Biomedical subjects

Jon-Paul S Powers

Publications and source records attributed to Jon-Paul S Powers.

5 recordsLinked to original sources

PubMed2006

The antimicrobial peptide polyphemusin localizes to the cytoplasm of Escherichia coli following treatment.

The horseshoe crab peptide polyphemusin I possesses high antimicrobial activity, but its mechanism of action is as yet not well defined. Using a biotin-labeled polyphemusin I analogue and confocal fluorescence microscopy, we showed that the peptide accumulates in the cytoplasm of wild-type Escherichia coli within 30 min after addition without causing substantial membrane damage.

Amino Acid Sequence↗

PubMed2005

Solution structure and interaction of the antimicrobial polyphemusins with lipid membranes.

The horseshoe crab cationic antimicrobial peptide polyphemusin I is highly active in vitro but not protective in mouse models of bacterial and LPS challenge, while a synthetic polyphemusin variant, PV5, was previously shown to be protective in vivo. In this study, we investigated the interaction of these peptides with lipid membranes in an effort to propose a mechanism of interaction. The solution structure of PV5 was determined by proton NMR in the absence and presence of dodecylphosphocholine (DPC) micelles. Like polyphemusin I, PV5 is a beta-hairpin but appeared less amphipathic in solution. Upon association with DPC micelles, PV5 underwent side chain rearrangements which resulted in an increased amphipathic conformation. Using fluorescence spectroscopy, both peptides were found to have limited affinity for neutral vesicles composed of phosphatidylcholine (PC). Incorporation of 25 mol % cholesterol or phosphatidylethanolamine into PC vesicles produced little change in the partitioning of either peptide. Incorporation of 25 mol % phosphatidylglycerol (PG) into PC vesicles, a simple prokaryotic model, resulted in a large increase in the affinity for both peptides, but the partition coefficient for PV5 was almost twice that of polyphemusin I. Differential scanning calorimetry studies supported the partitioning data and demonstrated that neither peptide interacted readily with neutral PC vesicles. Both peptides showed affinity for negatively charged membranes incorporating PG. The affinity of PV5 was much greater as the pretransition peak was absent at low peptide to lipid ratios (1:400) and the reduction in enthalpy of the main transition was greater than that produced by polyphemusin I. Both peptides decreased the lamellar to inverted hexagonal phase transition temperature of PE indicating the induction of negative curvature strain. These results, combined with previous findings that polyphemusin I promotes lipid flip-flop but does not induce significant vesicle leakage, ruled out the torroidal pore and carpet mechanisms of antimicrobial action for these polyphemusins.

Animals↗

PubMed2004

Structure-activity relationships for the beta-hairpin cationic antimicrobial peptide polyphemusin I.

The solution structure of polyphemusin I was determined using (1)H-NMR spectroscopy. Polyphemusin I was found to be an amphipathic, beta-hairpin connected by a type I' beta-turn. The 17 low-energy structures aligned very well over the beta-sheet region while both termini were poorly defined due in part to a hinge-like region centred in the molecule about arginine residues 6 and 16. Conversely, a linear analogue, PM1-S, with all cysteines simultaneously replaced with serine was found to be dynamic in nature, and a lack of medium and long-range NOEs indicated that this molecule displayed no favoured conformation. Circular dichroism (CD) spectroscopy confirmed that in solution, 50% trifluoroethanol (TFE) and in the presence of liposomes, PM1-S remained unstructured. The antimicrobial activity of PM1-S was found to be 4- to 16-fold less than that of polyphemusin I and corresponded with a 4-fold reduction in bacterial membrane depolarization. Both peptides were able to associate with lipid bilayers in a similar fashion; however, PM1-S was completely unable to translocate model membranes while polyphemusin I retained this activity. It was concluded that the disulfide-constrained, beta-sheet structure of polyphemusin I is required for maximum antimicrobial activity. Disruption of this structure results in reduced antimicrobial activity and completely abolishes membrane translocation indicating that the linear PM1-S acts through a different antimicrobial mechanism.

Amino Acid Substitution↗

PubMed2003

Structure-based design of an indolicidin peptide analogue with increased protease stability.

Indolicidin is an antimicrobial cationic peptide with broad-spectrum activity isolated from bovine neutrophils. An indolicidin analogue CP-11, ILKKWPWWPWRRK-NH(2), with improved activity against Gram-negative bacteria had increased positive charge and amphipathicity while maintaining the short length of the parent molecule. The structure of CP-11 in the presence of dodecylphosphocholine (DPC) micelles was determined using nuclear magnetic resonance spectroscopy. CP-11 was found to be an amphipathic molecule with a U-shaped backbone bringing the N- and C-termini in close proximity. On the basis of this close proximity, a cyclic disulfide-bonded peptide cycloCP-11, ICLKKWPWWPWRRCK-NH(2), was designed to stabilize the lipid-bound structure and to increase protease resistance. The three-dimensional structure of cycloCP-11 was determined under the same conditions as for the linear peptide and was found to be similar to CP-11. Both CP-11 and cycloCP-11 associated with phospholipid membranes in a similar manner as indicated by circular dichroism and fluorescence spectra. The minimal inhibitory concentrations of CP-11 and cycloCP-11 for a range of bacteria differed by no more than 2-fold, and they were nonhemolytic at concentrations up to 256 microg/mL. Cyclization was found to greatly increase protease stability. The half-life of cycloCP-11 in the presence of trypsin was increased by 4.5-fold from 4 to 18 min. More importantly, the antibacterial activity of cycloCP-11, but not that of CP-11, in the presence of trypsin was completely retained up to 90 min since the major degradation product was equally active. A structural comparison of CP-11 and cycloCP-11 revealed that the higher trypsin resistance of cycloCP-11 may be due to the more compact packing of lysine and tryptophan side chains. These findings suggest that cyclization may serve as an important strategy in the rational design of antimicrobial peptides.

Amino Acid Sequence↗

PubMed2003

The relationship between peptide structure and antibacterial activity.

Cationic antimicrobial peptides are a class of small, positively charged peptides known for their broad-spectrum antimicrobial activity. These peptides have also been shown to possess anti-viral and anti-cancer activity and, most recently, the ability to modulate the innate immune response. To date, a large number of antimicrobial peptides have been chemically characterized, however, few high-resolution structures are available. Structure-activity studies of these peptides reveal two main requirements for antimicrobial activity, (1) a cationic charge and (2) an induced amphipathic conformation. In addition to peptide conformation, the role of membrane lipid composition, specifically non-bilayer lipids, on peptide activity will also be discussed.

Animals↗