PubMed Health⌕ Search

Biomedical subjects

H Planck

Publications and source records attributed to H Planck.

31 records · Page 2Linked to original sources
PubMed1989

Isoelastic polyurethane prosthesis for segmental trachea replacement in beagle dogs.

Porous polyurethane (nonwoven) was used for the development of tracheal prosthesis, which--in a special testing design--was adapted to shape and biomechanic properties of the natural organ. This prosthesis was implanted into 19 beagle dogs using inverted, everted, and end-to-end anastomosis. Insufficiency of the anastomosis or infection was observed in the everted and end-to-end anastomosis, whereas the inverted anastomosis showed complete incorporation into surrounding tissue of the porous prosthesis but was complicated by airway obstruction due to anastomosis granuloma.

Anastomosis, Surgical↗
PubMed1988

A potentially implantable enzyme electrode for amperometric measurement of glucose.

A membrane limited amperometric enzyme electrode suitable for glucose measurement in biological fluids was developed. The sensor consists of a central platinum wire (0.3 mm) surrounded by a stainless steel tubing (0.8-1.0 mm outer diameter; 2-4 cm length). By successive dipcoating procedures, layers from cellulose acetate, glucose oxidase (crosslinked with glutaraldehyde) and polyurethane are placed on its surface. The platinum is polarized at +700 mV against steel. In vitro results: Electrodes are stable for at least 6 days. They exhibit a linear range extending to 500 mg/dl glucose. Response times are less than 100 sec. The sensors are not dependent on stirring and are relatively insensitive to changes of pH. Dependency of glucose measurement upon dissolved oxygen is negligible at oxygen concentrations above 0.5 mg/l. In vivo results: Preliminary studies in sheep using subcutaneously implanted needles indicate that short term glucose monitoring is feasible.

Animals↗
PubMed1985

A new bioprosthesis: impermeable for bacteria, permeable for fluids, incorporable by connective tissue.

Polyurethane non woven membranes with microporous inner layer and macroporous outer layer where tested bacteriologically and histologically. It was proved that the macroporous layer is suitable for the ingrowth and maturing of connective tissue, while the microporous structure prevents the invasion of bacteria, nevertheless being permeable for nutrient substances. So the material could be yield favourable presupposition to achieve bioincorporation in contaminated borderlines.

Animals↗
PubMedDate not supplied

Experimental in vitro and in vivo studies of epithelium formation on biomaterials seeded with isolated respiratory cells.

Extensive tracheal defects after intensive care medicine, trauma, or large resections in tumor surgery remain a major challenge in plastic and reconstructive surgery. Defects that cannot be satisfactorily treated by complicated and costly reconstructive techniques reveal a need for an alloplastic tracheal replacement. Recent experimental and clinical studies in the development of alloplastic tracheal prostheses proved that the lack of an epithelial lining on the luminal surfaces and inadequate biophysical properties and shapes of the prostheses were the main causes for failure of these prostheses. In this study a cell-seeding technique has been used. Adhesion, spreading, and differentiation of seeded mucosa cells on biomaterials in vitro were observed by scanning electron microscopy (SEM). Chemical properties and surface structure of the material influenced the differentiation process. Epithelium formation of incorporated tracheal prostheses was tested in animal experiments. Isolated respiratory cells were seeded into implanted tubular prostheses of porous polyurethane or expanded polytetrafluorethylene. Light microscopy and SEM showed the tendency of epithelium formation on the surface of the lumen. Vigorous cell layers, predominantly as multiple cell layers of squamous epithelium, were observed. Ciliated or mucus cells were not detected. It can be stated that the epithelium formation on incorporated porous implants is possible. Further studies of the stability and the differentiation process of the epithelium on such implants is needed before an introduction of tracheal replacements into the clinical practice can be considered.

Biocompatible Materials↗
PubMedDate not supplied

Alveolar ridge repair using resorbable membranes and autogenous bone particles with simultaneous placement of implants: an experimental pilot study in dogs.

The aim of this experimental study was to evaluate the use of autogenous bone harvested during preparation of implant sites in combination with resorbable membranes for vertical ridge augmentation under 2 different defect site conditions. Combined vertical/horizontal alveolar bone defects were created by experimentally induced periodontal infections around all premolar teeth in the mandibles of 3 dogs (group 1). In another 3 dogs, fresh surgical defects were created after extraction of all premolar teeth in the mandibles (group 2). In all dogs, 2 implants were placed on each side of the mandible into the defect areas. One implant on each side of the mandible received augmentation with autogenous bone particles, and both implants on one side of the mandible were covered with polylactic acid membranes. After 5 months, the material was evaluated histologically. There was a small but significant increase in bone regeneration in the defects augmented with bone particles with and without membrane coverage in group 1. In group 2, no significant difference was seen between the controls and the augmented sites. The major limiting effect for bone regeneration appeared to be insufficient stability of the bone material to withstand the overlying soft tissue pressure. It was concluded that the placement of autogenous bone particles, either with or without membrane coverage, had little effect on the regeneration of peri-implant bone defects.

Absorbable Implants↗
PubMedDate not supplied

Dynamic model for the development and testing of a tracheal prosthesis under preclinical conditions.

The development of a tracheal prosthesis was evaluated using in vivo data on mechanical loads in the natural organ. The application of in vivo loads to the explanted organ in a laboratory tester was shown to give information on the natural reaction forces of the organ. It is therefore possible to perform in vitro tests on various prosthesis prototypes under near-natural stress conditions and to adapt the prostheses accordingly before implantation.

Animals↗