PubMed Health⌕ Search

Biomedical subjects

Johannes A Lercher

Publications and source records attributed to Johannes A Lercher.

9 recordsLinked to original sources
PubMed2006

SOx storage materials under Lean-Rich cycling conditions--Part II: influence of Pt, H2O, and cycling time.

The role of Pt and the influence of the reaction conditions during lean-rich cycling experiments were studied on a second generation SOx trapping material. The combination of the Generalized 2-D Correlation Analysis, 2-D Sample-Sample Correlation Analysis, and Factor Analysis using the MCR-ALS technique was applied to identify the reactive species. Transient surface sulfate species were formed under oxidative reaction conditions (lean mode) and decomposed under reducing reaction conditions (rich operation mode). The reduction of this species was identified to be the main contribution to the SO2 release observed under dynamic flow conditions. Pt facilitates the formation of sulfates but also catalyzes the reduction of the transient surface sulfate species leading to a higher amount of SO2 released under rich conditions. In the presence of water, this effect was diminished, which was found to be mainly a result of the suppressed formation of surface sulfate species caused by the faster transport of SO2 into the bulk phase of the SOx trapping component (BaCO3). Increasing the time under reducing conditions in the cycles leads to an enhanced reduction of the surface during rich conditions. The presence of water did not influence the bulk type species. It is proposed that for effective SO2 storage materials, strong SOx adsorption sites on the surface, the presence of water, and a short time under reducing conditions are essential.

Journal Article↗
PubMed2006

SO(x) storage materials under lean-rich cycling conditions. Part I: Identification of transient species.

The SO(x) uptake of second generation sulfur trapping materials was studied by in situ IR spectroscopy under lean-rich cycling conditions. The combination of advanced chemometric methods including generalized 2D correlation analysis, 2D sample-sample correlation analysis, and multivariate curve resolution with alternating least squares allowed the detection of the species involved in the storage process. The formation of the bulk sulfate species was always accompanied by the consumption of carbonates. The reduction of a transient surface sulfate species was identified as the key parameter in the storage process under dynamic conditions. Three distinct reaction regimes were differentiated on the industrial materials under SO(x) trapping conditions being imperceptible from conventional spectra.

Journal Article↗
PubMed2006

Markownikoff and anti-Markownikoff hydroamination with palladium catalysts immobilized in thin films of silica supported ionic liquids.

The concept of immobilising organometallic complexes in a thin film of supported ionic liquids was utilised to synthesise novel bi-functional catalysts combining soft Lewis acidic and strong Brønsted acidic functions; the materials showed exceptional catalytic activity for the addition of aniline to styrene, providing the Markownikoff product under kinetically controlled conditions and mainly the anti-Markownikoff product in the thermodynamic regime.

Journal Article↗
PubMed2006

Spectroscopic characterization of cobalt-containing mesoporous materials.

Cobalt-containing mesoporous materials that have been prepared using different procedures have been comparatively characterized by transmission electron microscopy/energy-dispersive X-ray spectroscopy (TEM/EDS), extended X-ray absorption fine structure spectroscopy (EXAFS), X-ray absorption near edge spectroscopy (XANES), and ultraviolet-visible (UV-vis), near-infrared (NIR), and mid-infrared (mid-IR) spectroscopies, and the results provide new insights into the local environment and properties of cobalt in this type of material. TEM/EDS analyses have shown that tetraethyl orthosilicate (TEOS) may be less appropriate as a silicon source during the syntheses of cobalt-containing mesoporous materials, because the distribution of cobalt throughout the framework may become uneven. EXAFS has been determined to be the most suitable method for direct verification of framework incorporation, by identifying silicon as the backscatterer in the second shell. Such a direct verification may not be obtained using UV-vis spectroscopy. From EXAFS analyses, it is also possible to distinguish between surface-bound and framework-incorporated cobalt. There is a good agreement between the results obtained from XANES and UV-vis regarding the coordination symmetry of cobalt in the samples. The presence of cobalt in the silica framework has been determined to create Lewis acid sites, and these acid sites are suggested to be located at tetrahedral cobalt sites at the surface.

Journal Article↗
PubMed2006

On the trapping of SOx on CaO-Al2O3-based novel high capacity sorbents.

Calcium-aluminum mixed oxide based materials doped with Na and Mn were explored as sulfur trapping materials. The materials showed a three times higher total storage capacity and a higher time on stream with complete SO2 removal compared to a second generation SOx trapping material which was mesoporous with calcium mainly present in oxidic form. Combining in situ XANES at the S K-edge and IR spectroscopy the key properties of the storage materials and the affiliated storage processes were identified. CaO-Al2O3 acts as the primary support and storage component, while Na+ cations adjust the base strength and enhances the storage capacity. Manganese cations provide the appropriate oxidation capacity in absence and presence of up to 10% water. The transport into the bulk phase, which is markedly influenced by a layer of sorbed water, is the rate-limiting step in presence of Mn cations. In the absence of manganese cations the oxidation step appears controlling the rate. The overall reaction network, identified by in situ IR spectroscopy and the 2D Correlation Analysis, is similar on all materials.

Journal Article↗
PubMed2005

In situ S K-edge X-ray absorption spectroscopy for understanding and developing SOx storage catalysts.

In situ S K-edge XANES experiments were carried out on second-generation SO(x)() trapping materials under oxidizing and reducing conditions. The experiments clearly show that the strong release of SO(2) under rich conditions at plug flow conditions is caused by the facilitated reduction of sulfite species on Pt. In the absence of Pt the sulfite species were stable under reducing conditions, while maintaining a similar total SO(2) uptake capacity. Thus, SO(x)() trapping materials without a noble metal are a clearly better option. The enhancing effect on the SO(x)() storage process of water present in the gas mixture is attributed to the formation of a higher sulfate fraction in the samples. The application of the in situ S K-edge XANES technique clearly reveals new information and insights on the behavior of the sulfur in the trapping process compared to that from the ex situ measurements and is therefore essential for designing new SO(x)() trapping materials.

Journal Article↗
PubMed2005

Oxidative activation of n-butane on sulfated zirconia.

Catalytic activation and conversion of light alkanes by sulfated zirconia is unequivocally shown to be initiated by producing small concentrations of olefins. This occurs via stoichiometric oxidative dehydrogenation of butane by SO3 or pyrosulfate groups to butene (present mostly as alkoxy groups), water, and SO2. Thermal desorption and in situ IR spectroscopy have been used to determine all three reaction products. The concentration of butene formed determines both the catalytic activity of sulfated zirconia as well as the deactivation via formation of oligomers. The thermodynamics of the oxidative dehydrogenation of n-butane by different SZ surface structures has been examined by density functional (DFT) calculations. The calculations show that pyrosulfate or re-adsorbed SO3 species have the highest oxidizing ability.

Journal Article↗
PubMed2002

Continuous hydroamination in a liquid-liquid two-phase system.

The direct addition of NH across a CC multiple bond (hydroamination) was efficiently catalysed in a liquid-liquid two-phase system. The latter comprised a polar catalyst phase of Zn(CF3SO3)2 in the ionic liquid 1-ethyl-3-methylimidazolium trifuoromethanesulfonate and a substrate mixture in heptane. The possibility of catalysing different hydroamination reactions continuously was demonstrated.

Amines↗