Shinya Matsuoka | PubMed Health

PubMed2006

Supercooled micro flows and application for asymmetric synthesis.

Supercooled micro flow in microchannels was demonstrated. In order to clarify fundamental properties of the supercooling state in microchannels, freezing temperature was measured in the microchannels having widths ranging from 70 microm to 300 microm. The freezing temperature decreased with decreasing width of the microchannel when the microchannel wall was chemically modified with octadecylsilane group. The lowest freezing temperature was observed as -28 degrees C for water in the 70 microm wide microchannel. By contrast, the freezing temperature was -15 degrees C and did not depend on width when a microchannel with a bare glass surface was used. Next, the freezing point was measured with flow rates ranging from 0.1 to 2.0 microl min(-1) and no dependence on flow rate was observed. Then, the supercooled micro flow was applied to an asymmetric reaction in micro two-phase flow of aqueous and CH2Cl2 phases. As expected from thermodynamic prediction, enantiomeric selectivity increased in the supercooled state of water.

Catalysis↗

PubMed2005

Surface modification method of microchannels for gas-liquid two-phase flow in microchips.

A capillarity restricted modification method for microchannel surfaces was developed for gas--liquid microchemical operations in microchips. In this method, a microstructure combining shallow and deep microchannels and the principle of capillarity were utilized for chemical modification of a restricted area of a microchannel. A hydrophobic--hydrophilic patterning in microchannels was prepared as an example for guiding gas and liquid flows along the respective microchannels. Validity of the patterning was confirmed by measuring aqueous flow leak pressure from the hydrophilic microchannel to the hydrophobic one. The leak pressure of 7.7-1.1 kPa agreed well with that predicted theoretically from the Young-Laplace equation for the microchannel depth of 8.6-39 microm. In an experiment to demonstrate usefulness and effectiveness of the method, an air bubble was first introduced into the hydrophilic microchannel and purged from the hydrophobic-hydrophilic patterned microchannels. Next, the patterning structure was applied to remove dissolved oxygen by contacting the aqueous flow with a nitrogen flow. The concentration of dissolved oxygen decreased with contact time, and its time course agreed well with numerical simulation. These demonstrations showed that the proposed patterning method can be used in general microfluidic gas-liquid operations.

Biomechanical Phenomena↗