Biomedical subjects

L E Freed

Publications and source records attributed to L E Freed.

11 recordsLinked to original sources

PubMed1997

Microgravity tissue engineering.

Tissue engineering studies were done using isolated cells, three-dimensional polymer scaffolds, and rotating bioreactors operated under conditions of simulated microgravity. In particular, vessel rotation speed was adjusted such that 10 mm diameter x 2 mm thick cell-polymer constructs were cultivated in a state of continuous free-fall. Feasibility was demonstrated for two different cell types: cartilage and heart. Conditions of simulated microgravity promoted the formation of cartilaginous constructs consisting of round cells, collagen and glycosaminoglycan (GAG), and cardiac tissue constructs consisting of elongated cells that contracted spontaneously and synchronously. Potential advantages of using a simulated microgravity environment for tissue engineering were demonstrated by comparing the compositions of cartilaginous constructs grown under four different in vitro culture conditions: simulated microgravity in rotating bioreactors, solid body rotation in rotating bioreactors, turbulent mixing in spinner flasks, and orbital mixing in petri dishes. Constructs grown in simulated microgravity contained the highest fractions of total regenerated tissue (as a percent of construct dry weight) and of GAG, the component required for cartilage to withstand compressive force.

Animals↗

PubMed1994

Joint resurfacing using allograft chondrocytes and synthetic biodegradable polymer scaffolds.

Cartilage implants which could potentially be used to resurface damaged joints were created using rabbit articular chondrocytes and synthetic, biodegradable polymer scaffolds. Cells were serially passaged and then cultured in vitro on fibrous polyglycolic acid (PGA) scaffolds. Cell-PGA constructs were implanted in vivo as allografts to repair 3-mm diameter, full thickness defects in the knee joints of adult rabbits, and cartilage repair was assessed histologically over 6 months. In vitro, chondrocytes proliferated on PGA and regenerated cartilaginous matrix. Collagen and glycosaminoglycan (GAG) represented 20 to 8% of the implant dry weight (dw), respectively, at the time of in vivo implantation; the remainder was PGA and unspecified components. Implants based on passaged chondrocytes had 1.7-times as much GAG and 2.6-times as much collagen as those based on primary chondrocytes. In vivo, cartilaginous repair tissue was observed after implantation of PGA both with and without cultured chondrocytes. Six month repair was qualitatively better for cell-PGA allografts than for PGA alone, with respect to: 1) surface smoothness, 2) columnar alignment of chondrocytes, 3) spatially uniform GAG distribution, 4) reconstitution of the subchondral plate, and 5) bonding of the repair tissue to the underlying bone. These pilot studies demonstrate that it is feasible to use cell-polymer allografts for joint resurfacing in vivo.

Animals↗

PubMed1994

Wetting of poly(L-lactic acid) and poly(DL-lactic-co-glycolic acid) foams for tissue culture.

Biodegradable foams of hydrophobic polymers can be efficiently wet by two-step immersion in ethanol and water, which overcomes the hindered entry of water into air-filled pores. Ethanol readily enters into the porous polymer, after which it is diluted and replaced by water. This method was evaluated for porous disks of poly(L-lactic acid) (PLLA) and poly(DL-lactic-co-glycolic acid) (PLGA) foams of copolymer ratios 85:15 and 50:50. For PLLA disks of 0.88 porosity and 1730 microns thickness, prewetting with ethanol for 1 h increased the percentage of void volume filled with water after 48 h from 23 to 79%. The same enhanced entry of water was also observed for prewet PLGA 85:15 disks of 0.86 porosity and 1300 microns thickness, which exhibited an increase from 59 to 97% void volume occupied by water. Furthermore, the water entry even after 1 h was very close to its plateau value for all prewet polymers tested. In recent studies, this method has been useful in uniformly seeding three-dimensional biodegradable polymer substrates for cell and tissue culture.

Culture Techniques↗

PubMed1994

Biodegradable polymer scaffolds for tissue engineering.

Synthetic polymer scaffolds designed for cell transplantation were reproducibly made on a large scale and studied with respect to biocompatibility, structure and biodegradation rate. Polyglycolic acid (PGA) was extruded and oriented to form 13 microns diameter fibers with desired tenacity. Textile processing techniques were used to produce fibrous scaffolds with a porosity of 97% and sufficient structural integrity to maintain their dimensions when seeded with isolated cartilage cells (chondrocytes) and cultured in vitro at 37 degrees C for 8 weeks. Cartilaginous tissue consisting of glycosaminoglycan and collagen was regenerated in the shape of the original PGA scaffold. The resulting cell-polymer constructs were the largest grown in vitro to date (1 cm diameter x 0.35 cm thick). Construct mass was accurately predicted by accounting for accumulation of tissue components and scaffold degradation. The scaffold induced chondrocyte differentiation with respect to morphology and phenotype and represents a model cell culture substrate that may be useful for a variety of tissue engineering applications.

Biocompatible Materials↗

PubMed1993

Neocartilage formation in vitro and in vivo using cells cultured on synthetic biodegradable polymers.

Cartilaginous implants for potential use in reconstructive or orthopedic surgery were created using chondrocytes grown on synthetic, biodegradable polymer scaffolds. Chondrocytes isolated from bovine or human articular or costal cartilage were cultured on fibrous polyglycolic acid (PGA) and porous poly(L)lactic acid (PLLA) and used in parallel in vitro and in vivo studies. Samples were taken at timed intervals for assessment of cell number and cartilage matrix (sulfated glycosaminoglycan [S-GAG], collagen). The chondrocytes secreted cartilage matrix to fill the void spaces in the polymer scaffolds that were simultaneously biodegrading. In vitro, chondrocytes grown on PGA for 6 weeks reached a cell density of 5.2 x 10(7) cells/g, which was 8.3-fold higher than at day 1, and equalled the cellularity of normal bovine articular cartilage. In vitro, the cell growth rate was approximately twice as high on PGA as it was on PLLA; cells grown on PGA produced S-GAG at a high steady rate, while cells grown on PLLA produced only minimal amounts of S-GAG. These differences could be attributed to polymer geometry and biodegradation rate. In vivo, chondrocytes grown on both PGA and PLLA for 1-6 months maintained the three-dimensional (3-D) shapes of the original polymer scaffolds, appeared glistening white macroscopically, contained S-GAG and type II collagen, and closely resembled cartilage histologically. These studies demonstrate the feasibility of culturing isolated chondrocytes on biodegradable polymer scaffolds to regenerate 3-D neocartilage.

Animals↗

PubMed1993

Cultivation of cell-polymer cartilage implants in bioreactors.

Cartilage implants for potential use in reconstructive or orthopedic surgery can be created by growing isolated cartilage cells (chondrocytes) in vitro on synthetic, biodegradable polymer scaffolds. The scaffolds provide specific three-dimensional structures which support cell proliferation and biodegrade in a controlled fashion in parallel to cellular regeneration of cartilaginous tissue. Cartilage implants based on chondrocytes and fibrous polyglycolic acid scaffolds were recently shown to closely resemble normal cartilage histologically as well as with respect to cell density and matrix composition (collagen, glycosaminoglycan) [Freed et al., J Biomed Mater Res 27:11-23, 1993a]. These findings form the basis for developing straightforward procedures to obtain implants for clinical use from small, autologous cartilage specimens without any limitations in terms of availability of donor tissue or implant dimensions. Chondrocyte growth and cartilage matrix regeneration on polymer scaffolds are interdependent and also depend on in vitro tissue culture conditions. Under static culture conditions, cell growth rates are diffusionally limited due to increasing cell mass and decreasing effective implant porosity resulting from cartilage matrix regeneration. Optimization of the in vitro culture environment is thus essential for the cultivation of large, clinically useful cartilage implants. Preliminary studies indicate that major improvements can be achieved using bioreactors that provide efficient mass transfer and controlled shear rates at the cell and implant surfaces.

Biotechnology↗

PubMed1993

Bioreactor based on suspended particles of immobilized enzyme.

A bioreactor for blood detoxification was developed in which oscillation-induced secondary flows suspend particles of immobilized enzyme in a reactor operating at clinically useful flowrates. Torsional oscillation of the reactor about its axis created a pair of counterrotating toroidal vortices which were readily observed in flow-visualization studies. Oscillation frequencies were selected to provide spatially uniform particle dispersion, as assessed visually. As a model system, blood deheparinization by reactors containing heparinase immobilized to agarose particles was investigated. Identical deheparinization profiles were observed in the continuous-flow reactor and in independent batch studies, done in well mixed test tubes of blood, demonstrating that the oscillating reactor design minimizes external mass transfer limitations. Identical heparin neutralization profiles and rates were also observed in the first and the second of consecutive heparin neutralization studies (0-2 h and 2-4 h, respectively) demonstrating an effective half-life of the immobilized enzyme in the oscillating reactor of at least 4 h. No significant decrease in red or white blood cell count, platelet count, or hematocrit, and clinically acceptable levels of plasma hemoglobin and activated complement were observed with 2 h (20 passes) of in vitro recirculation of human blood through the reactor. High, stable efficacy, operational stability, and excellent biocompatibility are attributed to secondary flow induced liquid-particle mixing within the oscillating reactor.

Biocompatible Materials↗

PubMed1993

Kinetics of immobilized heparinase in human blood.

Immobilized enzyme reactors can form the basis of useful blood detoxification systems. One such reactor was developed for heparin neutralization by immobilized heparinase. In this article, reactor kinetics were studied under clinically relevant conditions. Heparin neutralization was assessed in vitro in whole human blood using (a) a well-mixed batch reactor, and (b) an oscillating, continuous-flow reactor. The kinetics of heparin neutralization in human blood were first order over the entire range of heparin and enzyme concentrations and particle fractions tested. The kinetic rate was not sensitive to physiological variations in the concentration of antithrombin, a heparin binding protein in blood. Enzyme activity did not decrease significantly over the 2 hour test period. Kinetic control of the system with minimal intraparticle diffusional limitations was suggested by the Thiele moduli (0.11-0.67) and effectiveness factors (0.98 +/- 0.01). The ratio kcat/Km obtained in batch studies was 0.0028 +/- 0.0008 cm3/microgram-min. A continuous-flow oscillating reactor within a closed recirculation loop performed as a single well mixed batch reactor; there was a short mixing time of recirculating blood when compared to reaction time. A model based on this mixing pattern and the kinetics obtained in independent batch studies accurately predicted heparin neutralization profiles observed in the continuous-flow system.

Antithrombins↗

PubMed1988

Lipogenesis from ketone bodies in perfused livers from streptozocin-induced diabetic rats.

Production of ketone bodies and their contribution to lipogenesis were measured in isolated livers from normal and streptozocin-induced diabetic (STZ-D) rats perfused with tracer amounts of 3H2O and (R)-3-hydroxy[3-14C]butyrate. Diabetes decreased by 80-95% the total rates of fatty acid and 3-beta-hydroxysterol synthesis in perfused livers and livers of live rats. The activity of cytosolic acetoacetyl-CoA synthetase was slightly (17%) decreased in livers from STZ-D rats. The incorporation of ketone bodies into fatty acids and sterols was markedly inhibited in perfused livers from STZ-D rats despite the stimulation of ketogenesis by diabetes and the presence of oleate. Treatment of the rats with insulin before liver perfusion led to a normalization of the rates of ketogenesis and fatty acid synthesis. The rates of sterol synthesis were only partially normalized by insulin treatment. We conclude that in STZ-D, ketosis does not stimulate hepatic lipogenesis via cytosolic activation of acetoacetate.

3-Hydroxybutyric Acid↗

PubMed1982

Metabolism of plasma mevalonate in rats and humans.

A circadian rhythm in plasma mevalonate was identified in human subjects. This variation, over a 5-fold range, is paralleled by a rhythm in urinary excretion. No such diurnal change in plasma mevalonate was observed in schedule-fed, light-cycled rats, despite the presence of a pronounced rhythm in liver HMG-Coa reductase and sterol synthesis. A linear correlation was found between liver HMG-CoA reductase activity and the rate of hepatic sterol synthesis. Sterol synthesis accounted for 59% of the HMG-CoA reductase activity. A 4-fold increase in plasma mevalonate following bilateral nephrectomy did not feed back on liver HMG-CoA reductase. Turnover rates for circulating R- and S-mevalonate were determined by the kinetics of tritiated tracers. S-Mevalonate exhibited first-order kinetics with a T 1/2 of 19 to 23 min, while R-mevalonate kinetics could be resolved into two phases with half-lives of 9 and 42 min. The renal uptake of circulating mevalonate was measured by the initial rate of increase in plasma mevalonate immediately following bilateral nephrectomy; this was confirmed by determination of the renal arterio-venous difference. This value ranges between 500 and 600 pmol/min for a 250-g rat.

Adult↗

PubMedDate not supplied

A novel bioreactor based on suspended particles of agarose-immobilized species.

Bioreactors often contain porous particles of agarose because these provide an enormous surface area (50 m2/cc gel) onto which enzymes or antibodies can be immobilized. Although many investigators claim that contact with agarose induces significant blood damage, we find that the biocompatibility of immobilized agarose is significantly improved when a novel system is used to fluidize the particles within the bioreactor vessel. We have built a prototype device that is oscillated vigorously about the axis of fluid flow. This action produces secondary flow patterns within the vessel that suspend the particles. In our model system, the bioreactor contains agarose immobilized heparinase. The system is biocompatible for 2 hours in vitro (in human blood at 37 degrees C) as follows: 1) hematocrit, white cell, and platelet counts do not change, 2) levels of plasma hemoglobin increase to 15-34 mg/dl, and 3) levels of complement component C3a increase to 0.64-1.4 micrograms/cc. We hope these studies lead to the development of a heparin removal system that can improve the safety of a variety of extracorporeal procedures. In addition, the techniques and approach used are sufficiently general to permit their extension to any immobilized species bioreactor for blood detoxification.

Biocompatible Materials↗