resulted in a flattening and broadening of the phosphate peaks and the formation of carbonate peaks in the HA pattern of the implant indicating a chemical alteration of the HA surface. Adsorption of ALP onto PCP-altered HA surfaces was 26% lower than onto HA implant blank surfaces. PCP-ALP-complexed HA implants released the PCP and ALP steadily and continuously over observation periods of, respectively, 75 and 14 days. During these observation periods, the ceramic grains of the HA implant became smaller and intergrain boundaries became broader. These morphologic characteristics suggested preconditioning of the HA implant surface for future bonding and degradation in vivo. Individual grains were no longer bonded to other grains and detached from the implant which had become rounded in shape. From in vitro mice experiments we found that PCP concentrations between 10(-4) and 10(-3) M resulted in 45Ca-release from the bone HA. Our calculations showed, however, that only a total concentration of 1.4 x 10(-4) M PCP was gradually released over the whole observation period. In another experiment, it appeared that a PCP concentration in solution < 10(-3) M did not reduce ALP activity. It is concluded that release of PCP by the PCP-ALP-complexed implants is maintained at levels in the range to impair osteoclast bone resorption but not high enough to block osteoblast activity. The amount of ALP released can lead to induction of bone formation onto implant surfaces. pH-induced alterations in the microstructure and chemistry of the HA surface allow for controlled degradation of the HA implants in vitro. A PCP-ALP-complexed HA implant acting as temporary scaffolding for alveolar bone growth enhancement, mineralization, and maintenance seems to be a reasonable concept for preservation of the edentulous alveolus.

Explore related subjects

AbsorptionAlkaline PhosphataseAnimalsBone and BonesDelayed-Action PreparationsDental ImplantsDiphosphonatesDose-Response Relationship, DrugDrug SynergismDurapatiteHistocytochemistryMiceSurface PropertiesJournal Article

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

H Denissen, E van Beek, T van den Bos, J de Blieck, C Klein, A van den Hooff. 1997. Degradable bisphosphonate-alkaline phosphatase-complexed hydroxyapatite implants in vitro.. https://doi.org/10.1359/jbmr.1997.12.2.290

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

Adsorption, absorption, and biological degradation of ammonia in different biofilter organic media.

A tailor-made apparatus called ammoniometer, which is a batch mode respirometer applied to the study of ammonia biodegradation in biofilter media, has been used to evaluate adsorption, absorption, and biodegradation in five different organic materials (compost, coconut fibre, bark, pruning wastes, and peat) obtained from full-scale biofilters in operation in several waste treatment plants. The results showed that absorption could be represented by a Henry's law linear equation, with values of the Henry coefficient significantly higher (from 1,866 to 15,320) than that of pure water (1,498). Adsorption data were successfully fitted to Langmuir and Freundlich isotherms and maximum adsorption capacity varies from 1.06 to 1.81 mg NH(3)/g dry media. Ammonia biodegradation rates for each organic material were also calculated. Biodegradation rates varied from 0.67 to 7.82 mg NH(3)/kg media/d depending on the material tested. The data obtained showed important differences in the behaviour of the biofilter organic media, which has important implications in the design and modelling of these systems.

Absorption↗
PubMed2007

The use of an oil absorber as a strategy to overcome starvation periods in degrading 1,2-dichloroethane in waste gas.

This work investigates the use of an oil absorber as an operational strategy in vapor phase bioreactors exposed to starvation periods, during the treatment of inhibitory pollutants. After being exposed to 1,2-dichloroethane (DCE) starvation periods, the response and stability of a combined oil-absorber-bioscrubber (OAB) system was compared to that of a bioscrubber only (BO) system. In the BO system, after a 5.2 days starvation period, the DCE removal efficiency was reduced to 12%, and 6 days were needed to recover the initial removal efficiency when the DCE feed resumed. The total organic discharged (TOD(DCE)) was 16,500 g(DCE) m(bioscrubber) (-3) after the DCE starvation. Biomass analysis performed using fluorescence in situ hybridisation (FISH) showed that the microbial activity was significantly reduced during the starvation period and that 5 days were needed to recover the initial activity, after the re-introduction of DCE. In contrast, the performance of the OAB system was stable during 5.2 days of DCE starvation. The DCE removal efficiency was not affected when the DCE feed resumed and the TOD(DCE) was significantly reduced to 2,850 g(DCE) m(bioscrubber) (-3). During starvation, the activity of the microbial culture in the OAB system showed a substantially lower decrease than in the BO system and recovered almost immediately the initial activity after the re-introduction of DCE. Additionally, a mathematical model describing the performance of the OAB system was developed. The results of this study show that the OAB system can effectively sustain the biological treatment of waste gas during starvation periods of inhibitory pollutants.

Absorption↗
PubMed2007

Pterin pigment granules are responsible for both broadband light scattering and wavelength selective absorption in the wing scales of pierid butterflies.

A small but growing literature indicates that many animal colours are produced by combinations of structural and pigmentary mechanisms. We investigated one such complex colour phenotype: the highly chromatic wing colours of pierid butterflies including oranges, yellows and patterns which appear white to the human eye, but strongly absorb the ultraviolet (UV) wavelengths visible to butterflies. Pierids produce these bright colours using wing scales that contain collections of minute granules. However, to date, no work has directly characterized the molecular composition or optical properties of these granules. We present results that indicate these granules contain pterin pigments. We also find that pterin granules increase light reflection from single wing scales, such that wing scales containing denser granule arrays reflect more light than those with less dense granule collections. As male wing scales contain more pterin granules than those of females, the sexual dichromatism found in many pierid species can be explained by differences in wing scale pterin deposition. Additionally, the colour pattern elements produced by these pterins are known to be important during mating interactions in a number of pierid species. Therefore, we discuss the potential relevance of our results within the framework of sexual selection and colour signal evolution.

Absorption↗