PubMed Health⌕ Search

Biomedical subjects

G F Palmieri

Publications and source records attributed to G F Palmieri.

17 recordsLinked to original sources

The spray drying of acetazolamide as method to modify crystal properties and to improve compression behaviour.

Acetazolamide shows a very poor compression ability and tablets must usually be produced through a wet granulation process. However, the possibility to obtain pure acetazolamide for direct compression could be interesting for industrial application. With the scope to obtain a material for direct compression, three different crystallisation methods were chosen, with respect to acetazolamide solvent solubility. (a) Acetazolamide was dissolved in an ammonia solution and then spray dried. It was possible to characterise the spherical particles as a mixture of two polymorphic forms, I and II by Powder X-ray diffraction study. (b) Pure form I was obtained by slowly cooling to room temperature a boiling water solution. (c) Pure form II, the marketed form, was obtained by neutralisation of an ammonia solution. Their compression behaviour was investigated firstly by a rotary press. Whilst pure polymorphic forms I and II could not be compressed, the spray dried particles showed very good compression properties. In fact, tablets were obtained only by spray dried particles, which show very good properties under compression and the absence of capping tendency. On the other hand, it was impossible to obtain tablets from polymorphic forms I and II, whatever compression pressures were used. In order to explain their densification mechanism, a single-punch tablet machine, equipped for the measurement of the upper punch displacement in the die, was used. From calculated Heckel's parameters, it was demonstrated that the spray dried material shows a greater particle rearrangement in the initial stage of compression due to its spherical habit and minor wrinkledness of particle surface. The crystalline structure due to the presence of polymorphic forms I and II concur to lowering the intrinsic elasticity of the material. This fact avoids the risk of the rupturing the interpaticulate bonds, which are formed during the compression, concurring to the consolidation of the tablet.

Acetazolamide↗

Physical characterization of naproxen sodium hydrate and anhydrate forms.

Naproxen sodium (NS) is a nonsteroidal anti-inflammatory drug used in painful and inflammatory diseases. By crystallization from water or by exposure to relative humidities over 43%, the anhydrate form can be hydrated to a dihydrate species. Different techniques have been used to characterize physically anhydrate naproxen sodium (ANS) and hydrate naproxen sodium (HNS): elemental analysis, atomic absorption, electron scanning microscopy, thermomicroscopy, differential scanning calorimetry, Karl Fisher's titrimetry, thermogravimetry, spectrophotometric analysis and X-ray diffraction study. The hydration/dehydration mechanism, at different relative humidities, was investigated to evaluate their physical stability. When stored up to 43% relative humidity, ANS shows a good stability, whereas with an increase in relative humidity it is hydrated. HNS equilibrium solubility was determined at different temperatures (21, 26, 31, and 37 degrees C). Due to the metastability and the quick phase changes in the water of ANS, its solubility was calculated from intrinsic dissolution measurements at the same temperatures, as solubility measurements of HNS. Water solubility of ANS is greater than HNS, but the solubility difference decreases when the temperature decreases. This is due to the fact that at higher temperatures the intrinsic dissolution rates (IDR) of ANS are considerably faster and decrease as the temperature falls.

Anti-Inflammatory Agents, Non-Steroidal↗

Spray-drying as a method for microparticulate controlled release systems preparation: advantages and limits. I. Water-soluble drugs.

Spray-drying was used for the preparation of paracetamol/eudragit RS or RL or ethylcellulose microspheres to verify the possibility of their use in controlled-release solid-dosage forms formulation and try to determine advantages and limits of the technique of such use. Microspheres were first characterized by scanning electron microscopy, differential scanning calorimetry, x-ray diffractometry, and in vitro dissolution studies and then used for the preparation of tablets. During this step, the compressibility of the spray-dried powders was also evaluated. In vitro dissolution studies were performed also on the tablets and their release control was accessed. Although powders were unable to slow down drug release, tablets obtained from microsphere compression showed a good capability of controlling paracetamol release when eudragit RS or ethylcellulose was used, even at low polymer amounts.

Acetaminophen↗

Emulsion/solvent evaporation as an alternative technique in pellet preparation.

Paracetamol/Eudragit RS, paracetamol/ethylcellulose, and paracetamol/cellulose acetate pellets of different drug/polymer ratios (w/w) were prepared by the dissolution/solvent evaporation technique. These pellets were then characterized by particle size distribution analysis, ultraviolet (UV) spectroscopy, differential thermal analysis, and scanning electron microscopy (SEM). Hard gelatin capsules were filled with each particle size fraction of these pellets, and in vitro dissolution studies were performed to verify the capability of each series of pellets to control drug release. Pellets were spherical, presented a polynucleated microcapsule structure, and under certain experimental conditions, the yield of the preparation process reached very high values. The dissolution studies pointed out the slow paracetamol release from these pellets.

Acetaminophen↗

Polymers with pH-dependent solubility: possibility of use in the formulation of gastroresistant and controlled-release matrix tablets.

Polymers usually utilized for gastroresistant film coating of tablets or pellets such as cellulose acetate phthalate (CAP), cellulose acetate trimellitate (CAT), hydroxypropylmethylcellulose phthalate (HPMCP), and Eudragit L and S were used in the preparation of drug/polymer matrix tablets. These tablets were prepared either by direct compression of both powders or by the formulation of microspheres that were then compressed. The microspheres were characterized by scanning electron microscopy (SEM), differential scanning calorimetry (DSC), and X-ray diffractometry analyses. Dissolution studies were finally carried out to verify if the tablets possessed gastroresistant or controlled-release characteristics. Except for Eudragit L, the polymers can be used under certain conditions in the formulation of modified-release tablets.

Acetaminophen↗

Molecular mobility of the paracetamol amorphous form.

The purpose of this paper is to study the molecular mobility of paracetamol molecules in their amorphous state below the glass transition temperature (Tg) in order to evaluate the thermodynamic driving force which allows the amorphous form to recrystallize under different polymorphic modifications. Samples were aged at temperatures of -15, 0, 6, and 12 degrees C for periods of time from 1 h to a maximum of 360 h. The extent of physical aging was measured by a DSC study of enthalpy recovery in the glass transition region. The onset temperature of glass transition was also determined (Tg). Enthalpy recovery (deltaH) and change in heat capacity (deltaCp) were used to calculate the mean molecular relaxation time constant (tau) using the empirical Kohlausch-Williams-Watts (KWW) equation. Enthalpy recovery and onset glass transition temperature increased gradually with aging and aging temperatures. Structural equilibrium was reached experimentally only at an aging temperature of 12 degrees C (Tg-10 degrees C), according to the deltaH(infinity) results. The experimental model used is appropriate only at lower aging temperatures, while at higher ones the complexity of the system increases and molecular polymorphic arrangement could be involved. When structural equilibrium is experimentally reached, molecules can be arranged in their lowest energy state, and the polymorphic form I formation is the one preferred.

Acetaminophen↗

Methoxybutropate microencapsulation by gelatin-acacia complex coacervation.

Microcapsules of methoxybutropate solid particles or of an oily saturated solution of the same drug were prepared by complex coacervation between gelatin and acacia and dried with three different methods: isopropanol addition, spray-drying, and freeze-drying. Successively, microparticles were analyzed by infrared thermobalance, ultraviolet (UV) spectroscopy, optical and scanning electron microscopy, and sieves to find out parameters such as yield, moisture content, encapsulation percentage, morphology of solid particles, and particle size. Results highlighted that the most appropriate drying method for industrial purposes was spray-drying, particularly for oil-containing microcapsule formulations.

2-Propanol↗

New controlled-release ibuprofen tablets.

Tablets containing two different doses of ibuprofen are realized. The first possesses very fast release kinetics, while the second has slow and linear release kinetics. This allows drug to produce a therapeutic effect quickly and to maintain it for a long time with only one administration unit. Such tablets are obtained by compression of a mixture of two very different kinds of granulates: an ibuprofen-starch granulate and an ibuprofen-Eudragit RS microsphere granulate. Specific proportions of mixtures of them give the described result after compression at particular tablet hardnesses.

Anti-Inflammatory Agents, Non-Steroidal↗

Improved dissolution behavior of fenbufen by spherical crystallization.

Fenbufen is an analgesic, antipyretic and anti-inflammatory drug that is characterized by poor water solubility, a defect increased by very low wettability. Poor water solubility, particularly at low pH, could decrease absorption in the upper part of the gastrointestinal tract, which would be inconvenient for good bioavailability. Different spherical crystallization processes have been considered as methods to improve fenbufen dissolution behavior. A two-solvent system, in the presence of a bridging liquid, is the only method capable of producing spherical fenbufen crystals. In a first step, fenbufen solubility was considered in different solvents. The drug crystals formed were typically needle shaped. This characteristic was considered as a favorable parameter to obtain spherical crystals. After the selection of the best fenbufen solvent, several ratios of solvent (S)-nonsolvent (NS) (tetrahydrofuran [THF]-demineralized water) were studied. The addition of a bridging liquid (isopropyl acetate) improved spherical crystallization. The results from this method were reproducible batch to batch. The spherical crystals obtained showed a clear improvement in dissolution capacity, probably due to better wettability. Dissolution studies were then carried out on these spherical crystals stored for 1 month at different relative humidities (RHs). The dissolution profiles remained unchanged.

Anti-Inflammatory Agents, Non-Steroidal↗

Interactions between lonidamine and beta- or hydroxypropyl-beta-cyclodextrin.

The possibility of obtaining inclusion complexes between lonidamine and beta- or hydroxypropyl-beta-cyclodextrin have been evaluated by phase solubility diagram, differential scanning calorimetry (DSC), and x-ray diffractometry. The applied complexation methods were spray-drying, kneading, and solid dispersion. DSC and x-ray analyses of the powders revealed an external interaction between lonidamine and cyclodextrins. Dissolution profiles of the obtained powders were also studied to define the most appropriate preparation method and molar ratio to use in attempts to increase lonidamine water solubility.

2-Hydroxypropyl-beta-cyclodextrin↗

Synthesis and biological evaluation of mono- and bis-[(alkylamino)alkylamino] substituted thienopyridopyridazines, a new class of potential antitumor agents.

A new class of potential antitumor agents, provided with thieno[2',3':5,6]pyrido[2,3-d]pyridazin-9(4H)-one nucleus as chromophore, was synthesized. Thus, the suitable amines were reacted, in different conditions, with 5,8-dichlorothieno[2',3':5,6]pyrido[2,3- d]pyridazin-9(4H)-one (5) to afford the 8-alkylamino derivatives 6a-f, the 5-alkylamino derivatives 7a-f, and the 5,8-bis-alkylamino derivatives 8a,b. Selected compounds were evaluated for cytotoxic potency in vitro against the human colon adenocarcinoma HT 29 cell line and studied in DNA binding assays. The cytotoxic potency versus HT29 was also correlated with binding affinity for calf thymus DNA.

Animals↗

Tabletted polylactide microspheres prepared by a w/o emulsion-spray drying method.

An emulsification-spray drying technique is used to prepare poly(D,L-lactic acid) (PDLLA) microparticles loaded with a water soluble, non-steroidal anti-inflammatory drug (NSAID), sodium naproxen (NaNPX). The method involves the preparation of a w/o emulsion in which the water soluble drug is dissolved in the aqueous dispersed phase, while the polymer is dissolved in the organic continuous phase. As a comparison, microparticles were prepared by spraying a suspension of the drug into an organic solution of the polymer. The spray-dried particles were characterized using SEM, DSC, XRD and in vitro release tests. The spray-dried product was then compressed (direct compression) to obtain controlled release matrix tablets. All microparticles release NaNPX within 30 min. The matrix tablets release the drug in 8-10 h; the matrix tablets characterized by the presence of surfactant (due to the emulsion used to obtain the microparticles) have the highest release rate.

Anti-Inflammatory Agents, Non-Steroidal↗

Gastro-resistant microspheres containing ketoprofen.

Ketoprofen gastroresistant microspheres were prepared by spray-drying using common pH dependent polymers, such as Eudragit S and L, CAP, CAT and HPMCP. The long ketoprofen recrystallization time was a serious hindrance to the preparation of microspheres having a drug content higher than 35%. Microspheres were characterized by scanning electron microscopy, differential scanning calorimetry, X-ray diffractometry and in vitro dissolution studies, and used for the preparation of tablets. During this step, the compaction ability of the spray-dried powders was measured. While the compressibility of the microspheres containing the enteric cellulosic derivatives are not acceptable and different from those of the microcrystalline cellulose, the compaction properties of ketoprofen/Eudragit L or S microspheres are comparable to those of the Avicel PH 101. In vitro dissolution studies were performed on the microspheres and the tablets. All microspheres showed a good gastroresistance, but some differences among the five polymers in reducing drug release at low pH values are present. Acrylic polymers (Eudragit L or S) are considerably more effective than the cellulosic derivatives CAP and CAT, while the HPMCP profile is in an intermediate position. These differences are erased by the microspheres compression process. In HCl 0.1 N, the percentage of ketoprofen released from the tablets is always close to zero, independently from the polymer used.

Acrylates↗