Biomedical subjects

Matthew Libera

Publications and source records attributed to Matthew Libera.

4 recordsLinked to original sources

PubMed2006

Selective protein adsorption on a phase-separated solvent-cast polymer blend.

Polymer-based biomedical devices are growing increasingly sophisticated as compositions evolve toward copolymers and blends in order to satisfy complex design criteria. Such polymers afford opportunities for both micro- and macrophase separation at nano- and micro-length scales and raise questions concerning the role of heterogeneous surface morphology on protein adsorption. Adsorbed protein layers play a critical role in mediating the interaction of cells with polymer surfaces, and both understanding and controlling protein adsorption is assuming greater significance in the development of surfaces with enhanced physiological compatibility. Here we study the short-time adsorption of ferritin, a model protein highly resistant to denaturation and easily imaged in the transmission electron microscope (TEM), onto a phase-separated homopolymer blend of polycaprolactone (PCL) and a polycarbonate derived from desaminotyrosyl-tyrosine dodecyl ester (PDTD). At physiological pH, ferritin selectively adsorbs onto the PDTD phase at a surface density approximately three times greater than that on the PCL phase. By decreasing the pH below ferritin's isoelectric point so its average charge becomes positive, the selective adsorption disappears and the surface density of adsorbed ferritin becomes independent of the phase separation. We attribute the selectivity to the electrostatic repulsion between ferritin and hydrolytically charged PCL, both of which will have a net negative charge at physiological pH. To perform these experiments, we solvent-cast ultrathin polymer films onto dissolvable salt substrates, and we characterize the morphology by TEM imaging and quantitative spatially resolved electron energy-loss spectroscopy (EELS). We find that the film morphology depends strongly on such processing-related variables as the solvent evaporation rate and the nature of the surface in contact with the polymer film during casting. The adsorption of ferritin depends on whether the film is phase-separated as well as to which surface of the film the protein solution is exposed, and these findings suggest that seemingly small variations in polymer processing that influence both the bulk and surface morphology can have a profound effect on the short-time protein adsorption.

Adsorption↗

PubMed2006

Diffuse polymer interfaces in lobed nanoemulsions preserved in aqueous media.

Using valence electron energy loss spectroscopy (EELS) in the cryo-scanning transmission electron microscopy (STEM), we found that the polymer-polymer interface in two-phase nanocolloids of polydimethyl siloxane (PDMS) and copolymer (methyl acrylate (MA)-methyl methacrylate (MMA)-vinyl acetate (VA)) preserved in water was diffuse despite the fact that equilibrium thermodynamics indicates it should only be on the order of a few nanometers. The diffuse interface is a result of the kinetic trapping of the copolymer within the PDMS phase, and this finding suggests new nonequilibrium pathways to control interfaces during the synthesis of multicomponent polymeric nanostructures.

Dimethylpolysiloxanes↗

PubMed2005

Water mapping in hydrated soft materials.

We present a method based on spatially resolved electron energy-loss spectroscopy in the cryo-STEM to map the spatial distribution of water in frozen-hydrated polymers. The spatial resolution is limited by the dose constraints imposed by radiation damage, and to stay within these constraints, the use of fine electron-probe sizes comes at the cost of reduced counts in the energy-loss spectra. Thus, at the resolution limit, the detection of isolated water-rich pixels or the identification of minor variations in water content across the specimen is complicated because one must distinguish significant fluctuations from noise. Here we develop a criterion with which to guide such a distinction. We characterize the intrinsic noise associated with spectral measurements under given illumination and acquisition conditions. We then use that noise in combination with scatter diagrams to threshold spectrum images and objectively identify statistically significant compositional fluctuations. We illustrate these ideas using a simulated spectrum dataset for a hypothetical blend of hydrophilic and hydrophobic homopolymers. We show that while a direct inspection of the water map may not allow any meaningful conclusions to be drawn, after applying the thresholding approach we can clearly identify the regions of the specimen that are rich in water. We also experimentally study a model blend system comprised of hydrophilic poly(vinyl pyrrolidone) (PVP) dispersed in a hydrophobic matrix of poly(styrene) (PS). By MLS fitting using damaged and undamaged PVP reference spectra, we determine that the critical dose characteristic of dry PVP is approximately 8000 e/nm2 using 200 keV incident electrons. Irradiating frozen-hydrated PVP gives rise to noticeable hydrogen evolution at doses of approximately 1500 e/nm2. To stay within this constraint we use doses of 400 e/nm2 and a pixel spacing in the spectrum imaging of 100 nm. In order to quantitatively map the water, PVP, and PS compositions, we measure their total inelastic scattering cross-sections. Direct inspection of the composition maps reveals the presence of large water-rich domains of the order of approximately 1 microm and the scatter-diagram thresholding approach identifies small water-rich domains one pixel in size.

Frozen Sections↗

PubMed2004

Protein surface patterning using nanoscale PEG hydrogels.

We have used focused electron-beam cross-linking to create nanosized hydrogels and thus present a new method with which to bring the attractive biocompatibility associated with macroscopic hydrogels into the submicron length-scale regime. Using amine-terminated poly(ethylene glycol) thin films on silicon substrates, we generate nanohydrogels with lateral dimensions of order 200 nm which can swell by a factor of at least five, depending on the radiative dose. With the focused electron beam, high-density arrays of such nanohydrogels can be flexibly patterned onto silicon surfaces. Significantly, the amine groups remain functional after e-beam exposure, and we show that they can be used to covalently bind proteins and other molecules. We use bovine serum albumin to amplify the number of amine groups, and we further demonstrate that different proteins can be covalently bound to different hydrogel pads on the same substrate to create multifunctional surfaces useful in emerging bio/proteomic and sensor technologies.

Hydrogels↗