Biomedical subjects
Publications and source records attributed to Julie V Macpherson.
Polyaniline (PANI)/Pt nanoparticle composites can be prepared by the spontaneous redox reaction of K2PtCl4 with PANI, to yield thin films that show electrocatalytic properties in both acidic and neutral aqueous media.
The surface processes involved in the initial stages of the proton-assisted dissolution of the calcite single crystal cleavage plane (1014) have been identified using a combined scanning electro-chemical-atomic force microscope (SECM-AFM). This instrument employs a platinum-coated AFM probe, which functions as an electrode as well as a high-resolution topographical sensor. Dissolution in this arrangement is effected by the local electrogeneration of protons, produced by oxidation of water at the probe electrode. By careful control of the applied potential, it is possible to vary the magnitude of the electrogenerated flux of protons from the probe towards the calcite surface. Crucially, by generating a small proton flux for short time periods (0.5 s) it is possible to observe and monitor the initial sites in the dissolution process. Topographical images were recorded in the same area of the surface both prior to and after inducing dissolution, as a function of the proton flux. At low proton fluxes, of the order of 1 nmol cm-2s-1 or less, the surface was observed to dissolve by the nucleation of monolayer deep pits, with densities of about 10(8) cm-2. These pits are likely to be formed at point vacancies or atomic (impurity, for example) defects in the crystal lattice. As the proton flux was increased (over two orders of magnitude), these same etch pits were found to open into wider macro-pits, with an outline morphology that reflected the crystallographic orientation of the surface. At the highest proton fluxes, dissolution from macroscopic step edges became significant.
Explore the source record for details and available documents.
A combined scanning electrochemical-atomic force microscope (SECM-AFM) has been used to probe the diffusional transport of target electroactive solutes in isolated nanopores of a track-etched membrane. A polycarbonate membrane (100-nm-diam pore size) hydrated with an electrolyte solution, containing a redox-active probe molecule, such as IrCl6(3-) or Fe(phen)3(2+), functions as the model membrane system. The use of a mobile Pt-coated AFM probe enables individual solution-filled pores to be topographically identified. Analysis of the corresponding current images for the diffusion-limited oxidation of the redox mediator indicates that solution is largely confined to pores in the membrane. Moreover, the tip collector current response provides information on diffusion of the mediator through the pore. Force-distance tip approach and retract measurements allow the radius of contact between the electrochemical-AFM tip and solution confined within a pore at the point of pull-off to be estimated.