PubMed Health⌕ Search

Biomedical subjects

Jianxi Lu

Publications and source records attributed to Jianxi Lu.

11 recordsLinked to original sources
PubMed2006

Clinical, radiological and histological study of the failure of cervical interbody fusions with bone substitutes.

Few histological studies on bone substitutes in human cervical spine are available and the biological processes of bone substitutes are not well documented. The authors studied four failure cases of cervical interbody fusion: two cases with hydroxyapatite (HA), one case with beta-tricalcium phosphate ceramic (beta-TCP) and one case with xenograft (bovine bone). Clinical data showed that all the patients experienced neck pain with or without numbness of upper extremity due to fusion failure. Successful fusions were achieved after the salvage surgeries in which autograft were used. Radiographs showed that radiolucent lines were present in all cases. Two HA substitutes fractured without complications. One of them sank into the vertebral body. Some small beta-TCP fragments were found under the microscope. Histological study demonstrated only a few newly formed bones at the interface of the substitutes. The fragments of HA were encapsulated by fibrous tissue. The degradation process and bone regeneration were more active in beta-TCP than in HA. The intertrabecular spaces of bovine bone were filled with fibrous tissue. The results suggest that a porous calcium phosphate ceramic with special design might assure bone ingrowth and meet the mechanical requirements in cervical interbody fusion. The complications of these materials in the cervical spine should be highlighted.

Adult↗
PubMed2006

Evaluation of the osteogenesis and biodegradation of porous biphasic ceramic in the human spine.

The histological reports on porous biphasic calcium phosphate ceramic (PBC) in human spine are limited. The osteogenesis and biodegradation of PBC are insufficiently known in human. In present study, the undecalcified histological study was carried out on 20 samples retrieved from posterior spinal fusion in order to reveal the osteogenesis and biodegradation of the PBC in human spine. The quantitative study was performed in 14 samples with sufficient size. Newly formed bone was found in all the samples. More new bone was formed in those samples closely in contact with autogenous bone. The PBC degradation particles were present both in the macrophages and around the tissue. However, those phenomena were highly variable among the samples. New bone formation increased with time and decreased with age. The PBC degradation decreased with age, but it did not differ greatly with time. New bone formation was higher and the residual material was lower in the fusion group than that in non-fusion group. The PBC is a kind of osteoconductive material and do not transform into new bone after a relatively long time. The PBC should be well mixed with the autogenous bone in order to achieve high new bone colonization. The PBC degradation particles and related active phagocytotic activity have been noted.

Absorbable Implants↗
PubMed2006

[Micro-particles of bioceramics could cause cell and tissue damage].

We conducted studies to confirm the hypothesis that the cellular damage occurring around implanted biphasic bioceramics could be related to a micro-particles release because of an insufficient sintering. An in vitro cytotoxicity study was performed on four biphasic ceramic (BCP) samples. Without the treatment of extraction medium, a cytotoxicity was observed, although after centrifugation this cytotoxicity disappeared in all samples. (2) Micro-particles of HA, beta-TCP and 40%beta-TCP/60%HA mixture were used for a cell inhibition study. A decrease of cell viability was observed with the increase in particles concentration. At 10000 particles/ cell, the viability and proliferation were completely inhibited. (3) HA, beta-TCP and BCP ceramic granules were implanted in rabbit femoral cavities for 12 weeks. No degradation of HA granules was observed. The degradation was higher for beta-TCP (40%) than for BCP (5%). On the other hand, new bone formation was significantly higher for beta-TCP (21%) and HA (18%) than for BCP (12%). Much more micro-particles were formed around BCP granules than around beta-TCP, and were phagocytosed by macrophages. The release of ceramic micro-particles could be related to the sintering process. BCP ceramics have to be sintered at only 1160 degrees C. Consequently, HA microparticles of BCP ceramic are incompletely sintered and easily released after immersion or implantation. The microparticles could be at the origin of local inflammation and cell damage and could perhaps modify osteogenesis. Particular attention must be paid to this problem with regard to BCP ceramics because of the sintering difficulties of this bioceramic.

Biocompatible Materials↗
PubMed2005

Repair of sheep metatarsus defects by using tissue-engineering technique.

Tissue-engineering bone with porous ,betatricalcium phosphate (3-TCP) ceramic and autologous bone marrow mesenchymal stem cells (MSC) was constructed and the effect of this composite on healing of segmental bone defects was investigated. 10-15 ml bone marrow aspirates were harvested from the iliac crest of sheep, and enriched for MSC by density gradient centrifugation over a Percoll cushion (1. 073 g/ml). After cultured and proliferated, tissue-engineering bones were constructed with these,cellS seeded onto porous f-TCP, and then the constructs were implanted in 8 sheep left metatarsus defect (25 mm in length) as experimental group. Porous ,-TCP only were implanted to bridge same size and position defects in 8 sheep as control group, and 25 mm segmental bone defects of left metatarsus were left empty in 4 sheep as blank group. Sheep were sacrificed on the 6th, 12th, and 24th week postoperatively and the implants samples were examined by radiograph, histology, and biomechanical test. The 4 sheep in blank group were sacrificed on the 24th week postoperatively. The results showed that new bone tissues were observed either radiographic or histologically at the defects of experimental group as early as 6th week postoperatively, but not in control group, and osteoid tissue, woven bone and lamellar bone occurred earlier than in control group in which the bone defects were repaired in "creep substitution" way, because of the new bone formed in direct manner without progression through a cartilaginous intermediate. At the 24th week, radiographs and biomechanical test revealed an almost complete repair of the defect of experimental group, only partly in control group. The bone defects in blank group were non-healing at the 24th week. It was concluded that engineering bones constructed with porous -TCP and autologous MSC were capable of repairing segmental bone defects in sheep metatarsus beyond "creep substitution" way and making it healed earlier. Porous ,-TCP being constituted with autologous MSC may be a good option in healing critical segmental bone defects in clinical practice and provide insight for future clinical repair of segmental defect.

Animals↗
PubMed2004

Relationship between bioceramics sintering and micro-particles-induced cellular damages.

We performed experimental studies to confirm the hypothesis that cellular damages occurring around implanted biphasic bioceramics could be related to a micro-particles release because of an insufficient sintering. First, an in vitro cytotoxicity study was performed on four biphasic ceramic (BCP) samples. Without treatment of the extraction medium, a cytotoxicity was observed, although after centrifugation this cytotoxicity disappeared in all samples. Second, micro-particles of hydroxyapatite (HA), beta-tricalcium phosphate (beta-TCP) and 40% beta-TCP/60%HA mixture were used for a cell inhibition study. A decrease of cell viability was observed with the increase in particles concentration. At 10000 particles per cell, the viability and proliferation were completely inhibited. Third, HA, beta-TCP and BCP ceramic granules were implanted in rabbit femoral cavities for 12 weeks. No degradation of HA granules was observed. The degradation was higher for beta-TCP (40%) than for BCP (5%). On the other hand, new bone formation was significantly higher for beta-TCP (21%) and HA (18%) than for BCP (12%). More micro-particles were formed around BCP granules than around beta-TCP, and phagocytised by macrophages. The release of ceramic micro-particles could be related to the sintering process. BCP ceramic have to be sintered at only 1160 degrees C. Consequently, HA micro-particles of BCP ceramic are incompletely sintered and easily released after immersion or implantation. The microparticles could be at the origin of local inflammation and cell damage and could perhaps modify osteogenesis. Attention must be paid to this problem especially with BCP ceramics because of the sintering difficulties of this bioceramic.

Animals↗
PubMed2002

The biodegradation mechanism of calcium phosphate biomaterials in bone.

This study was undertaken to understand the biodegradation mechanisms of calcium phosphate (Ca-P) biomaterials with different crystallization. Two types of sintered Ca-P porous ceramic (HA and beta-TCP) and a Ca-P bone cement (CPC) were implanted into cavities drilled in rabbit femoral and tibiae condyles. The results have shown that a material biodegradation was rapid in the beta-TCP and the CPC, but very weak in the HA. This biodegradation presented a decrease of material volume from the periphery to the center as well as a particle formation causing phagocytosis by numerous macrophages and multinucleated giant cells in the CPC. In the beta-TCP, there was a peripheral and central decrease of material volume as well as an absence of particle formation or visible phagocytosis. The process of biodegradation is considered to be directly influenced by the type of material crystallization. The sintered bioceramics processed at a high temperature exhibit good crystallization and are primarily degraded by a process dependent on interstitial liquids. However, the bone cement is formed by physicochemical crystallization and is degraded through a dissolution process associated with a cellular process.

Animals↗
PubMed2002

[Cartilage engineering utilizing a porous bioceramic (beta-TCP)-cell complex].

OBJECTIVE: To evaluate the feasibility of growing tissue-engineered cartilage using chondrocytes seeded onto a biodegradable porous bioceramic, the beta-tricalcium phosphate (beta-TCP). METHODS: A porous bioceramic template of beta-TCP was created in the shape of a disc. Chondrocytes isolated from rabbit articular cartilage were seeded on the beta-TCP template and then kept in rotatory cell culture system (RCCS) for 1 week prior to subcutaneous transplantation into athymic mice. The three-dimensional structure was well-maintained 16 weeks after implantation. After 4, 8, 16 weeks, the specimens were harvested and examined macroscopically, histologically and immunohistochemically. RESULTS: Gross morphological and histological analysis of the specimens from the chondrocyte-beta-TCP complex demonstrated new cartilage construction. The overall configuration of the experimental specimens closely resembled the structure of beta-TCP template. CONCLUSION: These findings suggest that porous bioceramic (beta-TCP) is a good "matrix" for chondrocyte, and can be used for cartilage engineering.

Animals↗
PubMed2002

[Retroviral vector-mediated HBsAg expression and its stability].

OBJECTIVE: To explore use of retroviral vector in gene therapy of hepatitis B. METHODS: The recombinant vector Plxsn-HBs was constructed by inserting HBV S gene into pLXSN. The pseudovirus, which was produced from PA317 after transferring with pLXSN-HBs by electroporation, were frozen at different temperature. The activities of the pseudovirus to infect eukaryotic cells and express antigen were determined by comparing the numbers of G418-resistant clones and assaying HBsAg in the supernatant of the cells with ELISA after infection HepG2, NIH3T3 and 293 cells. RESULTS: It was hard to find changes in HBsAg amount at different intervals and different temperatures. G418 resistant clones, however, were variable. When frozen at -20 degrees C, the numbers of clones were half less than that of the beginning after 6 months, few clones were formed after 12 months, and no clone was found after 24 months. When frozen at -40 degrees C, the numbers of clones were 121, 332 and 89 42, 137 and 43 for HepG2, NIH3T3 and 293 cell lines at 12 and 24 months, respectively. When frozen at -70 degrees C, the numbers of clones were 159 463 and 112 for HepG2, NIH3T3 and 293 cell lines at 24 months, respectively. There was no statistical difference compared to that of zero months. CONCLUSIONS: The activity of the peseudovirus to infect eukaryotic cells and expressed antigen was not changed after 2 years frozen at -70 degrees C.

Cell Line↗
PubMedDate not supplied

Repair of large articular cartilage defects with implants of autologous mesenchymal stem cells seeded into beta-tricalcium phosphate in a sheep model.

Tissue engineering has long been investigated to repair articular cartilage defects. Successful reports have usually involved the seeding of autologous chondrocytes into polymers. Problems arise because of the scarcity of cartilage tissue biopsy material, and because the in vitro expansion of chondrocytes is difficult; to some extent, these problems limit the clinical application of this promising method. Bone marrow-derived mesenchymal stem cells (MSCs) have been proved a potential cell source because of their in vitro proliferation ability and multilineage differentiation capacity. However, in vitro differentiation will lead to high cost and always results in decreased cell viability. In this study we seeded culture-expanded autologous MSCs into bioceramic scaffold-beta-tricalcium phosphate (beta-TCP) in an attempt to repair articular cartilage defects (8 mm in diameter and 4 mm in depth) in a sheep model. Twenty-four weeks later, the defects were resurfaced with hyaline-like tissue and an ideal interface between the engineered cartilage, the adjacent normal cartilage, and the underlying bone was observed. From 12 to 24 weeks postimplantation, modification of neocartilage was obvious in the rearrangement of surface cartilage and the increase in glycosaminoglycan level. These findings suggest that it is feasible to repair articular cartilage defects with implants generated by seeding autologous MSCs, without in vitro differentiation, into beta-TCP. This approach provides great potential for clinical applications.

Animals↗
PubMedDate not supplied

Repair of osteochondral defects with autologous chondrocytes seeded onto bioceramic scaffold in sheep.

At present, the most popular biomaterials used in cartilage tissue engineering are synthetic polymers. However, problems-such as acidic by-product accumulation and side effects in local or systemic inflammatory reactions during in vivo degradation-are drawing much attention. The polymers are also highly hydrophobic and degrade within 4 weeks, allowing insufficient time to support neocartilage formation. All these have made polymers less promising in clinical application. In this study, we tested a new bioceramic scaffold made of artificial synthesized powder of beta-tricalcium phosphate (beta-TCP) in a sheep model. Osteochondral defects were filled with a bioceramic-chondrocyte construct and neocartilage tissue completely resurfaced the cartilage defects after 24 weeks. Typical hyaline cartilage structure was generated in the engineered cartilage. Biodegradation of bioceramic was notable, leading to bioceramic fragmentation and particle formation. Numerous ceramic particles (size, 0.5-1.9 microm) and numerous macrophages were observed at the ceramic-tissue interface as well as in the marrow tissue. No macrophages were visible in the neocartilage tissue. Although long-term in vivo study is needed to further determine the pathological sequences of the beta-TCP-based cartilage construct, this study suggests that this bioceramic might be used to repair chondral or osteochondral defects and could be used as a scaffold for cartilage tissue engineering.

Animals↗