PubMed Health⌕ Search

Biomedical subjects

V L Barbosa

Publications and source records attributed to V L Barbosa.

3 recordsLinked to original sources

Characterization of Thiobacillus thioparus isolated from an activated sludge bioreactor used for hydrogen sulfide treatment.

AIMS: To compare Thiobacillus thioparus population dynamics in a control and a test activated sludge (AS) bioreactor, used for hydrogen sulfide (H(2)S) degradation. METHODS AND RESULTS: Denaturing gradient gel electrophoresis (DGGE) was used to confirm the presence of T. thioparus, and real-time PCR was used to quantify the level of this bacterium in the AS samples. The DGGE analysis showed a band for T. thioparus in all samples, with the band being more prominent in the test sample with H(2)S diffusion. It also showed that although a change occurred in the diversity of the microbial population in the test sludge after 6 weeks of H(2)S diffusion, the microbial community structure of the test and control was still similar. Thiobacillus thioparus-specific PCR primers confirmed that 50% of the isolates from both the test and control bioreactors were T. thioparus. The thiobacilli population became more efficient at degrading the diffused H(2)S. This increase in efficiency was confirmed by a significant increase in the number of isolates from the test sludge compared with those from the control sludge, when they were grown in a thiosulfate-rich liquid medium. CONCLUSIONS: It was concluded that the use of AS process for H(2)S removal encourages the population of T. thioparus to increase even at times when the total biomass concentration shows a decrease. SIGNIFICANCE AND IMPACT OF THE STUDY: The research results give an insight into the dynamics of the microbial population in an AS pilot plant used in a dual role, to treat the wastewater and H(2)S.

Bioreactors↗

Hydrogen sulphide removal by activated sludge diffusion.

Odours from wastewater treatment plants comprise a mixture of various gases, of which hydrogen sulphide (H2S) is the main constituent. Microorganisms commonly found in wastewater can degrade sulphurous compounds. Therefore, the use of activated sludge (AS) for odour control offers an alternative to traditional waste gas treatment processes, such as biofilters, bioscrubbers and biotrickling filters, both in practical terms (use of existing facilities) and economically (minimal capital cost). The performance of AS diffusion as a bioscrubber for removing H2S at concentrations at 25, 75 and 150 ppmv was evaluated. Pilot-scale trials were undertaken using parallel 60-L aeration tanks and 20-L clarifier reactors at the Bedford Sewage Treatment Works, Carington, UK. Olfactometry measurements were also carried out to determine whether there was any increase in odour concentration owing to H2S diffusion. Hydrogen sulphide removal rates of 100% were obtained, with no noticeable increase in odour concentration throughout the trials as measured by olfactometry. Odour concentration was highest at the beginning of the trials and lowest during the high H2S dosing period, with similar values being obtained for test and control. It was concluded that AS diffusion is an effective bioscrubber for the removal of H2S odour.

Air Pollutants↗

Direct bonding to porcelain.

Orthodontic brackets were bonded to 180 faces of 45 porcelain cubes that were divided into three groups according to their surface preparation. In group I, the glaze had been removed with a sandpaper disk, whereas in group II, it was maintained. A solution of acidulated phosphate fluoride (APF) gel was applied to the samples in groups I and II for 5 minutes after pumicing. In group III, the glaze had been removed with a coarse diamond bur. Each group was further divided into four subgroups, depending on whether a priming agent had been used, and the type of composite used to bond the brackets. Shear force was used to debond the brackets, and the results showed that the APF solution was unable to provide enough retention on porcelain surface to bond brackets. Mechanical retention, obtained with a coarse diamond bur, was necessary to increase bond strength, which can be further improved by chemical bonding, with a silane priming agent. Therefore bonding to porcelain is clinically possible and is an acceptable procedure in orthodontic treatment.

Acidulated Phosphate Fluoride↗