PubMed Health⌕ Search

PubMed · 9759017

Cellular response to Mineral Trioxide Aggregate.

Abstract

This investigation studied the cytomorphology of osteoblasts in the presence of Mineral Trioxide Aggregate (MTA) and examined cytokine production. MTA and Intermediate Restorative Material (IRM) were prepared and placed in separate Petri dishes. Osteoblasts (cell-line MG-63), grown to confluence in Hams F12/Dulbecco's modified Eagle's medium, were seeded into the dishes, which were incubated for 1 to 7 days. The specimens were viewed by scanning electron microscopy. For cytokine evaluation, cells were grown either alone or in other dishes containing the test materials for 1 to 144 h. Media were removed for ELISA analysis of interleukin (IL)-1 alpha, IL-1 beta, IL-6, and macrophage colony-stimulating factor. Scanning electron microscopy revealed healthy cells in contact with MTA at 1 and 3 days; in contrast, cells in the presence of IRM appeared rounded. The ELISA assays revealed raised levels of all ILs at all periods when cells were grown in the presence of MTA; in contrast, cells grown alone or with IRM produced undetectable amounts. The macrophage colony-stimulating factor was produced by cells irrespective of the group. It seems that MTA offers a biologically active substrate for bone cells and stimulates IL production.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E T Koh, F McDonald, T R Pitt Ford, M Torabinejad. 1998. Cellular response to Mineral Trioxide Aggregate.. https://doi.org/10.1016/s0099-2399(98)80074-5

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related citations

Layer-by-layer self-assembly aluminum Keggin ions/Prussian blue nanoparticles ultrathin films towards multifunctional sensing applications.

In this study we described the nanocomposites films of specially synthesized inorganic Prussian blue (PB) nanoparticles and polyoxocation Al(13) Keggin ions that possess the excellent sensing activities. Film fabrication using layer-by-layer (LBL) self-assembly technique was followed by electrochemical characterization. The assembled multilayer Al(13)/PB films as sensor devices for both the catalytic reduction of H(2)O(2) and detecting the change of relative humidity were also investigated. The sensitivity of the biosensor was 0.886 mA cm(-2)mM(-1), and about two orders of magnitude change in resistance was observed as the relative humidity increasing from 5 to 95%. Both sensors exhibited good reproducibility, wide linear range. The performance and multifunctional abilities of these nanocomposites promise potential applications in biosensors, environmental controlling system and biomedical devices.

Aluminum Compounds↗

A new binary compound for the production of 124I via the 124Te(p,n)124I reaction.

The binary compound, aluminum telluride (Al(2)Te(3)), was investigated as a target material for the production of (124)I by way of the (124)Te(p,n)(124)I reaction on a low-energy cyclotron. The high melting point and formation of a glassy matrix upon heating provided a stable target material at irradiations up to 20 microA of 11 MeV protons. The 87% tellurium mass fraction and 95% iodine separation yield led to significantly higher quantities of iodine compared to traditional TeO(2)/6%Al(2)O(3) admixtures. Radiochemical analysis of distilled samples using ion chromatography showed that the product remained in the iodide form while supported in weak buffer solutions. Stable Te impurities in the radioiodine product were less than 0.5 microg following purification by ion exchange chromatography. Average thick target yields of 229+/-18 microCi/microAh were achieved, and typical production runs at 18 microA for three hours yielded 12 mCi at the end-of-bombardment. Total losses of the target material after each irradiation and distillation cycle were approximately 2%.

Aluminum Compounds↗