PubMed · 9203773
The source did not provide an abstract. Follow the original record for more information.
Explore connections, maps & timelines
P Larose. 1997. Holistic dentistry.. https://pubmed.ncbi.nlm.nih.gov/9203773/
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
Hydroxyapatite (HA) contents measurements were conducted on eight biphasic calcium phosphate (BCP) samples obtained by sintering calcium-deficient apatite formed previously by hydrolyzing a dicalcium phosphate dihydrate (DCPD) powder. We evaluated the influences and interactions of three synthesis factors: alkalinity, process duration, and concentration of the water suspension in DCPD. Those parameters were varied simultaneously between two limit levels. Experiments used a factorial design method (FDM) allowing optimization of the number of samples as well as statistical analysis of results. FDM showed that HA content, in a defined experimental area, can be described by a first-order polynomial equation in which the initial alcalinity and the DCPD/water ratio are the major influences. Experiment prove that pH measured at the end of the hydrolysis was predictive of the HA content in the final BCP. This study leads up to an isoresponse line diagram which will allow the synthesis of some BCP with fitted HA/beta-tricalcium phosphate ratios.
We describe a new approach for controlling cell motility on a material surface. Transparent, photosensitive polyimide materials were used to fabricate physical structures on glass; cell motility was then followed over time using optical microscopy. Arrays of pillars and holes with 2 micron square, 4-microm height (or depth) separated by 10 microm were successfully patterned using photolithography. Neutrophils attached and spread on the smooth glass surface and surfaces with pillars. In contrast, cells were rounded and did not adhere to either smooth polyimide film or films with holes. The migration of neutrophils was much faster on holes than on polyimide surface, but it was significantly slower on pillars than on glass. These results suggest that physical patterning may be an effective tool to manipulate cell migration in the design of biomaterials for tissue engineering.
Hydroxyapatite-biodegradable polymer composites have been formed by a low temperature chemical route. Precomposite structures were prepared by combining alpha-Ca(3)(PO(4))(2) (alpha-tricalcium phosphate or alpha-TCP) with poly(L-lactic) acid and poly(DL-lactide-co-glycolide) copolymers. The final composite structure was achieved by in situ hydrolysis of alpha-TCP to Ca(9)(HPO(4))(PO(4))(5)OH (calcium deficient hydroxyapatite or CDHAp) either in solvent cast or pressed precomposites. Hydrolysis was performed at 56 degrees C-a temperature slightly above the glass transition of the polymers. The effects of polymer chemistry, composite formation technique, and porosity on hydrolysis kinetics and degree of transformation were examined with isothermal calorimetry, X-ray diffraction (XRD), Fourier transform infrared spectroscopy, and scanning electron microscopy. Calorimetric data and XRD analyses revealed that hydrolysis reactions were inhibited in the presence of the polymers. Isothermal calorimetry indicated the extent of the alpha-TCP to CDHAp transformation in 24 h to be 85% in the solvent cast composites containing PLGA (85:15) copolymer; however, XRD analyses suggested almost complete reaction. The CDHAp formation extent was 26% for the pressed composites containing the same polymer. In the presence of NaCl as a pore generator, 81% transformation was observed for the pressed composites. This transformation occurred without any chemical reaction between the polymer-inorganic components, as determined by Fourier transform infrared spectroscopy. Minimal transformation to CDHAp occurred in composites containing poly(L-lactic) acid.