Biomedical subjects

M J Hilhorst

Publications and source records attributed to M J Hilhorst.

7 recordsLinked to original sources

PubMed2006

High throughput therapeutic drug monitoring of clozapine and metabolites in serum by on-line coupling of solid phase extraction with liquid chromatography-mass spectrometry.

The characteristics of automated on-line solid phase extraction with liquid chromatography-mass spectrometry (SPE-LC-MS) are very amenable for flexibility and throughput in therapeutic drug monitoring (TDM). We demonstrate this concept of automated, on-line SPE-LC-MS for the analysis of clozapine and metabolites (desmethylclozapine and clozapine-N-oxide) in serum. Method development, optimisation and validation are described and a comparison with previously published methods for the determination of clozapine and metabolites in serum and plasma is made. Optimisation of chromatographic and SPE conditions for increased throughput resulted in SPE-LC-MS cycle times of only about 2.2 min, demonstrating the great potential of automated on-line SPE-LC-MS for TDM. The new method is shown to be clearly favourable, in particular in terms of ease of sample handling, throughput and detection limits. Recovery is essentially quantitative. Detection limits are at about 0.15-0.3 ng ml(-1), depending on the ionisation source used. Calibration follows a quadratic model for clozapine and its N-oxide and a linear model for the desmethyl metabolite (all cases: R > 0.99). Accuracy, evaluated at three concentration levels spanning the whole therapeutic range, shows that bias is less than 10%. Precision (intra - and inter assay) ranges from about 5% R.S.D. at the high end of the therapeutic range (700-1,000 ng ml(-1)) to about 20% R.S.D. (OECD defined limit) at the lower limit of quantitation ( approximately 50 ng ml(-1)). The lower limit of quantitation is well below the low end of the therapeutic range at 350 ng ml(-1).

Antipsychotic Agents↗

PubMed2001

Towards a general approach for the impurity profiling of drugs by micellar electrokinetic chromatography.

A general micellar electrokinetic chromatographic (MEKC) strategy for the impurity profiling of drugs was developed involving a sodium dodecyl sulfate (SDS) and a cetyltrimethylammonium bromide (CTAB) MEKC system. With this combination, in principle, each sample component passes the detector in at least one of the two MEKC systems provided that separation buffers of the same pH are used in both systems. In order to select the proper MEKC systems, the electroosmotic flow (EOF) and micelle migration time (t(mc)) were determined for separation buffers of several pH values, containing various amounts of surfactant and organic modifier. The selectivity of the MEKC systems was studied using a mixture of compounds with a wide range of physico-chemical properties. The final selection of two adequate MEKC systems for this approach was based on the requirements that the t(mc) (i.e., analysis time) of both systems was below 20 min and that the t(mc)/t(eof) ratio was above 3 or 2 for the SDS and CTAB system, respectively. Furthermore, the systems should provide high efficiency, exhibit differences in selectivity and use moderate concentrations of modifier and surfactant, so that, if needed, further optimization is possible. The selected MEKC systems contained 60 mM SDS or 10 mM CTAB, respectively, in a phosphate buffer (pH 7.5) with 10% acetonitrile. Some test compounds with extreme mobilities were used to demonstrate the suitability of the MEKC approach to detect each component of a sample. The potential of the proposed MEKC combination for impurity profiling was demonstrated by the analysis of fluvoxamine with several impurities at the 0.1% level.

Chromatography↗

PubMed2001

Capillary electrokinetic separation techniques for profiling of drugs and related products.

Capillary electrokinetic separation techniques offer high efficiency and peak capacity, and can be very useful for the analysis of samples containing a large variety of (unknown) compounds. Such samples are frequently met in impurity profiling of drugs (detection of potential impurities in a pharmaceutical substance or product) and in general sample profiling (determination of differences or similarities between samples). In this paper, the potential, merits, and limitations of electrokinetic separation techniques for profiling purposes are evaluated using examples from literature. A distinction is made between impurity profiling, forensic profiling and profiling of natural products, and the application of capillary zone electrophoresis, micellar electrokinetic chromatography, and capillary electrochromatography in these fields is discussed. Attention is devoted to important aspects such as selectivity, resolution enhancement, applicability, detection, and compound confirmation and quantification. The specific properties of the various electrokinetic techniques are discussed and compared with more conventional techniques as liquid chromatography.

Cations↗

PubMed2000

Capillary electrochromatography of basic compounds using octadecyl-silica stationary phases with an amine-containing mobile phase.

The capillary electrochromatographic (CEC) analysis of basic compounds on octadecyl-silica stationary phases (Hypersil ODS and Spherisorb ODS I) was studied. A basic drug (fluvoxamine) and one of its possible impurities were used as test compounds. With an eluent of acetonitrile-phosphate buffer (pH 7.0), the compounds could be baseline-separated; however, broad and tailing peaks were obtained. To minimise detrimental interactions with residual silanol groups, the pH of the mobile phase was lowered to 2.5, but the plate numbers were still quite low (<2.6x10(4) plates/m). Addition of a masking agent (hexylamine or triethylamine) to the mobile phase resulted in much better peak efficiencies (ca. 1x10(5) plates/m). Therefore, the influence of the amine concentration and pH of the mobile phase on the CEC performance (peak width, peak tailing, electroosmotic flow, selectivity) was investigated in detail. Highest efficiencies (2.8x10(5) plates/m) could be obtained with the Spherisorb column, while the Hypersil column offered a better selectivity. Furthermore, the results show that the residual silanol groups are (at least partly) responsible for the separation of the basic compounds and that the amount of injected sample has an unusually large effect on the peak efficiency. The usefulness of the system for impurity profiling was demonstrated with a mixture containing fluvoxamine and its stereoisomer (a possible impurity) at the 0.1% level. The general effectiveness of amine additives in CEC was illustrated by the separation of a mixture of five structurally different basic drugs yielding plate numbers in the 1x10(5)-3x10(5) plates/m range. Comparison with capillary electrophoretic analysis revealed a unique selectivity of the CEC system which is based on both electrophoretic mobility and chromatographic partitioning.

Amines↗

PubMed2000

Resolution optimisation in micellar electrokinetic chromatography using empirical models.

Theoretical and empirical models can be used to model the migration or separation characteristics in micellar electrokinetic chromatography in order to optimise the resolution. In this paper only empirical models were used, because it is easier and more straightforward to obtain these models. Several empirical approaches for the optimisation of the resolution were compared in order to determine which response should be modelled preferably. The use of models of the effective mobility in combination with average plate numbers proved to be the most suitable approach to optimisation of the resolution, because the relative prediction errors of the models of the effective mobility were a factor of 2-4 smaller than the relative prediction errors of the models of the apparent mobility. Moreover for the least separated peak pair the resolutions based on the models of the apparent and effective mobility showed relative prediction errors that were approximately a factor of 2 smaller than the relative prediction errors of the resolutions based on the models of the resolution and separation factor. The predictions of the separation factor based on the different models generally showed lower prediction errors than the predictions of the corresponding resolutions. Although the relative prediction errors were large, particularly for closely migrating compounds, the empirical approach will probably lead to the optimum separation buffer composition.

Chromatography, Micellar Electrokinetic Capillary↗

PubMed1998

Choice of capillary electrophoresis systems for the impurity profiling of drugs.

In order to develop a strategy for the impurity profiling of drugs, the possibilities of some capillary electrophoresis systems were investigated. A mixture containing a drug and some of its possible impurities has been used as a model problem. The test compounds were investigated by capillary zone electrophoresis (CZE) and by micellar electrokinetic chromatography (MEKC). The pH of the CZE buffer was varied, but the two stereoisomers could not be separated. Moreover, CZE is not suitable for neutral compounds. In MEKC, two different types of surfactants, sodium dodecyl sulphate (SDS) and cetyltrimethylammonium bromide (CTAB), have been used and the effect of type and concentration modifier on the separation and the elution window was studied. In the SDS system, both the resolution and the elution window could be increased considerably by the addition of modifier. The use of two MEKC systems of different selectivity seems to be a combination with high potential for the impurity profiling of drugs.

Cetrimonium↗

PubMedDate not supplied

Profiling of cocaine by micellar electrokinetic chromatography.

The potential of micellar electrokinetic chromatography (MEKC) for the profiling of cocaine samples is described. An MEKC system containing sodium dodecyl sulfate (SDS) and methanol was optimized using a test mixture of cocaine, its common impurities (benzoylecgonine, norcocaine, tropacocaine, and trans-cinnamoylcocaine), and several degradation products. The effect of pH, percentage modifier, and concentration surfactant on the separation has been investigated. The optimal separation buffer for cocaine samples consisted of 75 mM SDS, 17.5% methanol, and 25 mM borate (pH 8.3) and was well suited to separate components of diverse polarity in one run. Various cocaine seizures have been analyzed with the MEKC system and their signatures were compared. The electrokinetic chromatograms obtained were characteristic, and differences and similarities among the samples could easily be observed. Several impurities were identified in the samples by means of migration times and comparison of recorded and library UV spectra. The composition of the samples was determined semiquantitatively using relative corrected peak areas.

Chromatography, Micellar Electrokinetic Capillary↗