PubMed Health⌕ Search
Home/Archive/PubMed

PubMed · 9530008

The waveguide Mach-Zender interferometer as atrazine sensor.

E F Schipper·S Rauchalles·R P Kooyman·B Hock·J Greve
View original source ↗Export metadata ↓

Abstract

Immunoanalytical techniques used in combination with a highly sensitive Mach-Zender waveguide sensor give a device that is capable of fast on-line monitoring of immunoreactions. The on-line monitoring is especially attractive when the sensor can be used as an environmental probe. It is demonstrated that low concentrations of atrazine can be measured with a sensitivity around the EC limit of 100 ng/L. These measurements are performed with an inhibition technique. In combination with "a dynamic slope method" one complete measurement is done within 10 min. Sensor measurements show the same sensitivity and errors as parallel ELISAs.

Explore related subjects

AtrazineEnzyme-Linked Immunosorbent AssayInterferometryKineticsSensitivity and SpecificityComparative StudyJournal ArticleResearch Support, Non-U.S. Gov't

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E F Schipper, S Rauchalles, R P Kooyman, B Hock, J Greve. 1998-03-15. The waveguide Mach-Zender interferometer as atrazine sensor.. https://doi.org/10.1021/ac970985b

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

PubMed2007

Degradation of atrazine using solar driven fenton-like advanced oxidation processes.

Atrazine (2-chloro-4-ethylamino-6-isopropylamino-s-triazine) was degraded using cobalt-peroximonosulfate (Co/PMS) advanced oxidation process (AOP). Three Co concentrations (0.00, 0.25 and 0.50 mM) and five peroximonosulfate (PMS) concentrations (0, 5, 8, 16 and 32 mM) were tested. Maximum degradation reached was 88% using dark Co/PMS in 126 minutes when 0.25 mM of cobalt and 32 mM of PMS were used. Complete atrazine degradation was achieved when the samples were irradiated by the sun under the same experimental conditions described. Tests for identification of intermediate products allowed identification and quantification of deethylatrazine in both dark and radiated conditions. Kinetic data for both processes was calculated fitting a pseudo-first order reaction rate approach to the experimental data. Having kinetic parameters enabled comparison between both conditions. It was found that the kinetic approach describes data behavior appropriately (R2 > or = 0.95). Pseudo-kinetic constants determined for both Co/PMS processes, show k value of 10(-4) for Co/PMS and a k value of 10(-3) for Co/PMS/ultraviolet (UV). This means, that, with the same Co/PMS concentrations, UV light increases the reaction rate by around one order of magnitude than performing the reaction under dark conditions.

Atrazine↗
PubMed2006

Metalloporphyrins as biomimetic models for cytochrome p-450 in the oxidation of atrazine.

The aim of this work was to evaluate whether metalloporphyrin models could mimic the action of cytochrome P-450 in the oxidation of atrazine, a herbicide. The commercially available second-generation metalloporphyrins 5,10,15,20-tetrakis(2,6-dichlorophenyl)porphyrin metal(III) chloride [M(TDCPP)Cl] and 5,10,15,20-tetrakis(pentafluorophenyl)porphyrin metal(III) chloride [M(TFPP)Cl] (metal = Fe or Mn) and the oxidants iodosylbenzene and metachloroperbenzoic acid were employed in this study. Results showed that the metalloporphyrins used here can oxidize atrazine. Yields as high as 32% were obtained for the Mn(TFPP)Cl/PhIO system, which shows that these catalysts can mimic both the in vivo and the in vitro action of cytochrome P-450, with formation of the metabolites DEA and DIA. The formation of five other unknown products was also detected, but only one of them could be identified, since the other four were present in very low concentrations. The compound COA, identified by mass spectrometry, was the main product in most of the oxidation reactions.

Atrazine↗
PubMed2006

Uptake of atrazine and cadmium from soil by maize (Zea mays L.) in association with the arbuscular mycorrhizal fungus Glomus etunicatum.

A greenhouse pot experiment was carried out to investigate the effect of the arbuscular mycorrhizal fungus Glomus etunicatum on the uptake of atrazine (ATR) and cadmium (Cd) from soil by maize (Zea mays L.). Mycorrhizal colonization led to an increase in the accumulation of Cd and ATR in maize roots but a decrease in the shoots. Atrazine alleviated the adverse effects of Cd on maize growth, and this was more pronounced in the inoculated plants. An increase in Cd accumulation by maize roots was observed when ATR was also present. After harvest, the residual ATR concentration in the soil decreased markedly. With mycorrhizal inoculation the amount of residual ATR decreased more in the bulk soil but less in the rhizosphere soil compared to the noninoculated controls. Cadmium application significantly decreased the ATR residual concentrations in both the rhizosphere and bulk soils irrespective of inoculation treatment.

Atrazine↗