Biomedical subjects

Naomi C Chesler

Publications and source records attributed to Naomi C Chesler.

9 recordsLinked to original sources

PubMed2006

Pulmonary vascular remodeling in isolated mouse lungs: effects on pulsatile pressure-flow relationships.

Chronic hypoxia causes pulmonary vasoconstriction and pulmonary hypertension, which lead to pulmonary vascular remodeling and right ventricular hypertrophy. To determine the effects of hypoxia-induced pulmonary vascular remodeling on pulmonary vascular impedance, which is the right ventricular afterload, we exposed C57BL6 mice to 0 (control), 10 and 15 days of hypobaric hypoxia (n=6, each) and measured pulmonary vascular resistance (PVR) and impedance ex vivo. Chronic hypoxia led to increased pulmonary artery pressures for flow rates between 1 and 5ml/min (P<0.01), and increased PVR, 0-Hz pulmonary vascular impedance and the index of wave reflection (P<0.05) as well as a more negative impedance phase angle for low frequencies (P<0.05). The increases in resistance and 0-Hz impedance correlated with increased muscularization of small arterioles measured with quantitative immunohistochemistry (P<0.01). The increases in wave reflection and decreases in phase angle are likely due to increased proximal artery stiffness. These results confirm that chronic hypoxia causes significant changes in steady and pulsatile pressure-flow relationships in mouse lungs and does so via structural remodeling. They also provide important baseline data for experiments with genetically engineered mice, with which molecular mechanisms of pulmonary vascular remodeling can be investigated.

Animals↗

PubMed2006

Pulmonary vascular resistance and impedance in isolated mouse lungs: effects of pulmonary emboli.

To study pulsatile pressure-flow rate relationships in the intact pulmonary vascular network of mice, we developed a protocol for measuring pulmonary vascular resistance and impedance in isolated, ventilated, and perfused mouse lungs. We used pulmonary emboli to validate the effect of vascular obstruction on resistance and impedance. Main pulmonary artery and left atrial pressures and pulmonary vascular flow rate were measured under steady and pulsatile conditions in the lungs of C57BL/6J mice (n = 6) before and after two infusions with 25 microm-diameter microspheres (one million per infusion). After the first and second embolizations, pulmonary artery pressures increased approximately two-fold and three and a half-fold, respectively, compared to baseline, at a steady flow rate of 1 ml/min (P < 0.05). Pulmonary vascular resistance and 0 Hz impedance also increased after the first and second embolizations for all flow rates tested (P < 0.05). Frequency-dependent features of the pulmonary vascular impedance spectrum were suggestive of shifts in the major pulmonary vascular reflection sites with embolization. Our results demonstrate that pulmonary artery pressure, resistance, and impedance magnitude measured in this isolated lung setup changed in ways consistent with in vivo studies in larger animals and humans and demonstrate the usefulness of the isolated, ventilated, and perfused mouse lung for investigating steady and pulsatile pressure-flow rate relationships.

Animals↗

PubMed2006

A method for dynamic system characterization using hydraulic series resistance.

The pressure required to drive flow through a microfluidic device is an important characteristic of that device. We present a method to measure the flow rate through microfluidic components and systems, including micropumps and microvalves. The measurement platform is composed of two pressure sensors and a glass tube, which provides series resistance. The principle of the measurement is the fluid dynamical equivalent of Ohm's law, which defines the relationship between current, resistance, and voltage that are analogues to flow rate, hydraulic resistance, and pressure drop, respectively. Once the series resistance is known, it is possible to compute the flow rate through a device based on pressure alone. In addition, the dynamic system characteristics of the device-resistance and capacitance-can be computed. The benefits of this method are its simple configuration, capability of measuring flow rate accurately from the more easily measured pressure, and the ability to predict the dynamic response of microfluidic devices.

Microfluidic Analytical Techniques↗

PubMed2006

The mechanobiology of pulmonary vascular remodeling in the congenital absence of eNOS.

Primary pulmonary hypertension is a rare but deadly disease. Lungs extracted from PPH patients are deficient in endothelial nitric oxide synthase (eNOS), making the eNOS-null mouse a potentially useful model of the disease. To better understand the progression of pulmonary vascular remodeling in the congenital absence of eNOS, we induced pulmonary hypertension in eNOS-null mice using hypobaric hypoxia, and then quantified large artery structure and function in contralateral vessels. In particular, to assess structure we quantified diameter, wall thickness, and collagen, elastin and smooth muscle cell content; to quantify function we performed pressure-diameter tests. After remodeling, the pulmonary arteries had increased wall, collagen and elastin thicknesses compared to controls (P<0.05). The remodeled pulmonary arteries also had increased elastic moduli at low and high strains compared to controls (P<0.05). The increases in moduli at low and high strain correlated with increases in elastin and collagen thickness, respectively (P<0.05). These results provide insight into the mechanobiology of pulmonary vascular remodeling in the congenital absence of eNOS, and the coupled nature of these changes.

Animals↗

PubMed2004

Linked mechanical and biological aspects of remodeling in mouse pulmonary arteries with hypoxia-induced hypertension.

Right heart failure due to pulmonary hypertension causes significant morbidity and mortality. To study the linked vascular mechanical and biological changes that are induced by pulmonary hypertension, we mechanically tested isolated left main pulmonary arteries from mice exposed to chronic hypobaric hypoxia and performed histological assays on contralateral vessels. In isolated vessel tests, hypoxic vessels stretched less in response to pressure than controls at all pressure levels. Given the short length and large diameter of the pulmonary artery, the tangent Young's modulus could not be measured; instead, an effective elastic modulus was calculated that increased significantly with hypoxia [(280 kPa (SD 53) and 296 kPa (SD 50) for 10 and 15 days, respectively, vs. 222 kPa (SD 35) for control; P < 0.02)]. Hypoxic vessels also had higher damping coefficients [(0.063 (SD 0.017) and 0.054 (SD 0.014) for 10 and 15 days, respectively, vs. 0.033 (SD 0.016) for control; P < 0.002)], indicating increased energy dissipation. The increased stiffness with hypoxia correlated with an increase in collagen thickness (percent collagen multiplied by wall thickness) as well as the sum of elastin and collagen thicknesses measured histologically in the artery wall. These results highlight the mechanobiological changes in the pulmonary vasculature that occur in response to hypoxia-induced pulmonary hypertension. Furthermore, they demonstrate significant vascular mechanical and biological changes that would increase pulmonary vascular impedance, leading to right heart failure.

Animals↗

PubMed2004

Mechanical properties of rat middle cerebral arteries with and without myogenic tone.

The inner diameter and wall thickness of rat middle cerebral arteries (MCAs) were measured in vitro in both a pressure-induced, myogenically-active state and a drug-induced, passive state to quantify active and passive mechanical behavior. Elasticity parameters from the literature (stiffness derived from an exponential pressure-diameter relationship, beta, and elasticity in response to an increment in pressure, Einc-p) and a novel elasticity parameter in response to smooth muscle cell (SMC) activation, Einc-a, were calculated. beta for all passive MCAs was 9.11 +/- 1.07 but could not be calculated for active vessels. The incremental stiffness increased significantly with pressure in passive vessels; Einc-p (10(6) dynes/cm2) increased from 5.6 +/- 0.5 at 75 mmHg to 14.7 +/- 2.4 at 125 mmHg, (p < 0.05). In active vessels, Einc-p (10(6) dynes/cm2) remained relatively constant (5.5 +/- 2.4 at 75 mmHg and 6.2 +/- 1.0 at 125 mmHg). Einc-a (10(6) dynes/cm2) increased significantly with pressure (from 15.1 +/- 2.3 at 75 mmHg to 49.4 +/- 12.6 at 125 mmHg, p < 0.001), indicating a greater contribution of SMC activity to vessel wall stiffness at higher pressures.

Animals↗

PubMed2004

Measurements of mouse pulmonary artery biomechanics.

BACKGROUND: Robust techniques for characterizing the biomechanical properties of mouse pulmonary arteries will permit exciting gene-level hypotheses regarding pulmonary vascular disease to be tested in genetically engineered animals. In this paper, we present the first measurements of the biomechanical properties of mouse pulmonary arteries. METHOD OF APPROACH: In an isolated vessel perfusion system, transmural pressure, internal diameter and wall thickness were measured during inflation and deflation of mouse pulmonary arteries over low (5-40 mmHg) and high (10-120 mmHg) pressure ranges representing physiological pressures in the pulmonary and systemic circulations, respectively. RESULTS: During inflation, circumferential stress versus strain showed the nonlinear "J"-shape typical of arteries. Hudetz's incremental elastic modulus ranged from 27 +/- 13 kPa (n = 7) during low-pressure inflation to 2,700 +/- 1,700 kPa (n = 9) during high-pressure inflation. The low and high-pressure testing protocols yielded quantitatively indistinguishable stress-strain and modulus-strain results. Histology performed to assess the state of the tissue after mechanical testing showed intact medial and adventitial architecture with some loss of endothelium, suggesting that smooth muscle cell contractile strength could also be measured with these techniques. CONCLUSIONS: The measurement techniques described demonstrate the feasibility of quantifying mouse pulmonary artery biomechanical properties. Stress-strain behavior and incremental modulus values are presented for normal, healthy arteries over a wide pressure range. These techniques will be useful for investigations into biomechanical abnormalities in pulmonary vascular disease.

Animals↗

PubMed2003

Particle deposition in arteries ex vivo: effects of pressure, flow, and waveform.

The goal of this study was to quantify the effect of hemodynamic pressure, flow and waveform perturbations on the deposition of protein-sized particles in porcine carotid arteries ex vivo. An ex vivo perfusion system was used to control the pressure and flow environment for excised arterial tissue. Confocal laser microscopy images revealed that 200 nm particles were deposited intimally and that more spheres were evident along vessels perfused under oscillatory waveform conditions than all others. Under all pressure, flow and waveform conditions, particles were excluded from the media and adventitia of the vessel wall. The steady flow data support the use of Darcy's Law with pressure-dependent hydraulic permeability to model arterial tissue.

Animals↗

PubMed2002

Effects of ischemia and myogenic activity on active and passive mechanical properties of rat cerebral arteries.

Passive (papaverine induced) and active (spontaneous pressure induced) biomechanical properties of ischemic and nonischemic rat middle cerebral arteries (MCAs) were studied under pressurized conditions in vitro. Ischemic (1 h of occlusion), contralateral, and sham-operated control MCAs were isolated from male Wistar rats (n = 22) and pressurized using an arteriograph system that allowed control of transmural pressure (TMP) and measurement of lumen diameter and wall thickness. Three mechanical stiffness parameters were computed: overall passive stiffness (beta), pressure-dependent modulus changes (E(inc,p)), and smooth muscle cell (SMC) activity-dependent changes (E(inc,a)). The beta-value for ischemic vessels was increased compared with sham vessels (13.9 +/- 1.7 vs. 9.1 +/- 1.4, P < 0.05), indicating possible short-term remodeling due to ischemia. E(inc,p) increased with pressure in the passive vessels (P < 0.05) but remained relatively constant in the active vessels for all vessel types, indicating that pressure-induced SMC contractile activity (i.e., myogenic reactivity) in cerebral arteries leads to the maintenance of a constant elastic modulus within the autoregulatory pressure range. E(inc,a) increased with pressure for all conditions, signifying that changes in stiffness are influenced by SMC activity and vascular tone.

Animals↗