Biomedical subjects

Victor J Morris

Publications and source records attributed to Victor J Morris.

9 recordsLinked to original sources

PubMed2005

AFM studies of water-soluble wheat arabinoxylans--effects of esterase treatment.

The degradation products of water-soluble wheat arabinoxylans treated with Aspergillus niger ferulic acid esterase (FAEA-able to cleave 5,5'- and 8-O-4'-ferulic acid dimers) have been characterised by atomic force microscopy (AFM) and size exclusion chromatography. The AFM images of arabinoxylans confirmed that a small proportion ( approximately 15%) of the population of arabinoxylan molecules contain xylan-based branches attached to the xylan-based backbone. Treatment with FAEA reduced the contour length of the molecules suggesting that certain dimeric ferulic acid linkages may play a previously unconfirmed role in the elongation of arabinoxylans. Overnight treatment with FAEA led to a reduction in the density of branches suggesting that they may also be linked to the backbone through phenolic linkages.

Aspergillus niger↗

PubMed2004

Effect of processing on the displacement of whey proteins: applying the orogenic model to a real system.

Atomic force microscopy (AFM) has been used to investigate the displacement of a commercial whey protein system and the behavior as compared to that of beta-lactoglobulin (Mackie, A. R.; Gunning, A. P.; Wilde, P. J.; Morris, V. J. Orogenic displacement of protein from the air-water interface by competitive adsorption. J. Colloid Interface Sci. 1999, 210, 157-166). The whey protein isolate (WPI) was displaced from an air-water interface by the surfactants Tween 20 and Tween 60. Displacement data obtained were compared with data obtained for pure beta-lactoglobulin and have shown that WPI was more resistant to displacement from the air-water interface than native beta-lactoglobulin. This was related to the greater surface elasticity of WPI at higher surface stresses. In the presence of Tween 20, WPI was observed to remain on the interface at surface pressures up to 8 mN/m greater than the surface pressure at which complete displacement of beta-lactoglobulin was observed. Displacement of WPI and beta-lactoglobulin films by the surfactant Tween 60 showed similar results. However, because of the lower surface activity of Tween 60, it was not possible to reach surface tension values similar to those obtained for Tween 20. Despite the lower surface activity of Tween 60, WPI was still observed to be present at the interface at surface pressure values greater than those by which beta-lactoglobulin had been completely displaced.

Chemical Phenomena↗

PubMed2004

Inactivated enzymes as probes of the structure of arabinoxylans as observed by atomic force microscopy.

The complex structures of water-soluble wheat arabinoxylans have been mapped along individual molecules, and within populations, using the visualisation of the binding of inactivated enzymes by atomic force microscopy (AFM). It was demonstrated that site-directed mutagenesis (SDM) can be used to produce inactive enzymes as structural probes. For the SDM mutants AFM has been used to compare the binding of different xylanases to arabinoxylans. Xylanase mutant E386A, derived from the Xyn11A enzyme (Neocallimastrix patriciarium), was shown to bind randomly along arabinoxylan molecules. The xylanase binding was also monitored following Aspergillus niger arabinofuranosidase pre-treatment of samples. It was demonstrated that removal of arabinose side chains significantly altered the binding pattern of the inactivated enzyme. Xylanase mutant E246A, derived from the Xyn10A enzyme (Cellvibrio japonicus), was found to show deviations from random binding to the arabinoxylan chains. It is believed that this is due to the effect of a small residual catalytic activity of the enzyme that alters the binding pattern of the probe. Control procedures were developed and assessed to establish that the interactions between the modified xylanases and the arabinoxylans were specific interactions. The experimental data demonstrates the potential for using inactivated enzymes and AFM to probe the structural heterogeneity of individual polysaccharide molecules.

Carbohydrate Sequence↗

PubMed2003

Acetan:glucomannan interactions--a molecular modeling study.

X-ray fiber diffraction patterns from deacylated acetan and glucomannan (konjac mannan) blends are diagnostic of good orientation and modest polycrystallinity. The meridional reflection on the sixth layer line suggests that the binary complex is a 6-fold helix of pitch 55.4 A. A molecular modeling study incorporating this information reveals that a double helix in which one strand is acetan and the other glucomannan is stereochemically feasible. While the backbone and side groups are sufficiently flexible to allow the chains to associate with the same or opposite polarity, the parallel model is superior in terms of unit cell packing. The results are compatible with the observed synergy; namely the weak gelation behavior of the complex. The molecular model can be generalized for the binary system when acetan is replaced by xanthan or glucomannan by galactomannan.

Acetylation↗

PubMed2003

Atomic force microscopy of pea starch granules: granule architecture of wild-type parent, r and rb single mutants, and the rrb double mutant.

AFM studies have been made of the internal structure of pea starch granules. The data obtained provides support for the blocklet model of starch granule structure (Carbohydr. Polym. 32 (1997) 177-191). The granules consist of hard blocklets dispersed in a softer matrix material. High-resolution images have yielded new insights into the detailed structure of growth rings within the granules. The blocklet structure is continuous throughout the granule and the growth rings originate from localised defects in blocklet production distributed around the surface of spheroidal shells within the granules. A mutation at the rb locus did not lead to significant changes in granule architecture. However, a mutation at the r locus led to loss of growth rings and changed blocklet structure. For this mutant the blocklets were distributed within a harder matrix material. This novel composite arrangement was used to explain why the granules had internal fissures and also changes in gelatinisation behaviour. It is suggested that the matrix material is the amylose component of the granule and that both amylose and amylopectin are present within the r mutant starch granules in a partially-crystalline form. Intermediate changes in granule architecture have been observed for the double mutant rrb.

Microscopy, Atomic Force↗

PubMed2003

Characterisation of heterogeneous arabinoxylans by direct imaging of individual molecules by atomic force microscopy.

Atomic force microscopy has been used to characterise populations of extracted water-soluble wheat endosperm arabinoxylans. The adsorbed molecules are extended structures with an estimated Kuhn statistical segment length of 128 nm, suggesting that they adopt an ordered helical structure. However, estimates of the molecular weight distribution, coupled with size exclusion data, suggest that, in solution, the polysaccharides behave as semi-flexible coils, with a Kuhn length of 16 nm. These data imply that adsorption of the arabinoxylan structures onto mica promotes formation of the helical structure. Adoption of this ordered structure is fortunate because it has permitted characterisation of branching observed in a small proportion (approximately 15%) of the population of otherwise linear molecules. The degree of branching has been found to increase with the contour length of the molecules. Degradation of the polysaccharides with xylanase has been used to confirm that both the backbone and branches are based on beta-(1-->4) linked D-xylopyranosyl residues.

Adsorption↗

PubMedDate not supplied

Fine-stranded and particulate aggregates of heat-denatured whey proteins visualized by atomic force microscopy.

beta-Lactoglobulin and whey protein isolate (WPI) were heated in aqueous solutions at pH 2 and 7 at 80 degrees C, spread onto freshly cleaved mica surfaces, and visualized under butanol using atomic force microscopy. Fine-stranded aggregates were formed at pH 2, the diameter of strands being ca. 4 nm for beta-lactoglobulin and 10 nm for WPI. At pH 7, aggregates were composed of ellipsoidal particles, regardless of the concentration of added NaCl. This observation supports the previously proposed two-step aggregation model at neutral pH (Aymard, P.; Gimel, J. C.; Nicolai, T.; Durand, D. J. Chim. Phys. 1996, 93, 987-997), consisting of the formation of primary globular particles and the subsequent aggregation of those primary particles. The AFM provides the first direct evidence for the anisotropic shape of these primary particles. The heights of primary particles increased from ca. 11 to 27 nm with increasing concentrations of added NaCl from 0 to 0.3 M in the case of WPI. The rate of aggregation was also accelerated with increasing NaCl concentrations, which appeared to induce transitions in gel networks from fine-stranded toward particulate networks. The present study provides structural information essential for understanding the diverse physical properties of heat-induced whey protein gels.

Hot Temperature↗

PubMedDate not supplied

Effect of surfactant type on surfactant--protein interactions at the air-water interface.

The displacement of the proteins (beta-lactoglobulin and beta-casein) from an air-water interface by the nonionic (Tween 20 and Tween 60) and ionic (sodium dodecyl sulfate, cetyltrimethylammonium bromide, and lyso-phosphatidylcholine-lauroyl) surfactants has been visualized by atomic force microscopy (AFM). The surface structure has been sampled by the use of Langmuir-Blodgett deposition onto mica substrates to allow imaging in the AFM. In all cases, the displacement process was found to occur through the recently proposed orogenic mechanism (Mackie et al. J. Colloid Interface Sci. 1999, 210, 157-166). In the case of the nonionic surfactants, the displacement involved nucleation and growth of surfactant domains leading to failure of the protein network and subsequent loss of protein into the bulk phase. The surface pressure dependence of the growth of surfactant domains and the failure of the network were found to be the same for both Tween 20 and Tween 60, demonstrating that the breakdown of the protein film was dominated by the mechanical properties of the network. The displacement of protein by ionic surfactants was found to be characterized by nucleation of surfactant domains with little domain growth prior to failure of the network. The size of the domains formed by ionic surfactants was found to be limited by the strong intersurfactant repulsive forces between the charged headgroups. Screening of these charges led to an increase in the size of the domains. The surface pressure at which the network continuity was lost was found to be dependent on the type of surfactant and, in all cases, to occur at higher surface pressures than that required for nonionic surfactants. This has been attributed to surfactant-protein binding that initially strengthens the protein network at low surfactant concentrations. Evidence obtained from surface shear rheology supports this assertion.

Caseins↗

PubMedDate not supplied

Atomic force microscopy of pea starch: origins of image contrast.

Atomic force microscopy (AFM) has been used to image the internal structure of pea starch granules. Starch granules were encased in a nonpenetrating matrix of rapid-set Araldite. Images were obtained of the internal structure of starch exposed by cutting the face of the block and of starch in sections collected on water. These images have been obtained without staining, or either chemical or enzymatic treatment of the granule. It has been demonstrated that contrast in the AFM images is due to localized absorption of water within specific regions of the exposed fragments of the starch granules. These regions swell, becoming "softer" and higher than surrounding regions. The images obtained confirm the "blocklet model" of starch granule architecture. By using topographic, error signal and force modulation imaging modes on samples of the wild-type pea starch and the high amylose r near-isogenic mutant, it has been possible to demonstrate differing structures within granules of different origin. These architectural changes provide a basis for explaining the changed appearance and functionality of the r mutant. The growth-ring structure of the granule is suggested to arise from localized "defects" in blocklet distribution within the granule. It is proposed that these defects are partially crystalline regions devoid of amylose.

Microscopy, Atomic Force↗