PubMed Health⌕ Search

PubMed · 9512721

Evaluation and modification of a physiologically based model of lead kinetics using data from a sequential isotope study in cynomolgus monkeys.

Abstract

Endogenous (predominantly bone) and exogenous lead were differentially labeled in two 11-year-old female cynomolgus monkeys (Macaca fascicularis) to establish the contributions of the two sources to blood lead. The monkeys had been administered a common lead isotope "mix" at the rate of about 1300 micrograms Pb/kg body wt/day from age 10 months until the start of the study. On day 0, common lead was replaced in sequence by mixes artificially enriched in 204Pb, 206Pb, and 207Pb, given for periods of from 50 to 281 days. Total lead ingestion rate was held constant except during administration of the 207Pb-enriched mix to one of the monkeys, when it was reduced to 650 micrograms/kg/day. Blood and bone were sampled at intervals and analyzed for their content of each of the isotope mixes. A physiologically based model of human lead kinetics was scaled to the cynomolgus monkey and fit to the data to test the correctness of the model structure and to assist with interpretation of study results. Fractional absorption was varied to achieve the best visual fits of the scaled model to blood and bone concentration data for each monkey. The model failed to reproduce the sharp drop in isotope concentrations in blood observed after each exchange of isotope mix. Consequently, it was revised to include a rapid-turnover trabecular bone compartment and a slow-turnover cortical bone compartment, using estimates of trabecular and cortical bone turnover rates from histomorphometric studies in adult cynomolgus monkeys. The revised model fit most of the sets of bone and blood concentrations well. About 17% of the blood lead originated from bone after 11 years of exposure, at blood lead concentrations in excess of 50 micrograms/dl. The rate of return of common lead from bone, as estimated from the model, was 28 micrograms/day just before termination of controlled common lead exposure on day 0. Based on the success of the scaled human model in fitting these data and on the absolute and relative values of bone and blood lead concentrations, the metabolism of lead in the cynomolgus monkey appears to be similar to human lead metabolism.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E J O'Flaherty, M J Inskip, C A Franklin, P W Durbin, W I Manton, C L Baccanale. 1998. Evaluation and modification of a physiologically based model of lead kinetics using data from a sequential isotope study in cynomolgus monkeys.. https://doi.org/10.1006/taap.1997.8328

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Fast neutron spectrometry and dosimetry using a spherical moderator with position-sensitive detectors.

A neutron spectrometry and dosimetry measurement system has been developed based on a different design of the divided regions for a sphere, with three position-sensitive counters. The characteristics of the measurement system have been investigated in the reference radiation fields of Am-Be and (252)Cf sources. When realistic input spectra are used for the unfolding, the overall deviations of the calculated results for four dosimetric quantities are less than +/-10%. The results of other input spectra are also discussed in this report.

Americium↗

Sorption of Am(III) onto 6-line-ferrihydrite and its alteration products: investigations by EXAFS.

For the long-term performance assessment of nuclear waste repositories, knowledge about the interactions of actinide ions with mineral surfaces such as iron oxides is imperative. The mobility of released radionuclides is strongly dependent on the sorption/desorption processes at these surfaces and on their incorporation into the mineral structure. In this study the interaction of Am(III) with 6-line-ferrihydrite (6LFh) was investigated by EXAFS spectroscopy. At low pH values (pH 5.5), as well at higher pH values (pH 8.0), Am(III) sorbs as a bidentate corner-sharing species onto the surface. Investigations of the interaction of Am(III) with Fh coated silica colloids prove the sorption onto the iron coating and not onto the silica substrate. Hence, the presence of Fh, even as sediment coating, is the dominant sorption surface. Upon heating, Fh is transformed into goethite and hematite as shown by TEM and IR measurements. The results of the fit to the EXAFS data indicate the release of sorbed Am(III) at pH 5.5 during the transformation and likely a partial incorporation of Am into the Fh transformation products at pH 8.0.

Americium↗

Separation of Am3+ and Eu3+ using an extraction chromatographic resin containing bis(2,4,4-trimethylpentyl)dithiophosphinic acid as the stationary phase.

Sorption of Am3+ and Eu3+ onto an extraction chromatographic resin material, prepared by impregnating purified bis(2,4,4-trimethylpentyl)dithiophosphinic acid (commercially available as Cyanex 301) into Chromosorb W, was investigated. Separation factor (S.F. = K(d,Am)/K(d,Eu)) values tend to increase in the presence of complexing agents such as thiocyanate and nitrate. In presence of 1 M NaNO3 in the aqueous phase, a S.F. value of approximately 1000 was obtained. The nature of extracted species was ascertained by carrying out the sorption studies at different aqueous phase pH. A column made from 300 mg of the resin material was used for the separation of Am3+ and Eu3+. A synthetic solution containing 1x10(5) cpm each of Am3+ and Eu3+ when loaded on to the column, >99% Eu was eluted out in 60 mL of 1 M NaNO3 at a pH of 3.2 while Am was eluted out using 5 mL of 1 M HNO3. The performance of the resin material was found to be reasonably good even after three cycles.

Americium↗